ired information E: This is a multi-part question. Once e given figure, the bent rod ABEF is mm long, and the load W is 540 N.. 4/1

Q: Please help. Written on paper not typed on computer or keyboard please. Need help on all questions.…

A: Step 1: Step 2:Step 3:Step 4:

Q: P=650N d=0.20m h=0.35m What are the Y components of the forces at B and C

A:

Q: In (Figure 1), P₁ = 12 kN and P₂ = 6 kN. Figure 2 m G B 1 m 2 m 1 m 1 of 1

A:

Q: The pin-connected structure consists of a rigid bar ABCD and two axial members. Bar (1) is bronze [E…

A: The given information in the problem is shown in the following attached image:

Q: A flanged wooden shape is used to support the loads shown on the beam. The dimensions of the shape…

A:

Q: Find the reactions at pins A, B, and C in the frame below if you REPLACE the 6 kips pointing down at…

A:

Q: when the beam is horizontal. For W-90 lb and the stiffness of the spring k-313 lb/in, determine the…

A: The free-body diagram is-

Q: Please write it out. I don’t like the computer typed answers. Need help on all questions. Please…

A:

Q: A Ax = Bx = Ex = Number W Find the magnitude of the horizontal and vertical components of the pin…

A:

Q: Consider the bracket shown in Fig-3. If: • F1 = 10 lb @ -90° • a - 2 ft • b = 4 ft C = 1 ft then,…

A:

Q: A flanged wooden shape is used to support the loads shown on the beam. The dimensions of the shape…

A:

Q: i) Find the "x" and "y" components of the reaction force at A. Ax A₂ Ay = ii) Find the "x" and "y"…

A: According to the given dataConsidering the free body diagram AC and BCDE We need to find theReaction…

Q: The figureshows a copper rod that is placed in an aluminum tube. The rod is 0.005 in. Ionger than…

A:

Q: Bracket BCD is supported by a hinge at C and a cable at B, as shown below. Given the forces P=288 N…

A:

Q: Use the Method of Sections to find the load in member EK of the bridge. Is it in tension or…

A:

Q: Find the reactions at pins A, B, and C in the frame below if you REPLACE the 6 kips pointing down at…

A:

Q: I need help on solving this question

A:

Q: Shear breaking strength of the solder used in the brazing joint in the figure. tIK=15daN/mm2 since…

A: Given: The shear stress in brazed joint = 15 DaN/mm2 = 150 N/mm2 The factor of safety, n = 3

Q: Consider the structure shown in Figure 1). Assume the cornections A, B, and C are pins. Suppose that…

A: Part (A): Draw the free-body diagram of AB.

Q: Need help on all questions. Please include all units, steps to the problem and information such as…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.