PLEASE FAST Kh-5M. For the tangent galvanometer a is the angle of the compass with respect to the earthmagnetic field Be (S-N), when the current in the coil I in mA versus tang is plotted to getthe slope S, then the horizontal magnetic field of the earth Be is proportional toSelect one:а. 2Sb. 1/S2c. s?d. S Kh-13E. If the compass of the tangent galvanometer makes angle e with respect to the earthmagnetic field B. (S-N), when the plane of the coil is parallel to the earth's magnetic field is asshown in Fig.What is the direction of the current in the coil?Select one:a. In the direction of the magnetic field of coil.Eb. Counterclockwisec. Cannot be determinedd. ClockwiseFig.13E

Kh-5M. For the tangent galvanometer a is the angle of the compass with respect to the earth magnetic field Be (S-N), when the current in the coil I in mA versus tang_is plotted to get the slope S, then the horizontal magnetic field of the earth Be is proportional to Select one: O a. 25 b. 1/S C. d. S

Kh-5M. For the tangent galvanometer a is the angle of the compass with respect to the earth magnetic field Be (S-N), when the current in the coil I in mA versus tang_is plotted to get the slope S, then the horizontal magnetic field of the earth Be is proportional to Select one: O a. 25 b. 1/S C. d. S

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In a lathe machine, The diameter of the driver and driven pulley are 2745 mm and 1200 mm respectively, And the driver pulley runs at speed of 225 rpm. Find the speed at which is driven pulley runs in the machine. the speed of the driven pulley in rpm is
What are the concentrated forces?
Statics of Rigid Bodies Note: If you have already answered the problems in this post, kindly ignore it. If not, then answer it. Thank you, Tutor! Content Covered: - Method of Joints Direction: Create two problems based on the topic "Method of Joints" and then solve them with a complete solution. In return, I will give you a good rating. Thank you so much! Note: Please bear in mind to create two problems based on the topic "Method of Joints." Be careful with the calculations in the problem. Kindly double check the solution and answer if there is a deficiency. And also, box the final answer. Thank you so much!
Which is the simplest type of vibrating motion?
Define the international system of units.
Do you want to see a comparison of the many varieties of dynamic rams in terms of their manufacturing process and physical characteristics?
kinetics of particles-relative motion report
Would the plank and the roller have the same acceleration why or why not?
In the motion of a crank shaft, the piston undergoes rotation rectilinear translation curvilinear translation general plane motion
i need the answer quickly
Q1. The part shown below will be turned in two machining steps. In the first step a length of (50 + 50) = 100 mm will be reduced from Ø100 mm to Ø80 mm and in the second step a length of 50 mm will be reduced from Ø80 mm to Ø60 mm. Calculate the required total machining time T with the following cutting conditions: Cutting speed V=80 m/min, Feed is f=0.8 mm/rev, Depth of cut 3 mm per pass. Ø100 Ø80 Ø60 50 50
4. State Hooke's law.