Knowing that all = 24 ksi and Tall = 14 ksi, select the most economical wide flange shape that should be used to support the loading shown. Determine the value to be expected for om, Tm, and the principal stress Omax at the junction of the flange and the web of the selected beam. Assume the support at A is a pin and the support at B is a roller.

Q: 2. Knowing that all = 24 ksi and Tall= 14 ksi, select the most economical wide flange shape that…

A: Given   Allowable bending stress= 24 KSI  allowable Shear stress= 14 Ksi

Q: The prismatic bar has a solid circular cross section with 2-in. radius. Determine the average normal…

A: Given data : Radius (r)=2

Q: The rigid bar EFG is supported by the truss system shown. Knowing that the member CG is a solid…

A: Given Load PSpan 12 ftTo find out Normal stress in CG

Q: A B C 80 kN 2 m 50 kN D E F -1m--1 m--1 m--1 m-|

A:

Q: The three suspender bars AD, BE, and CF are made of the same material (E = 70 GPa) and have equal…

A: Given Data Three suspender bars are givenCross-sectional area A=450 mm2Young's modulus E=70 GPaTwo…

Q: R14-9. The 60 strain ronette is mounted on a beam. The following readings are obtained for each…

A: Given: The 60 strain rosette is mounted on a beam. The following readings are obtained for each…

Q: a. The beam weighs 3600N. Draw the V and M diagram. b. Assume we do not know the weight of the beam…

A: 1-If Beam weighs 3600 N then drawing of SFD and BMD 2- if Beam Weighs is not know then finding of…

Q: 3. Determine the required diameter of the pins at A and B to the nearest 1mm if the allowable shear…

A:

Q: The piece of plastic is originally rectangular. After the application of force, it deformed in the…

A: L = 500mm B = 800mm ∆Cx = a = 2mm∆Cy = b = 1.5mm∆Dx = c = 4mm∆Dy = b = 1.5mm

Q: The two bars are made of polystyrene, which has the stress-strain diagram shown. If the…

A: Given : Cross sectional area of bar AB is = 975 mm2 Cross Sectional area of bar BC = 2600 mm2…

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.