a = 50mm b = 80mm The rigid bar ABC, which is pin-supported at A, is connected to an aluminum (E = 70 GPa) cable (A = 25 mm2) at B and a shear spring at C. The shear spring is composed of a rubber (G = 0.6 MPa) pad 50x80x70 (mm) that is glued to a Valyrian steel (E = 10 GPa) plate (with dimensions 25x160x70 (mm) What value of the downward force P (in kN) will cause the rigid bar to tilt by 0.1°? Neglect the weight of the bar and horizontal deflections. nabber pad - aluminum cable Valyrian steel plate A 35 X = 3 y = 4m

a = 50mm b = 80mm The rigid bar ABC, which is pin-supported at A, is connected to an aluminum (E = 70 GPa) cable (A = 25 mm2) at B and a shear spring at C. The shear spring is composed of a rubber (G = 0.6 MPa) pad 50x80x70 (mm) that is glued to a Valyrian steel (E = 10 GPa) plate (with dimensions 25x160x70 (mm) What value of the downward force P (in kN) will cause the rigid bar to tilt by 0.1°? Neglect the weight of the bar and horizontal deflections. nabber pad - aluminum cable Valyrian steel plate A 35 X = 3 y = 4m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Explain the uses of kratom
What is the maximum concentrated load that can be applied at the end of an embedded hollow pipe, made of AISI 1020 steel? Take 10.16 cm for the outside diameter, and 6.35 cm for the inside diameter. The length of the pipe is 183 cm. Its maximum deflection must not exceed 5.08 cm. Neglect the weight of the pipe. Answer 22816 N
In steel columns, what are the methods that will increase the strength of the column without increasing the cross-section. Explain with two images. (handwriting is not accepted) Please answer my question format pdf or world
SUBJECT: FUNDAMENTAL OF ENGINEERING MECHANICS Q2 A2 PLEASE ANSWER AS SOON AS POSSIBLE
I NEED IT ASAP PLEASE. I NEED THE FINAL ANSWER PLEASE.
I need the answer as soon as possible
7. For each of the bars shown below, identify the bar size, grade, and ASTM standard the bar was produced to. A B V 8 W 80 H 11 S
b) In engineering practice, it is often required that two sheets or plates are joined together and carry the load in such ways that the joint is loaded. Many times, such joints are required to be leak proof so that gas contained inside is not allowed to escape. A riveted joint is easily conceived between two plates overlapping at edges, making holes through thickness of both, passing the stem of rivet through holes and creating the head at the end of the stem on the other side. Discuss each of the rivet joints listed below: i) Tearing failure of plates ii) Bearing failure of rivets 2 iii) Shear failure of rivets iv) Splitting/cracking failure of plates at the edges
I need an answer quickly please
Please, professor, I know. My request is strange, but my line is bad. I want the same solution in a beautiful and tidy line. Don't forget that my name is on paper. A beautiful and tidy line, thank you, professor.
Please show complete solution and explanation thank you