Q1. (a) Considering pure inductance in an ac circuit element, show that the alternating current lags the voltage by 0.5.b)j42j8Nj42a100 L0° (V)N 100 L 60° (V)In the network, determine the steady current in the 82 inductor using Thevenin's theorem.

Answered: Image /qna-images/answer/23a125a9-957d-4166-bca2-922684787e07.jpg

Answered: mat tiiC b) j42 j40 a 100 L0° (V)( W.09…

mat tiiC b) j42 j40 a 100 L0° (V)( W.09 7 001( In the network determine the steady current in the 80 inductor using Thevenin's theorem

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Find the sinusoids represented by the following phasors 11. V-12 + j8 mV

Q: resistor has a 1000 ohms and a capacitor has a value of

Q: 1. A single phase transmission line has two parallel conductors 3 m apart, the radius of each…

Q: R 200 Vs -100V C. - j10 Calculate the magnitude of the voltage drop across the capacitance.

A: In this question, What is magnitude of the voltage drop across the capacitance? We are solving…

Q: Time taken for an alternating quantity to complete one cycle of the waveform is called time period.…

A: We need to tell whether the given statement is true or false.

Q: Problem 10 the j4 2 inductor. You only need to write the equations. You do not need to simplify the…

A: In this question, we need to determine the equations to get voltage across the j4 ohm inductor.

Q: 5. What is the total capacitance of a circuit with three capacitors connected in series with the…

A: Given data, Capacitance is given C1=0.015 F, C2=0.015 F, C3=0.015 F

Q: response is the response of a system from the rest to steady state.

A: responses are of two type steady state and transient state

Q: 0.114 U1 114.387 AC 10MOhm R1 M 1kQ U4 AC 1e-090hm V1 120Vrms ~ 50Hz 0° U2 0.036 AC 10MOhm L1 1mH U3…

Q: In the circuit shown, determine the following: The equivalent reactance and its nature (inductive or…

A: The solution is given

Q: Reactive power is zero for a purely:.. Select one: O a. Inductive Load O b. Capacitive Load Oc.…

A: Reactive power is zero,

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: In the circuit given below, what should be the minimum value of C1 capacitor so that this capacitor…

Q: Problem E Provide steady-state waveforms for the cap voltage and output voltage on the same…

A: Need to obtain the output waveform and the waveform across the capacitor in the given astable…

Q: The figure shows v(t) and i(t) across a load. Then, the impedance of the load in kQ is: v(t) Volt,…

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Q: 5cos4t+7sin4t

A: Given : 5cos4t+7sin4t

Q: ,In an L-R-C series circuit, the rms voltage across the resistor is 30.0 V, across he capacitor it…

A: In the circuit If rms voltage across the resistance = 30V rms voltage across the capacitor = 90V rms…

Q: 147. For the circuit shown in figure, the voltage across the capacitor during steady state condition…

A: In this question , we will find voltage across capacitor in steady state...

Q: Given V 20 sin(@t + 60°) and V2 %3D = 60 cos(@t-10°) What is the phase angle between the waveforms?…

Q: Two impedances of Z1 = 100 +j50 Q and Z2 = 20 -j20 Q are connected in series what is the magnitude…

A: Given: The two impedance connected in series are Z1=100+j50 ΩZ2=20-j20 Ω

Q: (3) Find the phasors V₁ and V₂ for the waveforms below. You can use polar or cartesian notation. 9 s…

A: In this question We need to determine the polar and Cartesian form of the given waveforms. We know…

Q: Find the sinusoids

Q: The circuit is in sinusoidal state. Is this the right answer?

A: No, it is not the right answer. Step 3 is incorrect.

Q: The circuit below is operating under sinusoidal steady-state conditions. Find the phasor voltages…

Q: How can you tell which phasor is lagging when the two phasors don’t start in the same location such…

A: It is given that:

Q: The r.m.s. value of a sinusoidal current of maximum value 95 A is,

A: Given Maximum value of Sinusoidal current, Imax =…

Q: V = 20Vpp 1kHz's sinusoidal wave) In this Circuit, change the inductor to 2.2mH, 4mH, 10mH,…

A: Given Data:An RL series circuit with,AC voltage Frequency Inductors,To Find:The plot of the voltage…

Q: ) Cenvert the following phasors to the time domain if the frequency is I KH. b) h-12 / A

A: Phasors are the simple and easily understandable representation of the time-domain signals. suppose…

Q: The frequency of an alternating current which completes 15 cycles in 8ms is

A: The solution can be achieved as follows.

