Make steps on how to input this in LTSpice

Q: II. COMPUTER NO. COVERSION. CONVERT THE FF. NO. BELOW. SHOW YOUR SOLUTIONS. 1. Convert EF216 TO BASE…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 2. Draw the output waveform for the J-K ff using Positive edge transition assuming Q = 1 b. Positive…

A:

Q: Schneider LON I 0.OFF MCCB MCB RCD Isolator

A:

Q: Consider a 9.4-bit ADC and full scale voltage measurement range of (-41V to 41V).The Resolution will…

A: Resolution is given by  R = Dynamic Range / total number of steps  Resolution = Dynamic Range /…

Q: a) Fill in the table below for 4-bit A/D converter if Va = 13V with a reference voltage of 15V. Show…

A: According to the question, for a 4-bit SAR ADC the reference voltage is 15 V and the input voltage…

Q: Determine the required resolution for analog to digital converter with 24 bits of word length if t…

A:

Q: Design a 3bit flash A/D converter

A:

Q: Analyze this circuit -Y K B D Q B Clock 20

A:

Q: For a 5 bits successive approximation ADC, find the digital values of Vin if it=0.625 V .and Vr= 1V

A:

Q: التاريخ A prove that the output of discrete LTI System for a sinusoidel imput is sinusoidal/.

A: We need to prove that for a sinusoidal input we will get w sinusoidal output for a LTI system.

Q: The devices that convert serial to parallel and parallel to serial are called? a)…

A: As per the guidelines of bartleyby I need to answer first three questions only so kindly repost…

Q: Course: Data Networks - ECTE201 Write three types of analog-to-analog modulation and illustrate one…

A:

Q: A discrete-time causal signal x[n] has a z-transform as X(z) = (1+3z-2+ 2z-)sin-1(2). Find x[11]. 巴…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: For 4-bit DAC Binary Weighted Resistor Method, if the Vref = 20V, and R = 5 Kohm, what is the output…

A: In this question we need to find a output current for the sequence 1001

Q: For an 8-bit SAR ADC, find the output code if Vref = 10 V and Vin = 4.95 V 00110001 01111111…

A:

Q: Determine all the output waveforms for the 74HC195 when its input signals are shown below CLK K…

A:

Q: An 8-bit digital ramp ADC has a FSR of 8V and an input clock running at 10kHz. What is the…

A: Given, An 8-bit (n=8) digital ramp ADC has FSR= 8V Input clock frequency= 10 kHz Analog input, VA=…

Q: 30°, the average value of output current ir A single-phase full-wave transistor rectifien feeds…

A: In this question we will find single phase full wave rectifier average value of output current for…

Q: What are the advantages for each of the capacitors; CI, C2, CE? Which is better large B.W or small…

A: Given: Common emitter amplifier

Q: In moving coil instruments, is proportional to the coil current. Consider a 9.4-bit ADC and full…

A:

Q: 6. Find the range of R, to meet proper UJT turn-on and turn-off, given the follo characteristic…

A:

Q: For an N-channel JFET Idss = 8mA and Vp = -6V, if Vgs = -2V then what is the value of the Drain…

A:

Q: Which of the following standard is used to compare the limits of harmonic indices? ΙEEE 18 IEEE 519…

A: Given :    In the above question they have mentioned the different type of IEEE standards.   From…

Q: The ----- terminal of the JFET is the equivalent of the Collector terminal of a BJT. a. Drain O b.…

A: In this question,  Choose the correct option What is terminal of the JFET is the equivalent of the…

Q: analogue to digital converter

A: ADC-Full form of ADC is analog to digital conversions. And the electronics device used for…

Q: What are the size for the following 8085 instructions:

A: In this question we will write size of given instructions....

Q: Explain how the built-in potential is formed in the PN junction UTM

A: Consider a P type and N type material joined together as shown below, N-type material have excess…

Q: Will the envelope detector work just fine with its current specifications? Choose the best action/s…

A: Given:  Required: Envelope detector specifications.

Q: Which of the following is true about JFET? The gate is grounded B The gate to source PN junction is…

A: 1. Which of the following is true about JFET ? A. Gate is grounded  B. The gate to source PN…

Q: In order to design an square wave oscillator with 50% duty cycle of the period of 1 second. Specify…

A: In order to design an square wave oscillator with 50% duty cycle of the period of 1 second. to…

Q: 9.6 V VDc 9.2 V T= 8.3333 ms Ripple Factor = 8.6957% The Full Wave (Bridge) Rectifier Si Diodes vi…

A: Frequency is the reciprocal of time period (T)

Q: Fin! the saturation current Icnt fur fixel-bias configumtion for the figwre shown bellow 16V 47ok…

A:

Q: The smallest input voltage recognized by the ADC converter is the Select one: O superior O…

A:

Q: Question 3. Draw and design a Buck-Boost Converter circuit according to the Values given below.…

A:

Q: Choose the 8088 signals that are used to generate ROMRD. IO/M ALE RD WR IORD

A: IO/M

Q: A unijunction transistor (UJT) circuit is attached. The parameters of the UJT are η = 0.75 and RBB =…

A: In this question we need to find RB1 & RB2 2) VB1 B2 AND VP

Q: 2. An ECG oscilloscope is calibrated so that the vertical deflection factor is 1 V/cm, and an…

A: Given data, Vertical deflection factor = 1 V/cm an external preamplifier gain = X1000 If a 1 to 4 mV…