List which piece of lab equipment would be most useful for each of the following tasks. 1. Hold 50 mL of boiling water. 2. Crush a chunk of chemical into a powder. 3. Heat a beaker of water when a gas line is not available to power any equipment. 4. Measure exactly 42.5 mL of water. 5. Scoop ammonium nitrate out of its container and onto weigh paper to be measured.

List which piece of lab equipment would be most useful for each of the following tasks. 1. Hold 50 mL of boiling water. 2. Crush a chunk of chemical into a powder. 3. Heat a beaker of water when a gas line is not available to power any equipment. 4. Measure exactly 42.5 mL of water. 5. Scoop ammonium nitrate out of its container and onto weigh paper to be measured.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

a. Convert 52.6 mM (millimolar) to μM (micromolar) and to M (molar). b. Convert 200.0 μM to mM (millimolar) and to M (molar). c. The new U.S. Public Health Service optimal fluoride concentration in water is 0.700 mg/L. Convert this value to M (molar) and to ppm. Upload your responses here.
2.93 g Measured Volume of Water: 100.0 mL each question with correct significant figures and units. You must show calculations for determining each quantity. If necessary, use the molar mass of NaCI = 58.44 g/mol. You will be asked to show your work for each question. A.Determine the number of moles of NaCI in the solution B.Determine the number of moles of all solutes (both cations and anions) from the number of moles of NaCI that you determined above. C. Determine the mass (in kg) of solvent (assume that the density of water is 1.000 g/mL). D. the molality of all solutes.
A chemist has a 60 mL beaker of a 40% solution. a. Write an equation for the concentration of the solution after adding x mL of pure water. Concentration = b. Use that equation to determine how many mL of water should be added to obtain a 12% solution. Round your answer to 1 decimal place. mL
Explain the results obtained in this experiment
What is the volume of 1.80 M NaCl solution that can be prepared by the dilution of a 50.0 mL of brine solution containing 32.0 wt% NaCl? (Assume the density of a brine solution is 1.10 g/mL and formula mass of NaCl=58.4 g/mol) a. 6.03 mL b. 167 mL C. 301 mL d. 438 mL
You are given a dye stock solution which contains 0.200 g/L dye. If you place 20.0 mL of stock in a 50.0 mL volumetric flask and add distilled water to the line, what is the concnetration of the new solution in the flask? a. 0.080 g/L b. 0.800 g/L c. 0.500 g/L d. 0.00020 g/L
Can you do number 3 and 4 please