LANTPLAN 1Task 9Link state routing (open shortest path first protocol) is used in the given network.FFFaFF60LAN 2FaFGigLAN 2Bandwidths of Fast Ethernet (100 Mbps) and Gigabit Ethernet (1000 Mbps) areknown and the OSPF cost of an interface is defined as:Cost 100Mbps/ (interface bandwidth).Solve the subtasks below. Write down all assumptions.a) Determine routing table of router A (15p)Destination NextAvertex1BсDEFGHOSPF cost0b) Determine the lowest OSPF cost from the device in LAN 1 to the device inLAN 2. (5p)c) Draw all sink trees for Router A. One graph should represent one sink tree.(10p)

Part c: Sink Tree for Router A:A diagram of the sink tree from Router A is as follows:mathematica…

Answered: LANT P LAN 1 Task 9 Link state routing…

Operations Research : Applications and Algorithms

4th Edition

ISBN:9780534380588

Author:Wayne L. Winston

Publisher:Wayne L. Winston

Chapter20: Queuing Theory

Section20.10: Exponential Queues In Series And Open Queuing Networks

Problem 8P

See similar textbooks

Similar questions

If a two port bridge was used in a heavy load standard Ethernet network such that the traffic is going through it. If each station is theoretically given a capacity of5Mbpsand the number of stations in each LAN segment is equal, then the number of stations in each LAN is:
Give unique answer only. Do not use AI or plagiarized answer.
Assume that there is a shared connection (for example, an Ethernet bus) with a speed of 1 Mbps. How much time (in microseconds) is required to send a frame with a length of 1000 bits over this link?
Data Communication
data communication
If a multi port bridge was used in a heavy load standard Ethernet network such that the traffic is not going through it. If the total number of stations in the LAN is 40 and the number of collision domains is 4 with equal number of stations in each domain, then each station will theoretically be given a capacity in Mbps :equals to
Please written by computer source
Efficiency Principle:Ethernet V1 access protocol was designed to run at 10 Mbps over 2.5 Km using 1500 Byte packets. This same protocol needs to be used at 100 Mbps at the same efficiency (utilization). What distance can it cover if the frame size is not changed? (Note: be careful with the units.
1. Build a Router network which has three Generic Routers and totally of Six networks in it. From each Router the required switch shall be connected through Fast Ethernet port and the switch is connected to two users. On the whole there are '6' networks in the configuration. Along with the network diagram do the packet transfer in simulation mode and write results for three different combinations.
A packet switch receives a packet and determines the outbound link to which the packet should be forwarded. When the packet arrives, one other packet is halfway done being transmitted on this outbound link and four other packets are waiting to be transmitted. Packets are transmitted in order of arrival. Suppose all packets are 1,200 bytes and the link rate is 2 Mbps. What is the queuing delay for the packet? More generally, what is the queuing delay when all packets have length L, the transmission rate is R, x bits of the currently-being-transmitted packet have been transmitted, and n packets are already in the queue?
Computer Networks Problem In the CSMA/CD protocol, the network adapter waits K-512 bit times after a collision, where K is drawn randomly. For K=20, how long does the adapter wait until returning to Step 2 for a 10 Mbps broadcast channel?
A communication satellite orbits the earth at distance of 30000 miles with each mile having a propagation speed of 5 x 10^(-6) seconds. The data rate of the satellite link is 1 Mb/s. Suppose a data frame is 1250 bytes and that ACKs have negligible processing and transmission times. With the Stop-and-Wait protocol, what is the maximum utilization possible.Discuss ways in which the utilization can be improved. Remember that the satellite is far away and therefore outline the disadvantages to any scheme you propose that may improve the utilization.

SEE MORE QUESTIONS

Recommended textbooks for you

Operations Research : Applications and Algorithms

Computer Science

ISBN:

9780534380588

Author:

Wayne L. Winston

Publisher:

Brooks Cole

Systems Architecture

Computer Science

ISBN:

9781305080195

Author:

Stephen D. Burd

Publisher:

Cengage Learning

Operations Research : Applications and Algorithms

Computer Science

ISBN:

9780534380588

Author:

Wayne L. Winston

Publisher:

Brooks Cole

Systems Architecture

Computer Science

ISBN:

9781305080195

Author:

Stephen D. Burd

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS