It is desired to produce an aligned and continuous fiber-reinforced epoxy composite having a maximum of 50% fibers. A minimum longitudinal modulus of elasticity of 55 GPa and a minimum tensile strength of 1200 MPa are required. E-glass and carbon (PAN standard modulus) fibers are the possible candidates to select. In addition, assume the stress levels on the epoxy matrix at fiber failure are 70 MPa for E-glass fiber and 30MPa for carbon fiber, respectively. Which fiber meets the design requirement? Use the properties given in the Table below to evaluate your selection. Modulus of Elasticity (GPa) Materials Epoxy matrix E-glass Carbon 3.1 72.5 230 Tensile Strength (MPa) 69 3450 4000

It is desired to produce an aligned and continuous fiber-reinforced epoxy composite having a maximum of 50% fibers. A minimum longitudinal modulus of elasticity of 55 GPa and a minimum tensile strength of 1200 MPa are required. E-glass and carbon (PAN standard modulus) fibers are the possible candidates to select. In addition, assume the stress levels on the epoxy matrix at fiber failure are 70 MPa for E-glass fiber and 30MPa for carbon fiber, respectively. Which fiber meets the design requirement? Use the properties given in the Table below to evaluate your selection. Modulus of Elasticity (GPa) Materials Epoxy matrix E-glass Carbon 3.1 72.5 230 Tensile Strength (MPa) 69 3450 4000

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

For continuous and aligned fibre composites, prove that the Young's modulus of the composites along the longitudinal and transverse directions can be described using the EmEf equations: Ect= EmVm + EƒVƒ and Ect =VmEf+VjEm respectively.
Carbon fibers are used to reinforce with the matrix in the fiber-reinforced polymers. Select one: True False
Which is correct for 8 and Which is correct in 9?
1. For a load applied in the direction of fiber, assuming equal deformation in the components, the two phases are viewed as being defomed in parallel. Derive an equation relating the elastic modulus of the composites. F
What fiber fraction would be required for a composite with titanium fibers in a polycarbonate matrix (E = 2.5 GPa) to have the fibers handle 85% of a longitudinal tensile load? (Titanium Ef = 116 GPa )
solve 30-40 minutes hand written asap..i'll rate
1 Which one below is true for thermoplastic polymers? * O They do not soften when heated and do not harden when cooled. O Most cross-linked polymers are thermoplastics. O None of them. O They are harder and stronger than thermosetting polymers.
Can someone assist me please? Thanks.
State the critical difference in the processing behavior of thermoplastics vs. thermosets.
answer quickly
From the attached image. Annotate and explain the phases of the polymer stress-strain curve.
On the basis of fiber length and orientation, which of the following results to an 'isotropic' properties of fiber-reinforced composites. Continuous and aligned Discontinuous and randomly oriented Discontinuous and aligned