Kod 1219¢4m. 37° O Tension M shiy fore exutd by hinge On rod.
Q: A heavy beam is 6.00m long and weighs 250N. It is hinged at one end and held so that it is 30° below…
A:
Q: If the resultant force acting on the bracket is to be 750 N directed akong the positive x axis,…
A: Concept used: Cosine components of force act only x-axis. Sine components of force act along y-axis.
Q: The bar shown below is inclined at 45 degrees with the horizontal and at equilibrium. The force at C…
A:
Q: The 49-lb rectangular access door is held in the 90° open position by the single prop CD. Determine…
A: Static equilibrium equations are ∑Fz=0 ...............(1) ∑Mx=0…
Q: O A Elniform horizontal bean 3.om long and oeighing 3.0x. 1ON is attached to auoall by Pin…
A: Given data: Weight of beam, WB=3×102 N Weight of the person, Wp=6×102 N The distance of the person…
Q: goodeats.png The uniform horizontal beam supporting the sign is 1.39 m long, has a mass of 12.51 kg,…
A: Since the two wires are symmetrically replaced on either site of the middle of the sign, their…
Q: Determine the magnitude of force at the pin A and in the cable BC needed to support the 500 N load.…
A:
Q: Assuming P=10 kips in the connection shown, determine the maximum bearing stress between the rivet…
A: Given :P =10 kipsrivet measurement : 0.5 inch ( 12 inch )
Q: A 5-m weightless strut, hinged to a wall is used to support a 1189 N block as shown. Determine the…
A: Given Strut length AB = 5 m Weight W = 1189 N Determine the vertical component of the force…
Q: Determine the magnitude of the pin force at A. Assume W = 750 lb, a-3.1 ft, b = 2.2 ft, r = 7 in. r…
A:
Q: 4m A uniform ladder AB of weight WN and length 4m rests with its end A on rough horizontal ground…
A:
Q: A 400.0-N sign hangs from the end of a uniform strut. The strut is 4.0 m long and weighs a 600.0N.…
A: The tension(T) in the supporting cable and the force of the hinge of the strut. Length of the…
Q: A 183.6 kg uniform, horizontal beam is hinged at one end and at the other is supported by a cable…
A: Given Data:Mass Angle Length To Determine:The magnitude of the force at the hinge.
Q: The 3m long uniform plank is supported by a fulcrum at the midpoint. Where a 45kg student should…
A: Mass of person1 : m1 = 30 kg Mass of person2 : m2 = 40 kg Mass of person3 : m3 = 45 kg Position of…
Q: A sign is supported by a uniform horizontal boom of length 3.10 m and weight 72.0 N. A cable,…
A: In the system is in equilibrium so we know \sum F = 0∑F=0 and \sum\tau = 0∑τ=0. First we use the net…
Q: A man opens a 1.00-m wide door by pushing on it with a forceof 50.0 N directed perpendicular to its…
A:
Q: As shown below, a 258 N horizontal beam is in equilibrium. The orange circle represents the hinge.…
A: The forces acting are shown in the firgure below. In equilibrium, the total moment about the hinge…
Q: The fishing pole in the figure makes an angle of 20.0o with the horizontal. What is the torque…
A:
Q: Jack and Rose are carrying a uniform rod that is 3.00m long and weighs 160.N. If Rose lifts at one…
A: Given:- The jack and rose are carrying a uniform rod of length L = 3 m The weight of the rod is…
Q: t 80 N, length 6 meters) is being supported by cable and a hinge on a wall. The cable is attached to…
A: Given:- The weight W = 80 N The length of the L = 6 m The weight of the hang sign Ws = 100 N…
Q: A slightly simplified view of the arm has the hinge at the elbow, the bicep attaching to the bone…
A: Given Data: The distance of bicep from hinge is x = 2.5 cm. The distance between weight and hinge…
Q: Figure Fw 40° CG mg FT 1 of 1. Calculate the tension Fr in the wire that supports the 42 kg beam…
A:
Q: A UNIFORM ROD OF LENGTH 3M AND WEIGHT 100N WITH ENDS A AND B RESTING ON TWO BRACKETS, BEARS 50N…
A: The diagram is drawn below.
Q: A slightly simplified view of the arm has the hinge at the elbow, the bicep attaching to the bone…
A:
Q: A horizontal plank 4.32m long and having mass 25.2 kg rests on two pivots, one at the left end and a…
A:
Q: The foot of a ladder rests against a wall and its top is held by a tie rope, as shown. The ladder…
A: Given-
Q: a solid uniform ball with a mass m and diameter d is supported against a vertical frictionless wall…
A: Given: The mass of ball is m. The diameter of the ball is d. The length of the massless string is…
Q: A uniform beam has a length of 17.7 m and a mass of 39.6 kg. The beam is horizontal and resting (in…
A:
Q: メ> 10 kg l0m->
A: Given,Tension in the rope, T = 125 Ng = 10 Nkgsin 37° = 0.60cos 37° = 0.8weight, W = 80 Nlength of…
Q: In a uniform see-saw, child A of mass 20 kg sits at 2.3 m from the center of the fulcrum. At what…
A: Given data, Mass of the child A = 20 kg Distance from the center of see-saw of the child A = 2.3 m…
Q: A 3.0kg uniform pole 1.8m long is held horizontal by a hinge to a wall and supported by a cable…
A: To solve this problem, we need to use the principle of moments. The pole is in equilibrium, so the…
Q: A uniform rod of length 3m and weight 100N with ends A and B resting on two brackets and bearing 50N…
A: For equilibrium net force as well as net torque acting on the system must be zero.
Q: 2 mg A ladder is leaning against a wall as shown on the left. The mass of the ladder is 17.5 kg. The…
A:
Step by step
Solved in 3 steps with 3 images
