ja A resistance R₁ of 5kr is shunted by conductance G of 50 μS. The combination draws a current of 1o MA... from a d.c supply. Calculates a) GT and RF....-- b) I, and I2- <) The voltage across each resistor and the supply Voltage [Anse-a-250.j^ S. 4.Kr b-8mA, 2 mA C-40.2 ].-.-.

Q: Find currents I1 and I2 and voltages V1 and V2 for the network below. Also determine the charge…

A: The circuit is given in steady state condition In steady state, inductor acts as short circuit and…

Q: Determine and carefully sketch the even and odd parts of the function shown in Figure 1.

A:

Q: j202 Select one: O a. None of these O b. Is 100 <-90° mA O c. Is = 5.0<.90° A 90° me ell

A:

Q: 2X1N4148 2,2K R = 1K %3D V=12%p 2,2K Please find and draw the voltage over the load resistance, RL.…

A:

Q: Which of the following statement is true? a. Angle between load voltage and load current in a pure…

A: Solution:- Let's consider a capacitor C connected to load with capacitance C.C is connected as load.…

Q: The voltage sensitivities of Barium Titanate and Quartz are respectively 12 × 10-³ Vm/N and 15 ×…

A: Given, For Barium Titanate: Voltage sensitivity = 12×10-3 VmN Permittivity = 12.5×10-9 Fm   For…

Q: Determine the DC currents (1s. Ic and le) and dc junction voltages (VBE, VCE and Vca) In-Blank 1 mA,…

A: Given,  VBB = 3 VRB = 5 kΩRC = 232 ΩVcc = 18 VβDC = 65

Q: (a) Refer to the circuit as in Figure Q1(a), a switch has been in position A for a long time and…

A:

Q: A voltage-multiplier has a Vm = 60 V peak sinusoidal secondary voltage. During the positive…

A:

Q: 400 V is the input voltage given to a chopper, the required output is 650 V. The thyristor is…

A: DC-DC Converter: It will transfer the DC power from one circuit to another circuit at the required…

Q: Match each type of transducer with the corresponding physical phenomenon, law, or property where it…

A: We are given with the following choices: Lorentz law Charge Faraday's law Ohm's law Capacitance…

Q: (i) Analyse comparator circuit (op-amp U1) and compute its output voltage Vo1 sampled by probe PR2.…

A: "According to the Company's policy we will solve first three subparts of the question". Given the…

Q: alaulated m 91 you

A: Diode- Ideally diode is short circuited when forward biased. Ideally diode open circuited when…

Q: obtain the a-b, Hence I= 3A e the nnin calculate the circult bebw Refening to eQuivalend Svitable…

A: The thevenins equivalent circuit can be obtained by using nodal analysis.

Q: 2.)What is the difference between Ampere's law and Biot-Savart's law?

A: A current carrying wire produce magnetic field. The direction is obtained by right hand rule.…

Q: A system consists of o cubic cell. The electric potential applied to this cell drogs to 10V from 30V…

A: The value of the work done (W) can be calculated by multiplying the value of the potential…

Q: the non-inductive resistance of kelvin double bridge are set at 1000 each, the standard resistance…

A: Kelvin double bridge it's used to measure low resistance.  Resistance R= 1000 ohm Standard…

Q: Consider a system with input x[n] and output y[n] that satisfy the difference equation y[n] = ny[n –…

A: Given equation  y[n]=ny[n-1]+x[n]

Q: Ql: A plate (100 mm) wide and (15 mm) thick is joined with another plate by a singe transverne weld…

A: For the given data Length is calculated as shown below

Q: 0.5) A full-wave rectifier with L-C filter is shown in figure 3. If the resistance of the loa is…

A: According to the question we have to find the value of ripple factor.

Q: is the electrical voltage that generated from Thermo- Couple with c=3.75x10-2 and k=4.5x10-5 ,…

A:

Q: ,Qa(HW) shawn in Big. ImH Calulate alf.

A: In this question series RLC circuit is given...We have to find resonance frequency , voltage across…

Q: A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source.…

A:

Q: If a multiratio CT having 1505 CT ratio with 0.104 ohm secondary resistance and the excitation…

A: Given CT ratio = 150:5 secondary resistance = Zs =0.104 ohm Excitation current Ie =0.2 A I'=5 A…

Q: For the below circuit, find Req across the source in KO. 3 kn3 5 kn 4 kN 3 mA() 10 kn 3 7 kn3 Select…

A:

Q: The main difference between resistance R and capacitive reactance X, is that

A: Resistance  Resistance is the measure of opposition for the flow of electrons or current in an…

Q: We want to investigate how the field strength will be with air as dielectric and with steatite. A…

A: Parallel plate capacitor, Line voltage, VL=24 kV. Area of parallel plate A=1 m2. Distance between…

Q: r eut 20 Cm 1Ocm 1oum /111/ 下 A capacitur is mnde by sandwiching a sheet of two sheets of aluminum…

A: A capacitor is made by sandwiching a sheet of wax paper between two sheets of aluminium foil , as…

Q: A sample of Si is doped with 1016 phosphorus atoms /cm, find the Hall voltage in a sample with W-500…

A: Given data width of sample=500 μm =500×10-6mA=0.25 mm2I=1 mA =1×10-3ABZ=10-4 Wb/cm2= 1 wb/m2n=1016…

Q: 4. With reference to the Paschen curve below, Breakdown voltage (V) 60 55 50 45 40 35 30 0.5 1.0 1.5…

A: Given For P = 0.1 torr       d = 20 cm For P = 0.025       d = 20 cm

Q: The measured temperature is 173 OF and the reference is 45 °F. The voltage. in mV is Select one: O…

A: Explanation: From the thermocouple chart, the voltage in mV for 1730 F is 4.097 mV. And the voltage…

Q: Q1: For the circuits shown in figures. If the temperature has changed from 25°C to 65°C, find AIc.…

A: Given: Ic=1.5mA Ic=βIB+β+1Ico At T=250 C ,Ic=1.5mA ,β=55 ,Ico=10-6mA 1.5=55IB+56×10-6 IB=0.27mA

Q: How temperature effect conductivity? Explain with the help of following equation. m e'n7'

A: Ans) Conductive decreases as the temperature increases.

Q: cliocle with 24mA OF Current Flowing through has a vortage drop of 0.750. Determine the reverse…

A: Given that,                   Diode current ID =24 mA                   Voltage drop VD = 0.75 V…

Load flow analysis

Load flow analysis is a study or numerical calculation of the power flow of power in steady-state conditions in any electrical system. It is used to determine the flow of power (real and reactive), voltage, or current in a system under any load conditions. 

Nodal Matrix

The nodal matrix or simply known as admittance matrix, generally in engineering term it is called Y Matrix or Y bus, since it involve matrices so it is also referred as a n into n order matrix that represents a power system with n number of buses. It shows the buses' nodal admittance in a power system. The Y matrix is rather sparse in actual systems with thousands of buses. In the power system the transmission cables connect each bus to only a few other buses. Also the important data that one needs for have a power flow study is the Y Matrix.

Types of Buses

A bus is a type of system of communication that transfers data between the components inside a computer or between two or more computers. With multiple hardware connections, the earlier buses were parallel electrical wires but the term "bus" is now used for any type of physical arrangement which provides the same type of logical functions similar to the parallel electrical bus. Both parallel and bit connections are used by modern buses. They can be wired either electrical parallel or daisy chain topology or are connected by hubs which are switched same as in the case of Universal Serial Bus or USB.