Liquid propane (C3H8) enters a combustion chamber at 25°C at a rate of 0.07 kg/min where it is mixed and burned with 40 percent excess air that enters the combustion chamber at 7°C. An analysis of the combustion gases reveals that all the hydrogen in the fuel burns to H,0 but only 75 percent of the carbon burns to CO,, with the remaining 25 percent forming CO. determine (a) the balanced equation for actual combustion process and (b) the mass flow rate of air.

Liquid propane (C3H8) enters a combustion chamber at 25°C at a rate of 0.07 kg/min where it is mixed and burned with 40 percent excess air that enters the combustion chamber at 7°C. An analysis of the combustion gases reveals that all the hydrogen in the fuel burns to H,0 but only 75 percent of the carbon burns to CO,, with the remaining 25 percent forming CO. determine (a) the balanced equation for actual combustion process and (b) the mass flow rate of air.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Using the enthalpy of reaction he data at 3000K and the Kp value at 2800 K of the combustion process A2 + B2 = 2AB (Kp = 0.385 @2800 K) 1. a) Estimate the Kp value at 3200 K b) Determine the equilibrium mole fraction of AB when the pressure is 101 kPa and the temperature is 3200 K ħ298K ħ3000K kJ/kmol kJ/kmol kJ/kmol A2 8,682 106,780 B2 8,669 105,115 АВ 91,290 94,970
Q1. Propane (C3H8) gas enters a steady-flow adiabatic combustion chamber at 25°℃ and 1 atm. It is burned with 300 percent excess air that also enters at 25°C and 1 atm. Assuming complete combustion, determine (a) the temperature of the products, (b) the entropy generation, and (c) the reversible work and exergy destruction. Assume that To = 298 K and the products leave the combustion chamber at 1 atm pressure.
4.10- Methanol is burned in an engine with air at an equivalence ratio of $=0.75. Write the balanced chemical equation. Calculate air-fuel ratio сни тог
Do not give answer in image formet and hand writing
Complete the balanced chemical equation for the combustion of ethane, C2H6. C2H6 + O2 + N2 CO2 + H20 + N2
A thermal power plant of 800 MW capacity burns 50 T of coal/MW/day. Assume complete combustion of carbon compounds. During the burning process, the power plant has the following information: C content in coal = 40% (wt/wt); Temperature on stack = 2000C; Pressure in stack = 1.2 atm; Stack exit velocity = 30 m/sec; Diameter of the stack = 20 m. Estimate CO2 emission in Kg/d, mg/Am3, mg/Nm3 and ppm based on NTP? %3D Need Asap
!
Complete the balanced chemical equation for the combustion of methane, CH4. CH4 + O, + N2 → CO2 + H20 + N2
In a furnace the fuel and air are burnt at atmospheric pressure of 1 bar temperature and of 17°C. The temperature attained by the hot products is 1817°C. Find the availability of products of combustion. Assume, Cp = 1.0 kJ/kg K. %3D
9. Adiabatic Flame Temperature is achieved when (a) the combustion heat is the maximum (c) the combustion heat is the minimum (b) there is no loss in the heat to the surroundings (d) all products are at the same temperature has the most affinity to water to form sulfuric acid. (b) SO₂ (d) SO 10. Among all sulfur compounds, (a) SO3 (c) SO4² 11. When comparing the performance of SI engines, the (a) Indicated -efficiency is used as the measure. (b) Thermal (d) volumetric (c) mechanical 12. For a complete combustion, the reaction time should be longer than the physical time. (a) True (b) False
Ethane, C2H6, burns to completion with 21% excess air. Determine (a) the chemical reaction describing the process, (b) the mass based air-fuel ratio, (c) the molar air- fuel ratio, and (d) equivalence ratio of the process.