Is the flow incompressible? g is a constant
Q: A reservoir has a shape that is approximately rectangular. It is being held by a dam that is 525…
A: Given value--- breadth = 525 m. length = 12700 m. height = 84 m. We have to find--- What is the…
Q: 8.19 WP A fluid flows through a horizontal o.1-in.-diameter pipe. When the Reynolds number is 1500,…
A: Datas given head loss hL=6.4 ft length of the pipe=20 ft Given Reynolds number=1500…
Q: The human iliac artery has a radius of 0.35 cm. The presure gradient is 390 Pa/m Assume blood is 4…
A: Given, radius of artery, r = 0.35 cmpressure gradient, ∆PL= 390 Pamviscosity of blood, ηblood =…
Q: What outward force (in N) is needed on the outside of a lung to create the pressure P noted in the…
A:
Q: what is the ratio of the final cross sectional area of the pipe to the initial cross sectional area?
A: The water’s flow rate at both the cross-sections will be the same. Thu Here, Q, A, and v represent…
Q: A light spring of force constant k = 164 N/m rests vertically on the bottom of a large beaker of…
A: Step 1: Step 2: Step 3: Step 4:
Q: , what is the volume flow rate?
A:
Q: A large man sits on a four-legged chair with his feet off the floor. The combined mass of the man…
A: To find the pressure
Q: In the diagram below, the vertical heights holl and hwater are 3.00 cm and 3.00 cm. The diameter of…
A:
Q: The pressure-flow characteristic of a pump can be expressed in equation form as AP, = Qo - aQ? The…
A: Given that,The pressure-flow characteristics of a pump can be expressed in equation form…
Q: A horizontal segment of pipe tapers from a cross-sectional area of 48.3 cm to 0.500 cm. The pressure…
A: Given data: Area of cross section of one of the larger end of the pipe is, A1 =48.3 cm2 = 0.483 m2…
Q: Often when salty sea water meets a source of fresh water they do not readily mix. The salt water is…
A:
Q: What outward force (in N) is needed on the outside of a lung to create the pressure P noted in the…
A: Write the given values of this problem. P=-5.50 mm Hg P=-5.50×133.32P=-733.26 PaA=270 cm2 or 0.027…
Q: P2 P1 Water moves through a constricted pipe in stead, ideal flow. At the lower point, the pressure…
A:
Q: The figure shows a ramp inclined at 30° leading into a swimming pool. Calculate the fluid force F on…
A: Given a = 5 fts b = 2 fts Weight density W = 62.5 lb/ft3 To find out Fluid force F on the ramp
Q: What is the flow rate of a horizontal pipe whose intake diameter is 20 cm, and the constriction…
A:
Q: Fresh water moves at a constant speed through a pipe. The pipe bends upward, but the diameter does…
A:
Q: 12 point VA VB An unknown fluid flows through a horizontal pipe with a decreasing square cross…
A: Given : The velocity of the fluid at the point A is vA = 4.7 m/s and the cross-section is…
Q: Which of the following describes an incompressible flow? O The pressure at a given point cannot…
A: Introduction :- Here we need to know the basic definition of incompressible flow in case of fluid…
Q: Oil is flowing through a pipeline at a speed of 1.4 m/s. If the diameter of the pipe is 0.12 m, what…
A: Given Speed = 1.4 m/s Diameter of the pipe = 0.12 m Radius of pipe = 0.06 m = 6 x 10-2 m
Q: Use Bernoulli's equation to estimate the upward force on an airplane's wing if the average flow…
A: Given:Average flow speed of air, vairup= 190 m/s…
Q: The drawing shows an intravenous feeding. With the distance shown, nutrient solution (p = 1050 kg/m)…
A: The pressure due to the fluid is given by P = h d g where, h is the height of the fluid, d is the…
Q: Turbulence in the aorta is a certainty for a Reynolds number of 3000. Assuming that blood is an…
A:
Q: A straight horizontal pipe with a diameter of 1.0 cm and a length of 51 m carries oil with a…
A:
Q: A 5.8 cm diameter horizontal pipe gradually narrows to 2.9 cm . When water flows through this pipe…
A:
Q: What outward force (in N) is needed on the outside of a lung to create the pressure P noted in the…
A: Given Pressure is given as P=-6.00 mm Hg Area is A=270 cm2=270×10-4 m2 We have to calculate the…
Q: A horizontal pipe carries a smoothly flowing liquid of density of 1330 kg/m3. At Locations 1 and 2…
A: The data given is as follows: 1. The density of the fluid, ρl=1330 kg/m3 2. The diameter of the pipe…
Q: A 6.6 cm diameter pipe gradually narrows to 4.0 cm. When water flows through this pipe at a certain…
A:
Q: Is the flow speed at Location 2 higher or lower than the flow speed at Location 1? higher di cannot…
A: Given:- d1= 5.93 cm = 0.0593 m d2= 2.27 cm = 0.0227 m A1= area of cross section of location 1=…
Q: Water flows with a constant speed through pipe of constant cross-sectional area in the ground floor…
A: Part a: The pressure difference between top (P1) and bottom (P2) is given in terms of density of…
Q: The picture shows a section of pipe within a closed system (not open at the ends). Water (density…
A:
Q: Water flows through a pipe that gradually descends from a height of 6.78 m to the ground. Near the…
A: height (h) = 6.78 m Area of cross section near the top (A1) = 0.4 m2Area of cross section near the…
Q: Water flows from a drain spout with an initial velocity of 1 m/s with angle of 15°. Determine the…
A: Given data :- The initial velocity of the water is v = 1 m/s. The angle of drain spout is θ = 15o.…
Q: A round pipe of varying diameter carries petroleum from a wellhead to a refinery. At the wellhead,…
A:
Q: The drawing shows an intravenous feeding. With the distance shown, nutrient solution (p = 1020…
A: We are given that solution can just barely enters the blood in the vain. That means at both ends the…
Q: e diameters are ?1=6.97 cm and ?2=2.65 cm, respectively. Is the flow speed at Location 2 higher or…
A: The density of the liquid ρ = 1290 kg/m3 At Locations 1 and 2 along the pipe, the diameters are…
Q: of the stream? oo unit m/s the gauge pressure of the gun's reservoir, assuming th of the water is…
A:
Q: Water flows through a horizontal pipe with a cross- sectional area of 4 m2 at a speed of 5 m/s with…
A: Here given the horizontal zontal pipe at initial cross section is 4 m² where speed is 5m/s and…
Q: Water flows through the vertical pipe such that when it is at A, it is subjected to a pressure of…
A:
Q: 1 m 2 m E 2 m H 1 m -2 m -1 m-
A:
Q: Water is flowing through a venturimeter shown. The difference in pressure between A (D = 5cm) and B…
A:
Q: What outward force (in N) is needed on the outside of a lung to create the pressure P noted in the…
A: Given Data The pressure created outside the lung is :P=-5 mm Hg The affected area is:A=280 cm2 To…
Q: Q) When the patient is conscious, the specialized doctorgives him nutrients through an intravenous…
A: density of solution (ρ) = 1.05 gmlPressure (P) = 5.99 kPa
Is the flow incompressible?
g is a constant
Step by step
Solved in 2 steps with 1 images
- please answer in mWater flows with a constant speed through a pipe of constant cross-sectional area in the ground floor (y1=0m) of a house. The pipe rises (y2=5.0m) to reach a shower head on the second floor. The pressure at ground level is 140kPa. a) what is the pressure at the shower head? b) what is the maximum height that water from the ground level could reach?A cylinder that is hi = 18.5 cm tall and open on top is filled with water. If a hole is made in the side of the cylinder, Ah Ah = 3.40 cm below the top level, how far x from the base of the cylinder will the stream land? h, Assume that the cylinder is large enough so that the level of the water in the cylinder does not drop significantly. cm
- O. A tank has vertical section of function (y = x") is initially filled with water At the bottom of the tank there is a hole of radius (1 cm) which the water drains under the influence of gravity, and the drag factor (Ca = 1). Find the depth of water at any time. y = x? 3 m Vertical section in tankSolveلابد B A These four containers are filled with the same volume of water. Which has the highest pressure at the bottom? A B C