Match the following statements Thevenin's theorem states that Norton's theorem states that [Choose ] ✓ a linear two terminal circuit may be replaced with a voltage source and resistor a linear two terminal circuit may be replaced with an equivalent circuit containing a resistor and a current source neither statement matches the theorem a linear two terminal circuit m

Q: Following Design an Electronic cct to convert the digital no. (1111 001ooollolol) an analoque…

A: Given:A binary number "1 1 1 1 0 0 1 0 0 0 1 1 0 1 0 1"we are required:to design an electronic…

Q: NOT AB AND E NOT OR Y

A: Given: A logic circuit diagram as shown in figure,  To find: Truth table for the above circuit.

Q: Design the following function F using: AB CD 00 01 11 10 00 1 01 1 11 1 10 1 1 1.4:16 decoder block…

A:

Q: 74 ELECTRONICS FOR TELECOMMUNICATIONS Calculate the BER if there were six bad bits in a total…

A: Bit Error Rate :  is known as the ratio of the number of bit error to the total number of…

Q: Complete The timing diagram and the AND gate by drawing the input (A, B, C) and the output (F)…

A: given that Function F as F = A'B'C' + A'BC' + ABC'with three inputs and one output

Q: last question what is k??

A: The k is the gain in the transfer function. The value of the gain can be calculated based on the…

Q: - State inputs (a,y), impure to Next State e6 Hipfiops (4 ) and oulpueg (Z) frecent State Seputs…

A: Given :   Here in the  image student had already posted the answer they just want the explanation…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.