noo Anod licqz 10Question 5tai Calculate the shrinkage factor of a soil that has the following characteristics:WEET / BANK unit = 1700kgMEZ. WeT / COMPACTED unit = 3500SAFEASE X-FI= 3 Soo ka Fко(Short X J

Answered: Image /qna-images/answer/04c2b0c1-7c3a-4480-9fa9-31ba53e9d7d2.jpg

inod loqa olu Question 5 tai Calculate the shrinkage factor of a soil that has the following characteristics: mε2.31 unit = 3500 = 3 500 kg F reg Shoot X J WET / BANK unit = 1700kg WeT / COMPACTED FEAE XF1

inod loqa olu Question 5 tai Calculate the shrinkage factor of a soil that has the following characteristics: mε2.31 unit = 3500 = 3 500 kg F reg Shoot X J WET / BANK unit = 1700kg WeT / COMPACTED FEAE XF1

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: In a shrinkage limit test, the volume and mass of a dry soil pat are found to be 50 cm³ and 88 g…

Q: 6.6 The in situ moist unit weight of a soil is 17.3 kN/m³ and the moisture content is 16%. The…

Q: Describe the physical state of soil with the following values of liquidity index: a) LI1.

Q: Q1: Classify the below soil according to Unified Soil Classification System (USCS) and .the AASHTO…

A: The fines proportion of the given soil is 10%. So, the proportion of the fine is more than 5% and…

Q: Question 14 Classify the following soils using the Unified soil classification system. Give the…

A: Given data, Percentage of finer passing through No.4 sieve = 100 No.200 sieve = 77 Liquid limit…

Q: Problem 14. The plastic limit and liquid limit of a soil are 36% and 54% respectively. The…

Q: Classify the following soils using the Unified soil classification system. Give the group symbol.…

A: Given data, No. 4 = 60 No. 200 = 40 LL = 26 PL = 4 Classify soil as per USCS

Q: Q3: Classify the following soil according to USCS. PI=25, L.L.= 40 Sieve No. Mass of soil retained…

A: USCS: The full form of USCS is the Unified Soil Classification System. The unified soil…

Q: A В D E determine the required field density at 90% compaction. 2 Mold Volume Soil Wet Weight in…

Q: 1. A saturated soil with a volume of 19.65cc has a mass of 36g. When the soil was dried its volume…

A: Saturated soil Volume V1 = 19.65 cc Mass M1 = 36 GM Dry soil Volume V2 = 13.5 cc Mass M2 = 25 gm…

Q: For a given soil, show that 1 + W sat w Yw Ysat = n( = n(¹ Won)y. W sat where wsat = moisture…

A: Prove the given relation between different quantities.

Q: (c) A dam project will be constructed in the London town. The laboratory test resultson a saturated…

A: Given data Wet mass Dry mass Initial volume Final volume

Q: 2. The resulting of the Standard Proctor Test is as follows: Vol. of Proctor Mold Wt. of wet soil in…

A: Find the corresponding dry densities of the given water content results from Standard Proctor Test…

Q: 3. Given below the tabulated result in the field of compaction test. A. Unit Weight Determination…

A: Water content is defined as the ratio of weight of water to the weight of soil solids= (Wt of…

Q: Table 2. Soils data Effective Void ratio stress,o’ kPa 25 Soil A Soil B 0.93 1.06 50 0.92 0.98 100…

Q: Please calculate the clay content %, this w%

A: Given the table, Sample number 1 2 3 Mass of empty, clean can (grams) 3.47 3.69 3.75 Mass…

Q: For a given soil, show that e Ya + Y sat Yw 1 + e

A: To show the following, equation we need to see the formula used in these equations. γsat=G+e1+eγw…

Q: Using AASHTO Classification System, determine the following: (a) Group Index (b) Soil Classification…

Q: The plastic limit and liquid limit of a soil are 30% and 42% respectively. The percentage volume…

A: Given- Plastic limit PL=30%, Liquid Limit LL=42%, % volume change=22% & 35%

Q: The liquid limit and plasticity index of the minus No. 40 fraction of the soil are 40 and 15,…

A: Soil classification by AASHTO

Q: ou take a representative soil sample back to your home laboratory and determine the following data:…

A: Concentration of Al+3 = 2.8 cmol/kg soil 1 AFS soil = 2,000,000 lbs

Q: Which of the following nearly gives the %gravel of Soil B using AASHTO? which of the following…

Q: 8. The looseness or denseness of sandy soils can be expressed numerically by the so-called relative…

A: Given data- Mass of the sample = 1830 g Volume of the sample = 0.001 m3 Sp.gravity (G) = 2.60 water…

Q: SITUATION 3: A soil was tested and the following properties were found: Percent of fine grain…

A: Liquid limit, plastic limit and moisture content have been given and it has been asked to determine…

Q: The o weight of 0.1 cubic feet of soil is 12.2 Ib. If the moisture content is 12% and the specific…

A: Given data in question Volume 0.1 ft3 weight 12.2 lb Moisture content 12% Specific gravity 2.72 To…

Q: Exercise No.4.3 For a given soil, show that Ysat e Yd - Ysat Ya + Yw

A: Unit Weight, g, is usually determined in the laboratory by measuring the weight and volume of a…

