Match the following to True/False. A. GPS devices are an example of mobile traffic sensors For the time-space diagram of a single-lane one-way road, the vehicle trajectories do not intersect with each other unless there is a crash. Pneumatic tubes detect vehicle presence by sending an electric signal to a roadside device. B. + Space mean speed may be greater than time mean speed in certain situations. A. True B. False

Match the following to True/False. A. GPS devices are an example of mobile traffic sensors For the time-space diagram of a single-lane one-way road, the vehicle trajectories do not intersect with each other unless there is a crash. Pneumatic tubes detect vehicle presence by sending an electric signal to a roadside device. B. + Space mean speed may be greater than time mean speed in certain situations. A. True B. False

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: If all trucks travel at speed v', cars at speed v, and the fraction of vehicles passing a stationary…

Q: 3. A driver takes 2.5 seconds to react to a complex situation while traveling at a speed of 40…

Q: A researcher was observing traffic along one lane of a rural highway. During a 1 minute time…

Q: A model known as stopping sight distance is used by civil engineers to design roadways. This simple…

Q: 5. Consider the time-space diagram below. a. If you are observing from a point at distance-1000 ft,…

A: Solution: a. From the Time-space diagram: For 1000ft, the time taken for each vehicle is given…

Q: Q2. Solve and choose the correct answer: 1. A driver takes 1.5 seconds to react to a complex…

Q: Results of traffic flow studies on a highway indicate that the flow-density relationship can be…

A: Answer We are given a speed-density model Speed (mi/hr) Density(veh/mi) 56 19 54 24 45 44…

Q: B During a traffic speed survey, the following observations were recorded when a vehicle passes a 50…

Q: compute the total distance covered in coming to a stop after a signal is observed from an initial…

A: This question has been taken from transportation engineering

Q: (b) An engineer wishing to determine whether there is a statistically significant difference between…

Q: Given: Radar indicates vehicle speed = 100 MPH…

A: We will use the given equation to solve this question. The first part of the equation will be…

Q: 4. The figure below shows the velocity curves for two cars, A and B, that start side by side and…

A: Given Data: The value of interval is n=4 The total time intervals to be considered is t=0 and t=16.…

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A: Solution:Given:The speed of automobile A is vA=95mi/h=95∗(1.46667)=139.33ft/sThe speed of automobile…

Q: The grade, g, of a road is defined as the distance it rises (or falls) to the distance it runs…

A: As per given in the question, The grade, g, of a road is defined as the distance it rises (or…

Concept explainers

Highway Safety

Proper highway safety refers to the methods or rules that prevent highway travelers from being killed or severely injured. Proper highway safety measures help to protect motorists, cyclists, pedestrians, passengers on public transport, and so on.

Question

Match the following to True/False.
A.
GPS devices are an example of mobile traffic sensors
For the time-space diagram of a single-lane one-way road, the vehicle
trajectories do not intersect with each other unless there is a crash.
Pneumatic tubes detect vehicle presence by sending an electric signal to a
roadside device.
B. Space mean speed may be greater than time mean speed in certain
situations.
A. True
B. False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction

Step 2: Part-1

Step 3: Part-2

Step 4: Part-3

Step 5: Part-4

Solution

Trending now

This is a popular solution!

Step by step

Solved in 6 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Time mean speed averages the speed of vehicles observed at a single point in time. O True O False
1. Assume you are observing traffic in a single lane of a highway at a specific location. You measure the average headway and average spacing of passing vehicles as 3 seconds and 150ft, respectively. What is the average speed of the traffic stream? Note: you can use two methods to conduct the calculation. 2. Assume the speed and density at a freeway location follows a linear relationship. You observe traffic flow rate of 2250 vehicles/hour at 45 mph and 3000 vehicles/hour at 30 mph. What are the jam density, free flow speed (max speed), and capacity of this freeway location? How about the density and speed (i.e., the critical density and the critical speed) at the capacity?
NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Three seconds after automobile B passes through the intersection shown, automobile A passes through the same intersection. Given, the speed of automobile A is VA = 55.00 mi/h and automobile B is vg= 34.00 mi/h, respectively. Also, know that the speeds are constant for the automobiles during the encounter. N 70° S + VA vB Determine the distance between the two automobiles 2 s after A has passed through the intersection. The distance between the two automobiles 2 s after A has passed through the intersection is
A 12 ft long loop detector has observed six vehicles that have crossed the device in a 148 second period, for the following durations: 0.44; 0.48; 0.5; 0.41; 0.49; and 0.55. The six vehicles are 18, 21, 20, 23, 17 and 19 ft respectively. Calculate: d. How many miles per hour is the rated speed, v?
Question 1 1.1 The sketch below shows the time-space diagram for a section of an urban road. Estimate the average spacing, headway and the speed. Distance (m) 160 140 120 100 80 60 40 20 0 0 5 10 15 20 25 Time (sec) 30 35 40
A 12 ft long loop detector has observed six vehicles that have crossed the device in a 148 second period, for the following durations: 0.44; 0.48; 0.5; 0.41; 0.49; and 0.55. The six vehicles are 18, 21, 20, 23, 17 and 19 ft respectively. Calculate: c. How many vehicles per mile is the density, k?
Consider the following spot speed data, which were collected from the location of expressways operating under free flow conditions: a. Draw the frequency curve and cumulative frequency for this data. b. Find and identify on the curve: average speed, modud speed, pace, percent of vehicles in pace. c. Calculate the mean and standard deviation of the velocity distribution. d. What are the confidence bounds in the true mean velocity estimate of the underlying distribution with a 95% confidence level? With a 99.7% confidence level? e. Based on the results of this study, a second study should be conducted to achieve a tolerance of ±1.5 mi/hour with a 95% confidence level. What is the required sample size? f. Can this data deserve to be declared as normal?
QUESTION 1 A researcher was observing traffic along one lane of a rural highway. During a 1 minute time interval, ten vehicles were observed travelling 65, 64, 71, 66, 58, 72, 69, 66, 55 and 62 mph. Using these spot speeds, calculate the space mean speed (mph). Provide your answer to the nearest tenth of a mph.
4-5 An engineer wishing to determine whether there is a statistically significant difference between the average speed of passenger cars and that of large trucks on a section of highway, collected the data shown below. Determine whether the engineer can con- clude that the average speed of large trucks is the same as that for passenger cars. Average Speed (mi/h) Standard deviation of speed ± mi/h Sample size Trucks 62 5.5 275 Passenger Cars 59 6.3 175
A researcher was observing traffic along one lane of a rural highway. During a 1 minute time interval, ten vehicles were observed travelling 65, 64, 71, 66, 58, 72, 69, 66, 55 and 62 mph. Using these spot speeds, calculate the time mean speed (mph). Provide your answer to the nearest tenth of a mph.
Problem 2 A project by some to monitor the traffc safety at a busy intersection. They measwre (with a precision stopwatch) that exactly three seconds after car B passes through the intersection traveling south at vg = 55 mph, minivan A passes through at va = 70 mph on the road that runs at an angle 0 = 60° east of north. The speed of each automobile is Civil Engineering students requires them constant. Determine (a) the relative velocity (in mph) of B with respect to A, draw the vector triangles as part of your answer (b) the change in position (in fi) of B with respect to A during a 10-s interval, (c) the distance (in ft) between the two automobiles 3 s after A has passed through the intersection.
Express the following equation, the traffic density in veh/km when d is in m, in terms of number of vehicles per mile when d is in mi, ft, and yd. (Use the following as necessary: n, d.) 1,000n d k = when d is in mi when d is in ft when d is in yd k = k = k = nd 5280nd 1760nd X X X