j) Explain the regulator characteristics. k) Explain how the regulator characteristics should be in order to obtain the proper reactive load distirbution in generators operating in parallel. I) What is the difference between the excitation dynamo being shunt or series, explain which one is preferred.

j) Explain the regulator characteristics. k) Explain how the regulator characteristics should be in order to obtain the proper reactive load distirbution in generators operating in parallel. I) What is the difference between the excitation dynamo being shunt or series, explain which one is preferred.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a separately excited generator supplying rated load the armature reaction. is always present is always absent O none of these may be sometimes present
The armature reaction occurs when a separately excited generator supplies rated load: Is always present Is always absent May be sometimes present None of the above
4. What for brushes are employed in DC generator? 5. What is the function of armature in a DC generator? 6. What is the function of commutator in a DC machine in generator action. 7 Whieh diffe u0ad in
Q-4 100 MVA, 50 Hz alternator is operating at rated speed. The H constant of the machine is 5 MJMVA. The load suddenly increases by 50 MW. Due to delay in governor action, there is a delay of 0.5 sec in opening of steam value. The frequency deviation in percentage is
6 shunt generators are running in parallel in a curtain generating station. Each generator supplies a load current of 500 A at 220 V. The shunt field current of each generator is 5 A and the armature resistance of each machine is 0.05 ohm. If one generator is suddenly switched off determine the percentage change in terminal voltage, the total load current being kept uncharged. A: 3%-2%
4. The commercial efficoency of a shunt generator is maximum when its variable kon oquals...loss. a. constant e. iroa b. stray d. friction and windage 5. The basic requirement of a d.c. armature winding is that it must be a. a closed one b.a lap winding e.a wave winding d. either (b) or (e).
Plz answer all parts
what is the conclusion for the concepts of rotating amature and rotating field in an alternator?
Q 5. A wave-wound armature of a 6-pole generator has 51 slots. Each slot contains 20 conductors. The voltage required to be generated is 250 V. What would be the speed of coupled prime mover if flux per pole is 0.07 Wb. If the armature is rewound as lap-wound machine and run by same prime mover, what will be the generated voltage? (Ans. 70 rpm; 83.3 V)
i need the answer quickly
The winding of a 4-pole alternator having 36 slots and a coil span of 1 to 8 is short-pitched by ........... degrees. 150 40. 90 20 Brushless excitation system consisting of: Stator field winding and power diodes stator and rotor field winding and capacitor stator and rotor field winding and power diodes Everything mentioned in the options Full Name : *
Calculate the flux per pole required on full-load for a 50 kW, 400 V, 8-pole, 600 r.p.m. d.c. shunt generator with 256 conductors arranged in a lap-connected winding. The armature winding resistances is 0.1N, the shunt field resistance is 200 N and there is a brush contact voltage drop of 1 V at each brush on full load. 3.