Q: 6) Transform from sinusoid to phasor 5cos4t + 7sin4t

A: In this question we need to convert the given time domain signal into phasor domain. While…

Q: Find the amplitude (Vpp) and find the frequency and most importantly find the Vdc offset and please…

Q: b) A 20-kVA, 440/220-V, single phase, 50-Hz transformer has an iron loss of 324 W. The Cu loss is…

Q: A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power…

A: The power factor for series RL circuit can be written as, p.f=cosθwhere…

Q: For the resistor shown above what best describes its behavior at 1 MHz? O It responds primarily as a…

A: For normal frequencies the components such as resistors,capacitor and inductor work normally but at…

Q: Find the Thevenin equivalent impedence across terminals A and B

Q: Find the impedance of a series connection resistor and an inductor.the inductance is L=1mH.the…

A: The impedance of the given circuit is given as Z=R+jXL also can be written as

Q: iT 42 4Ω iL ет icy -J92 J4Q

Q: 10245°= A 7.07+7.07j 10+10j C 10+14.14j 10+45j

Q: A resistor and a capacitor are connected in series across a supply of 250V. When the supply…

Q: 6. What is the total capacitance of a circuit containing a .01 farad, a .015 farad, and a .001 farad…

Q: Transform from sinusoid to phasor 5cos4t+ 7sin4t

A: Given 5cos(4t)+7sin(4t) Transform sinusoid to Phasor

Question

100%

Q1. (a) Considering pure inductance in an ac circuit element, show that the alternating current lags the voltage by 0.5.
b)
j42
j8N
j42
a
100 L0° (V)
N 100 L 60° (V)
In the network, determine the steady current in the 82 inductor using Thevenin's theorem.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Qu / MA 20 Using the afind the Ruh Sind the veAih's Voltage Vthi Bfind the value df load resislance? Gfind The max imu m Power at the Condidlon delivered to lead2
Q4
An electrical engineer is working with a parallel AC circuit. The circuit draws 8 ohms on a resistive branch, and the angle of the total impedance is 35°. What is the approximate number of ohms on the inductive branch? O 0.7 O 4.59 O 5.6 O 6.55
See images attached. Help with finding sinusoid equations for graph
show soln
4) Find current phasor I for the following AC steady state circuit. j35 O -j14 2 12/0° V 103 n3 j25 Q
The type of the load whose current and voltage phasors are as shown in the phaser diagram is Im 90° - Re Pure capacitive load non-pure Inductive load Purse resistive load O Pure inductive load non-pure capacitive load
Consider a drcuk where an ideal inductor L=D.144H is connected in parallel to a resistor R=1.00k. This combination is connected in series with a capacitor C=3.67e-07. This combination in connected to a power supply source of frequency f-3.4kHz. To study this circuit you need to drawa phasor diagram. Note the sum cf the current phasors through the resistor and the inductor must be equal to the phasor representing the current through the capacitor fie. the total current). You should draw the phasor for the current through the capadtor on the horizontal axis, since this is also the total ourrent delivered by the supply. The angie between this phasor and that of the power supply represents the phase angle o. Note that the voltage across the inductor equals the voltage aoross the resistor since they conmected parallel to esch other. Furthermore the sum of the phasors representing the currents through the inductor and the resistor equals the phasor representing the current through the…
For the circuit shown in the following do the following. Find the impedance of the circuit. 150 W C- 60 p 0 115cos(378t 10") 15+j 82.17 ohm O 150+j 182.71 ohm O 12+j 12.7 ohm O 215+j 12.71 ohm 0000 LM 0.6H
9. The matiueonk shawn is aparastineg the steady state with simusaielal un ualtage saunces. i v= 2cos 2t amd N2 = 2 sim 2+ , diturmine the valtage VaCt). 3173 F 2173 F Ja 2173F 31H all
The phasor of the impedance of an AC circuit has no vertical component. What does this mean? there are no reactive components in the AC circuit the resistance of the circuit is equal to the reactance of the reactive components the inductive reactance and capacitive reactance are equal in magnitude there are no inductors in the circuit
this is electric circuit questin ...plz solve it early .plz solve early