Material: Carbon Steel Heat Treatment 1 ReadingReadingAverage 2 Hardness(kg/mm2) XD1 YD2 22.71 Quenching 20.13 Tempering 40.01 Normalizing27.95 Annealing 24.34 Explain the Microstructural differences of each treatment process that account for the difference in hardness. 808.1 226.3 482.9 556.5 40.96 27.48 27.30

Q: What about Mohr's circle?

A: In the previous question, Given: The diameter of shaft, d = 20 mm = 0.02 m The maximum bending…

Q: Determine Iy. 50 mm 50 mm 300 mm 50 mm y -200 mm an -X We Problem 4

A:

Q: %o change in diamefesx-?

A: Given; Solid cylinder of; diameter,d1=120 mmheight,h1=50 mmTwo frictionless flat dies to a…

Q: State the difference between the eutectic and eutectoid points.

A: Eutectic point: In the iron carbon phase diagram at 2 percentage of carbon is called eutectic point.…

Q: Each cylinder in a four-cylinder car engine has a bore diameter of 63.53 mm and the stroke for each…

A: Consider a vehicle engine where number of cylinder are situated whose bore diameter is D and stroke…

Q: Identify the following sectioning views (a, b, and c). a O Removed, Revolved and Removed O All…

A:

Q: Wind flows over a flat plate of length L = 25 mm and width W = 8 mm. The plate is maintained at a…

A:

Q: What is the moment-area method?

A: The moment-area method is one of the methods for determining the slope and deflection generated in a…

Q: Solidworks MMGS units

A: Find Draw the given object in Solidworks. Unit: MMGS

Q: 2 Brass expands more than iron when heated. How would the strip look after prolonged exposure to…

A:

Q: If the allowable tensile stress of the wires AB and AC is oallow = 250 Mpa, determine the largest…

A: