Light of wavelength 587.5 nm illuminates a slit of width 0.75mm. At what distance from the slit should a screen be placed if the first minimum in the diffraction pattern is to be 0.85mm from the central maximum?

Light of wavelength 587.5 nm illuminates a slit of width 0.75mm. At what distance from the slit should a screen be placed if the first minimum in the diffraction pattern is to be 0.85mm from the central maximum?

Related questions

Q: If the turbine of the engine spins at an angular velocity of 270.748 radians per sec, what is the…

A: Given : Angular velocity (ω) = 270.748 radians per sec

Q: A wheel 32 cmcm in diameter accelerates uniformly from 250 rpmrpm to 370 rpmrpm in 7.0 ss . 1. How…

Q: A single clothesline is attached to two poles 10.0 m apart. A pulley holding a mass (11 = 294 N…

A: The scenario can be sketched as follows (figure 1) Given, Weight mg = 294 N. Distance between…

Q: 2. For each case, determine the total kinetic energy of the system.

Q: A wheel has a radius of 4.50 m. How far (path length) does a point on the circumference travel if…

A: a. the path length is s=rθ=4.5 m32°×π rad180°=2.5 m

Q: Part (a) Express the torque of F1 on cd, with respect of the axis ef, in terms of F1 and L2. τcd…

Q: If the turbine of the engine spins at an angular velocity of 217.011 radians per sec, what is the…

A: Given data :Angular velocity is ω =217.011 rad/sec

Q: 12-190. A particle moves along an Archimedean spiral r= 0 = 4 rad/s (80) ft, where 0 is given in…

A: Given, equation of the path of the particle is r=8θft And θ˙=4rad/s Then time derivatives…

Q: If a 70 kg man is riding a Monarch ergometer at 50 rpm and the resistance is 3.0 kg, what is the…

A: Mass of the man (m) = 70 kg Resistance (R) = 3.0 kg Ergometer at, 50 rpm

Q: 2-9) The in M rotationally mounted bar 1 (L1 = AM = 50 mm, ß = 53.13°) rotates with constant angular…

A: Step 1: Step 2: Step 3: Step 4:

Q: A 1.1kg bike wheel, is spinning 190rpm clockwise when a student applies a Frictional force as shown.…

A: Mass ( m ) = 1.1 kg Speed ( N ) = 190 rpm Force ( F ) = 2.3 N Radius ( r ) =( 5 × 10 ) cm = 0.5 m […

Q: The speed of a motor increases from 120 rad/s to 180 rad/s in 20.0 seconds. How many revolutions…

Q: 5. A pulley with a mass of 5.0 kg and a radius of 25 cm holds a string with a mass attached to each…

A: mass of the pulley, M=5 Kg radius of the pulley, R=25 cm=0.25 m Mass of block 1 on the left hand…

Q: For the mechanism in the position shown in Figure (a) where o = 60°, link 2 is the driver and…

Q: There are 2 thin uniform rods. Rod DC is pinned at its center of gravity (free to rotate 360…

Q: Wi 3. A drive shaft has an onzulof speed of 60.0 rad/ls. At probat distance from the axis should…

A: Given that A drive shaft has has an angular speed of 60rad/sec. To find At what distance from the…

Q: second hand and the linear speed and linear acceleration of a point on the second hand 7.67 cm from…

A: Radius r = 7.67 cm = 0.0767 m Time period T = 60 s Angular velocity w = 2π/T = 2 π /60…

Q: If the turbine of the engine spins at an angular velocity of 271.121 radians per sec, what is the…

A: Ans:- Image-1

Q: If the turbine of the engine spins at an angular velocity of 235.47 radians per sec, what is the…

Q: There are 2 thin uniform rods. Rod DC is pinned at its center of gravity (free to rotate 360…

A: Angular velocity for a rod pivoted at one end is given by ω=vl, where v is the linear velocity and l…

Q: The angle an airplane propeller makes with the horizontal as a function of time is given by theta =…

A: Angular velocity is given as ω=dθdt…

Q: a motor takes 8.00 s to go from 60rad/s to 140 rad/s at a constant angukar accerlation. the…

Q: What is the net torque on the rod shown in the figure? It is rotating around the axis passing…

A: Torque: It is a product of force with the perpendicular distance from the required point.…

Q: Gear B is driven by a motor mounted on turntable C. If gear A is held fixed, and the motor shaft…

A: Given that, Constant angular velocity, wy =30 rad /sHere we have to find the angular velocity and…

Q: In which of the three cases would it be easiest to calculate the torque using METHOD 2? (You may…

Q: Compute the torque under the following considerations: F=120 N , Θ=14.7∘, and r=6.6 m

Q: A solid ball of radius 6.0 cm is initially smoothly 10 m/s along a horizontal floor. It then rolls…

Q: *17-44. The uniform bar of mass m is pin connected to the collar, which slides along the smooth…

A: Solution:-

Q: Our refrigerated microcentrifuge has a rotor that has a 5.6 cm radius. If a protocol asks for a…

Q: A compact disk starts from rest and accelerates to its final angular velocity of 3.50 rev/s in 1.50…

A: Given data as per question time t = 1.50s final velocity = 3.50rev/s

Q: e rotational energy of

Q: As shown in the figure, the member is anchored at A and section AB lies in the x-y plane. The…

A: in this question we determine fisrt unit vector or AB becuse we will found moment about segment AB.…

Question

100%

Do asap, multiple upvotes.

Light of wavelength 587.5 nm illuminates a slit of width 0.75mm.
At what distance from the slit should a screen be placed if the first minimum in the diffraction pattern is to be
0.85mm from the central maximum?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Why is the third torque negative?
At t=0 the current to a dc electric motor is reversed, resulting in an angular displacement of the motor shaft given by 0(t) =( 240 rad/s)t—( 20.9 rad/s² )t²—( 1.60 rad/s³ )t³.
Help me please The force-torque system acting on O is equivalent to the key acting on A. If R = 600i + 1400j + 700k lb and | C | = 1200 lb ⋅ pie, determine CR
In the figure, a motor weighing 3000 N hangs on a chain attached by an O-ring to two other chains, one attached to the ceiling and the other to the wall. Calculate the tensile force acting on the chain attached to the wall. Consider that the weights of the chains and the ring are negligible.
A wheel has a radius of 3.00 m. How far (path length) does a point on the circumference travel if the wheel is rotated through the following angles, respectively? (a) 25.0° (b) (c) m 25.0 rad 25.0 rev m
While installing new spark plugs in your car, the manual specifies they be tightened to 74 Nm. If you can only apply a force to the wrench 21 cm from the plug, and only at an angle of 53 degrees, What magnitude force should you apply to the wrench?