and Z.rms, 7½ Part (a) Express the rms current, Irms, in terms of AV,*rmsAV rms8 97НOMEd↑^^ 4Irms3himRSubmitHintfir,% 2art (b) Calculate the numerical value of Irms in amps.Part (c) Express the average power dissipated in the circuit, Pavg, in terms of Ims and R.Part (d) Calculate the value of P,in watts.avg { ; Problem 6: The simple AC circuit shown on the right has resistance R= 45 Q andimpedance Z = 67 Q. The rms voltage of the power supply is AVrmsC188 V.RAV

Given, Vrms=188V Z=67Ω Since, we know the formula Irms=△VrmsZIrms=188V67Ω=2.8Amp So, Irms is 2.8Amp

Answered: ir Part (b) Calculate the numerical…

Similar questions

In a series circuit, how does dissipated power related to the resistance? Refer to this equation P=I^2R a. power is directly proportional to the resistance b. power is inversely proportional to the resistance c. resistance has no effect on power d. the greater the resistance, the lesser the power
A 120-Ohm resistor is in series with unknown resistor. The voltage drop across the unknown resistor is 12V and power dissipated b the 120-Ohm resistor is 4.8W. calculate the value of unknown resistor.
Please Asap
d. An RC circuit has a resistance of 20, a capacitance of 50µF, and is connected to a battery of 5V. What| will be the capacitor's maximum charge and about how long will it take to charge it to 99% of its maximum value?
In the circuit diagram R1 = 5R and R2 = 15R, where R = 14 Ω. The power dissipated in resistor 2 is P = 1.6 W. Part (a) What is the voltage across the battery in volts? Part (b) How much power, Ps, is the source supplying, in watts?
A fully charged capacitor with capacitance of C= 80 uF is being discharged. If the total electric resistance of the circuit is 24.0 k and the initial voltage of capacitor is V=10 V, then: a) How long does it take for the capacitor to discharge by 70%? b) Calculate the energy lost from the capacitor by this time? c) Calculate the heat energy produced in the resistor by this time. d) Are the values of energies in parts c and d expected to be the same? Explain.
20 Auto Fit for: Data Set | Current | = A*exp(-C*t) A: 20.00 C: 0.04000 10 Correlation: 1.000 RMSE: 2.373E-16 amp Current (amp) 15 LO
In an RC circuit, if we change the resistance to one with a higher value, we would expect that: A. The area under the curve changes B. Capacitor discharges faster C. The capacitor takes longer to achieve Q max D. Change the Vc voltage when the capacitor charges

ir Part (b) Calculate the numerical value of Irms in amps. Part (c) Express the average power dissipated in the circuit, Pavg, in terms of Ims and R. Part (d) Calculate the value of P, in watts. avg