Mass m = 1.30 kg is suspended vertically at rest by an insulating string connected to a circuit partially immersed in a magnetic field as in the figure below. The magnetic field has magnitude B = 2.40 T and the length { = 0.550 m. x x x x x x х| х х х х x x x x xx x R HINT (a) Find the current I (in A). (b) If Ɛ = 115 V, find the required resistance R (in N).

Mass m = 1.30 kg is suspended vertically at rest by an insulating string connected to a circuit partially immersed in a magnetic field as in the figure below. The magnetic field has magnitude B = 2.40 T and the length { = 0.550 m. x x x x x x х| х х х х x x x x xx x R HINT (a) Find the current I (in A). (b) If Ɛ = 115 V, find the required resistance R (in N).

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A square coil of wire of side 2.35 cm is placed in a uniform magnetic field of magnitude 2.50 T directed into the page as in the figure shown below. The coil has 25.0 turns and a resistance of 0.780 . If the coil is rotated through an angle of 90.0° about the horizontal axis shown in 0.335 s, find the following. x xx x X X X xxx x xx x X Rotation axis (a) the magnitude of the average emf induced in the coil during this rotation mV (b) the average current induced in the coil during this rotation MA
The loop in the figure has a resistance of 2.5 2 and is being pulled to the right at 1.0 m/s. X X X||X × X 2.0 T X||X 1.0 T 2.0 m X X X ||× × X X X X X • 2.0 m 2.0 m (a) Find the total magnetic flux through the loop, directed into the page, at the time instant shown. b)In the above problem, find the total magnetic flux through the loop, directed into the page, 2.0 s later. (c) In the above problem, find the magnitude of the induced current in the loop during this 2.0 s interval.
Two long parallel wires are at a distance of 1m. If both of them carry two ampere of current in same direction, then the force of attraction on unit length of the wires will be ______ N/m.
L R = 5.00 Q X Xix x 1 |X X X X R P = FexV =8.50 J/s Fext W X xx x X X X X X X X X A rectangular wire loop of length L, width w, is pulled out of a constant, uniform magnetic field with constant velocity v. The loop has a resistance R. The magnetic field of magnitude B, points into the plane of the paper, and is confined to the rectangular region shown above. Work must be done on the loop at the rate of P, to move it through the magnetic field at constant velocity. Find the magnitude of the emf, & and the current I for the loop.
It is desired to construct a solenoid that will have a resistance of 5.30 Ω (at 20°C) and produce a magnetic field of 4.00 ✕ 10−2 T at its center when it carries a current of 3.40 A. The solenoid is to be constructed from copper wire having a diameter of 0.500 mm. If the radius of the solenoid is to be 1.00 cm, determine the following. (The resistivity of copper at 20°C is 1.7 ✕ 10−8 Ω · m.) (a) the number of turns of wire needed to build the solenoid (b) the length the solenoid should have, in cm.
The figure represents a moving rod of length 3 cm in a magnetic field B= 4T What is the current in the circuit represented in the figure, if the speed of the rod is 12 m/s and the resistance of the wire is 9 ohms? X X x x x R X X X X x X X X X X X X O I =122.45 mA O I =160.00 mA O I = 11.00 mA O I = 44.90 mA O I = 81.34 mA
The force per meter between the two wires of a jumper cable being used to start a stalled car is 0.286 N/m. (a) What is the current (in A) in the wires, given they are separated by 2.10 cm?
A solenoid in your car is 36 cm long and has a diameter of 7.9 cm. It is made of copper wire with a radius of 0.50 mm. The turns are closely packed and form a single layer. Assume the resistivity of copper is 1.68 ✕ 10−8 Ω · m. (a) When the solenoid is connected to your battery with E = 11.6 V, what is the magnetic field inside the solenoid? (Enter the magnitude.) T
QUESTION 1 https://per.physics.illinois.edu/per/IE/ie.pl?phys112/ie/08/IE_movingcoil X X X X XX X W X X X X XX X X X X X X X X X X X X X X X Lg At t=0, a rectangular coil of resistance R = 2 ohms and dimensions w = 3 cm and L = 8 cm enters a region of constant magnetic field B = 1.6 T directed into the screen as shown. The length of the region containing the magnetic field is LB = 15 cm. The coil is observed to move at constant vėlocity v = 5 cm/s. What is the force required at time t = 0.8 sec to maintain this velocity? Answer in uN (u = micro = EE-06)
For the rod shown above, the magnitude of the magnetic field is 1.23 T. If the total resistance of the circuit is formed 3.5 ohms, find the Force in N required to keep the rod moving to the right with a velocity of 3.45 m/s?
Two 15.9-m long straight wires carry current in the same direction. One has a current of 15.8 A and the other has a current of 18.2 A. How far apart must they be so that the force between them does not exceed 0.050 N? Please give your answer in Newtons.
Two long, parallel conductors, separated by 14.0 cm, carry currents in the same direction. The first wire carries a current I1 = 3.00 A, and the second carries I2 = 8.00 A. (See figure below. Assume the conductors lie in the plane of the page.) (d) What is the force per length exerted by I2 on I1?