) is the fluid in the pipe shown below and mercury (s = 13.6) is the fluid in the manometer. If the deflection ∆h is 70 cm and l is 170 cm, what is the gage pressure at the center of the pipe?

Q: A mercury barometer at the base of the mountain reads 620 mm. At the same time, another barometer…

A:

Q: At one point in a pipeline the water's speed is 3.00 m/sand the gauge pressure is 5.00×10^4 Pa a)…

A:

Q: A large oil tank contains a circular gate with a diameter of 2 meters fixed to the inclined wall of…

A: Given Data: The specific gravity of oil, s=0.85 Diameter of the gate, d=2 m

Q: A capillary rise experiment is proposed for a high school physics class. The students are told that…

A:

Q: determine the height of the mountain.

A: Given: At sea level barometer reads 750 mm At Mountain level reads 745 mm Specific weight 12 N/m3 To…

Q: Find the gauge pressure at the bottom of a swimming pool that is 12 ft deep in psi. (The mass…

A: Given data Depth of pool is 12ft Mass density of water is 62.4lb/ft3 Gauge pressure =…

Q: At t = 0 the tank shown in fig. is full up to top level, write the differential equation for the…

A: Given Datar=0.05mt=0Conical and cylindrical

Q: If the fluid rises to a height of 160 mm, we write its gauge pressure as 160 mm H2O.  (a) Express…

A: Solution:

Q: 3. A tank full of water and oil (Soil = 0.80), as shown. Find the pressure at the oil/water T…

A:

Q: The belt moves at a steady velocity V and skims the op of oil tank. Assuming a linear velocity…

A:

Q: An open cylindrical tank with the curved portion restraining a body of static fluid as shown in the…

A: Solution: Given Data: T=20oCH=3 mR=1.7 mw=1.3 m   To Find: Horizontal distance to the centroid of…

Q: Given the following illustration, the pressure at A (far left) is PA = 81.4 psi, the pressure at B…

A: Dear student, for the sake of simplicity I have converted all the data in SI unit but final answer I…

Q: The fluid in the tank is water. Flow is steady state, incompressible and inviscid. It is known that…

A:

Q: A 25 meter vertical column of fluid with a density of 1972 kg/m^3 is located where the local gravity…

A: Introduction Fluid pressure varies with the height, as the depth increases the pressure also…

Q: The pressure at the bottom of a tank of oil (s=0.80) is 410 kPa.   Determine the equivalent head…

A:

Q: The quantities viscosity u, velocity V, and surface tension Y may be combined into a dimensionless…

A:

Q: What is the pressure head of oil (ft) in a vertical pipe if the pressure reading is 10 psi and the…

A: Given Data

Q: A cubic tank with a full capacity of 100 m^3 is filled halfway with oil (SG = 0.7). Determine the…

A:

Q: A pipe contains oil (density = 850 kg/m 3) at a gauge pressure of 200 kN/m 2 . Calculate the…

A:

Q: For the air duct shown below, if the total pressure of air is 250 kPa and the static pressure is 50…

A:

Q: Consider the pipe system in the diagram below. Tank 1 is a closed tank and the pressure in tank 1 is…

A: Given: The gravitational acceleration g=9.81m/s2. The minimum required flow rate is Qmin =0.5m3/s.…

Q: The fluid in a manometer tube is 60 % water and 40 % alcohol (S.G. = 0.83). What is the manometer…

A: The percentage of alcohol, %Alcohol = 40% = 0.4The percentage of water, %Water = 60% = 0.6The…

Q: For the vertical wall shown on the left, the oil thickness is assumed to be 0.2 m and its SG is 0.8.…

A: (a) To draw: The pressure diagram. Given: The density of water 1000 kgm2. Thickness of oil is 0.2 m.…

Q: -4 m 4 m 2.5 m 1 m a A

A:

Q: A tank of water 5m deep receives a constant upward acceleration az= 4 m2/sec, the gauge pressure at…

A:

Q: fluid having a density of 1400 kg/m³ stands in a tube of 6 mmθ at a height of 27 mm. what is the…

A:

Q: Find out the pressure difference between pipes A and B if A contains water and B contains oil of…

A:

Q: Jet of liquid (14 mm diameter) ejections vertically into the atmosphere. The pressure inside the jet…

A:

Q: vertical glass tube has an inside diameter of 1 mm. When pressure is applied, a column of water at…

A: Given Data D=1 mm h=25 cm T=20°C

Q: The belt moves at a steady velocity V and skims the top of oil tank. Assuming a linear velocity…

A:

Q: An inverted CONICAL tank (D = 0.5 m, H = 1 m) is full of water. Find the pressure at the bottom of…

A: D = 0.5 mH = 1 mDownward acceleration, a = 2 m/s2Required:P ( pressure at the bottom of the tank )

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A:

Q: What is the amount of pressure at point B (PB ), if the fluid is water and H = 35 m ( P at point A…

A: Given   P at point A  = 1 atm       Height, H = 35 m           ρ water =1000kg/m3 Find   Pressure at…

Q: Using the figure depicted below, calculate the minimum height h at which cavitation begins to occur.…

A:

Q: The belt as shown below, moves at steady velocity V and skim at the top of a tank of oil of…

A: Given data: viscosity=μpower=Pvelocity=Vdepth=hwidth of belt=b Need to drive the expression for the…

Q: Find the pressure and temperature at an altitude where the density is 0.5432 kg/m^3

A: Given Dataρ=0.5432 kg/m3Using the standard atmospheric conditions

Q: Consider a cylindrical tank of height h and base radius r filled with a liquid of density ρ. Find…

A: The hydrostatic force acting on a horizontal differential area A at a depth y from the surface of…