Q: 4.9 The maximum and minimum dry unit weights of a sand were determined in the laboratory to be 18.31…

A: (4.9)

Q: A cube soil sPecimen of dimensions loem X locm xlocm has Mass ofl.9o kg and water conten t We = )5 %…

Q: No. 200 sieve 100 80 Soil A Soil B 60 Figure 5.9 gives the grain-size distribution of two soils. The…

A: For soil A: Refer the grain size distribution curve, D10=0.09D30=0.15D60=0.2 It is required to…

Q: A soil sample weighs 1270g. After oven drying, volume and weight of soil reduced by 10% % and 25%…

Q: Problem 1: 0.48mm, D30 0.25mm, and D10 For a gravel with D60 coefficient and the coefficient of…

A: The uniformity coefficient is given as:The coefficient of gradation is given as:Considered together,…

Q: Q2- Classify the soil of following properties according to Unified and Textural Classification…

A: given: L.L=40%P.L=35%

Q: .Draw a phase diagram and then derive the necessary relationships in order to answer the following…

A: Specific gravity of clay (G) = 2.69 Void ratio (e) = 0.90 Dry unit weight…

Q: 2. Following are the results from the liquid and plastic limit tests for a soil. LIQUID LIMIT TEST…

A: As stated by the student , i am solving problem 2 Given: Liquid limit test data and plastic limit =…

Q: Soil A B No. 4 91 85 % Finer No. 200 58 32 Liquid Limit 30 25 Plastic Limit 12 19 Uniformity…

Q: SAND Medium Coarse| T Coarse Fine Fine # 200 # 4 3" 100 90 80 70 1. %3D B 50 %3D 40 %3D %3D 30 20…

A: Given- LL=30PL=25

Q: PROBLEM NO. 3 For an inorganic soil, the following grain size analysis is given: U.S. Sieve No.…

A: Solution: Given: U.S. Sieve No. Diameter m(m) % Passing 4 4.75 100 10 2 90 20 0.85 64 40…

Q: Exercise No.4.5 (G₁ + Se). + For a given soil, show that Y = Yw

Q: • Particle size analyses were carried out on two soils-Soil A and Soil B-and the particle size…

A: Given Soil A - silt and clay and sand content. Soil B- clay content is missing and soil is non…

Concept explainers

Weight-Volume relationships

Weight is defined as the quantity of matter contained in a body. Weight can also be defined as the force acting on a body due to gravity. Mathematically, weight can be defined as-

Question

Expert Solution

Step 1

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

An oven dry sand mass with a dry unit weight of 105pcf and Gs of 2.70 is placed outdoors in a container. Overnight, it rains. As it rains, the total volume of the soil specimen within the container remains the same, yet the S increases to 55% by the time the rain is over for the night. a. Determine the new total unit weight of the soil after the rain in units of pcf. Express your answer in four significant figures. Show full phase diagram.
For a given soil, prove that: 1 + sat 3 Y sat = N sat
Using Unified Soil Classification System, determine the type of soil, the coefficient of gradation and the group symbol. Passing No. 4 = 47 % Passing No. 200 = 22 % Dio = 0.685 mm D30 = 1.391 mm De0 = 4.076 mm Plasticity for the minus No. 40 fraction: Liquid Limit = 35 % Plastic Limit = 23 % O SP O Coef. of Gradation = 0.69 O Sand O Gravel O GP O silt O SC O GC O Coef. of Gradation = 5.95 O Clay
A. Answer in True or False 1. A soil has a Cu =1, then it is considered as a poorly graded soll. 2. A soll has L.L-60% and P.L-35%, then it plots a point below the A-line in the plasticity chat 3. A soil described with a symbol (SP) has % passing No. 200 sievs more than 50% 4. Decreasing water content below shrinkage limit is accompanied with a decreasing in void r 5. Water molecules are considered polar and known as dipoles. 6. Dry Density is the smallest density. 7. Capillary rise is directly proportional to the pore channel diameter. 8. The unconfined compressive strength is twice the undrained cohesion. 9. Piping or boiling occurs when effective stress equals to zero. 10. It is assumed that the secondary compression begins when the primary consolidation endis
A sample of saturated soft clay has a moisture content of w. The specific weight of solids é ys em g-f/cm' (Table 1). What is the void index, porosity and saturated specific weight of the soil (in g-f/cm). Adopt water specific weight of 1 g-f/cm3.
Q2: Answer the following questions. 1- For the soil packing shown in the figure below, find the void ration of this soil Sphere Sphere Sphere Sphere 2- Discuss why illite clay is more stable than montmorillonite clay.
i need the answer quickly
Geotech eng
Plot the moisture density curve and determine the maximum dry unit weight of compaction and the optimum moisture content.
Given the phase diagram shown, what is the porosity of the soil?
I need the answer as soon as possible
A cone penetration test has been conducted, and has measured a cone resistance of 85 kg/cm² at a depth of 10 m. The vertical effective stress at this depth is 150 kPa, and the overconsoliation ratio is 2. The soils at this depth are quartz sands. Compute the relative density, and classify the soil using Table 3.3.