It is assumed that the sender is aware of and prepared for the roundtrip delay that exists between their location and the recipient's. With the potential for packet loss in protocol rdt 3.0, is a timer still necessary? Explain.

Q: Let's pretend the sender is aware of, and prepared for, a continuous roundtrip delay between their…

A: Timers are essential for the protocol. The total travel time between these two locations is shown…

Q: A sender with window size (W=3) is connected to a go back N receiver by a link with bandwidth =106…

A: In this scenario, the sender has a window size of 3, which means it can send up to three packets at…

Q: A sender with window size (W=3) is connected to a selective repeat  receiver by a link with…

A: Solution:   Given, the window size (W) of the sender is 3, the bandwidth of the link is 106…

Q: Assume that the sender and receiver have a constant roundtrip delay and that the sender is aware of…

A: The timer is required in the protocol: The round-trip time between the sender and recipient is…

Q: Assume that there is a constant roundtrip delay between the sender and the receiver, and that the…

A: Introduction: The time it takes a server to process and reply to a request is a possible barrier in…

Q: Suppose that the roundtrip delay between sender and receiver is constant and known to the sender.…

A: Assume that the sender and receiver have a constant roundtrip delay and that the sender is aware of…

Q: Sender and receiver have a continual round-trip delay, and the sender is aware of it. Is a timer…

A: Sender and receiver have a continual round-trip delay, and the sender is aware of it. Is a timer…

Q: Assume that the sender and receiver have a constant roundtrip delay and that the sender is aware of…

A: Assume that the sender and receiver have a constant roundtrip delay and that the sender is aware of…

Q: Assume the sender is aware of the roundtrip delay, which is both constant and known to the sender.…

A: RDT 3.0, Reliable Data Transfer When the maximum delay from sender to a receiver and  back is…

Q: Suppose that the roundtrip delay between sender and receiver is constant and known to the sender.…

A: The answer of the question is given below:

Q: We will assume that there is a constant roundtrip delay between the sender and the recipient. Is a…

A: Introduction : Roundtrip delay is the total amount of time it takes for a signal to be sent from one…

Q: There's a good reason why an ARP inquiry is sent in a broadcast frame. Why does an ARP reply have to…

A: The justification for sending an ARP request as a broadcast message is as follows: The source node…

Q: Question 1: Draw the flow diagram of stop and wait protocol (rdt 3.0 in action) of the following…

A: Stop and wait protocol means when sender sends data packet to receiver then the receiver receives…

Q: Assume the sender and receiver have a constant roundtrip delay. Is a timer still necessary in rdt…

A: Introduction: Timers are used to keep track of the time remaining till the packet is broadcast.  A…

Q: Assume the sender's round-trip latency is constant and well-known. Will If the packets could be…

A: Answer

Q: Assume a constant round-trip delay between the sender and receiver, and that the sender is aware of…

A: Timers are essential for the protocol: In this case, the total delay caused by the roundtrip journey…

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.