Answered: In this experiment, why do we generate…

Science

Chemistry

In this experiment, why do we generate 12 electrochemically in situ rather than adding a known weight or volume?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: The maximum amount of iron(III) hydroxide that will dissolve in a 0.105 M iron(III) nitrate solution…

A: Given: Concentration of iron (III) nitrate i.e. Fe(NO3)3 = 0.105 M

Q: Research project if you copie from chatgtp or any ai will be reported Throughout this unit, you…

A: 1. How do alkaline batteries work, and what are the chemical reactions involved?*Research…

Q: For a nitrate ion selective electrode, the selectivity factor for nitrite over nitrate is 0.062 and…

A: First calculate percentage of nitrite present in nitrate; 0.062×100=6.2% Now calculate percentage of…

Q: of a ne c

A: We know that, the EMF of Westron standard cell is 1.0153 at 20∘C.

Q: What do counter-current and co-current extraction columns mean? Explain

A: 1) counter current extraction- Counter current flow means both liquids move in opposite direction…

Q: What is the difference between a calibration curve and a standard curve in analytical chemistry?…

A: Introduction: Analytical chemistry is a fascinating field that plays a vital role in the development…

Q: After graphing E vs 1 n initial 2 you obtain the following best-fit linear line: y = -1.5x + 5.38.…

A: Rearrange the equation of energy:

Q: peak potential difference in a single cyclic voltammetry curve is 58 mV, this indicates that

A: Answer ; The Charge transfer reaction uses one electron .

Q: Q4. Coulometry requires 100% current efficiency. What does this mean? a. Capacitive current b.…

A: Coulometry is the quantitative determination of any substance that can be made to undergo an…

Q: Which one of the following is correct? Select one: 0 a. Controlled potential means the potential…

A: a) Controlled potential means the potential difference between counter electrode and working…

Q: Throughout this unit, you have conducted a research project into an electrochemical object of your…

A: Standard alkaline batteries, ubiquitous in our daily lives, are a staple power source for countless…

Q: Calculate the moderating power and ratio for pure D:0 as well as for D:0 contaminated with 1% H;0.

A: Moderation is the process of slowing neutrons in a nuclear reactor so that they can easily promote…

Q: Indicate the half-reaction occurring at the cathode. Express your answer as a chemical equation.…

A: Oxidation: It involve increase in the oxidation number Reduction: It involve decrease in the…

Q: In a reaction involving the iodination of acetone, the following volumes were used to make up the…

A: Information of question

Q: can cyclic voltammetry be used to study irreversible reactions? provide an example

A: The objective of the question is to understand if cyclic voltammetry can be used to study…

Q: 13. What is the difference between a primary cell and a secondary cell? Which type of cell would you…

A: Types of cells:

Q: Part A: Electrochemical Cell Mass Data for Electochemical Cell Copper Zinc Initial mass of strip…

A: Hello. Since your question has multiple parts, we will answer part A for you. If you want residual…

Q: 1. An example of a nonfaradaic electrochemical process is a. corrosion b. electrodeposition c.…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: What is the concentration of ClF in the water sample?

Q: What is the mechanism in gel electrophoresis, why is an acidic solution more positive and a basic…

Q: 1. The lower the rate of a reaction the longer it takes to reach completion. 2. Slow reactions can…

A: Rate of the reaction define the velocity of reaction means how fast or slow the reaction process.

Q: The oxidation of o-dianisidine (o-DIA) is electrochemically reversible and involves the transfer of…

Q: If a pH electrode is experiencing the sodium (alkaline) error... A. the apparent pH will be lower…

A: We have to find out the pH when the pH electrode experiences sodium(alkaline) error.

Q: 4. Compare the copper 2+ ion concentration in the eluent after 15 and 30 minutes to the copper 2+…

A: IntroductionSingle Pass Recovery is a term used in computer science and data recovery to describe a…

Q: For an electrochemically reversible redox process at a DME, why is the resulting AC polarogram peak…

A: AC polarogram is the technique in which a small alternating current voltage is superposed on onto a…

Q: Copper materials with a total surface area of 50 m2 of 10 m2, covered with 7-micron silver only in…

A: Given: copper material with 50 m2 of 10 m2 Acids: H2SO4, HNO3, HCl

Q: What element makes up the electrode in the Hoffman apparatus? O carbon O lithium O platinum O copper

A: A Hofmann voltameter is an apparatus for electrolysing water invented in 1866. It consists of three…

Q: The oxidation of o-dianisidine (o-DIA) is electrochemically reversible and involves the transfer of…

Q: The table below lists data for a series of iodine clock reactions run by an actual student in Fall…

A: For a general reactionThe rate law can be given aswhere 'k' is the rate constant, [A] and [B] are…

Q: a. Why dyes cannot be used in the place of pigments? b. What will happen if ITO or FTO is not plated…

A: a) Dyes cannot be used in the place of pigments.

Q: ) Find the cell constant. Blank 1. Fill in the blanks, read the relevant. Blank 2. Fill in the…

A: We have to find cell constant, conductivity and specific conductivity of acetic acid

Q: Which of the following statements about flame ionization detector (FID) is not true? O A. FID…

A: FID (Flame Ionization Detector) is a chromatographic instrument used for the analysis of any organic…

Q: Write equations for the reaction of each compound with BF3 a Lewis acid Q.CH3CH2SCH2CH3

A: Given is the Lewis acid that is BF3. That means BF3 is an electron pair acceptor. And in substrate…

Q: Show your work in details: Cu2+ unknown concentration can be analyzed by electrogravitic analysis…

A: Mass of the electrode before starting the reaction = 0.5559g Mass of the electrode after the…

Q: What are the advantages of using ICP torches over other atomization methods?

A: The ICP's capacity to efficiently and reproducibly vaporise, atomize, excite, and ionise a variety…

Q: Is standardization against primary standard required for electrogravimetry using two electrode…

Q: Task 3: In the following problems, you will need to identify the real metals in the electrochemical…

A: In an electrochemical cell, the reactions take place at the two electrode placed in the cell that…

Q: 2. Considering your response to Question 1, as well as other data in your table from Part 1 and 2,…

A: As the reaction proceeds, [Zn2+] in the anodic compartment increases as the zinc electrode…

Q: Capillary electrophoresis was conducted at pH 9, at which electroosmotic velocity is greater than…

A: The electrode which has more positive decrease potential will go about as a cathode and will go…

Q: Give 10 applications of Photoconductive cells

A: Photoconductive cells- It is a light sensitive semiconducting device and has electrical conductivity…

Q: How can you tell from a cyclic voltammetry graph if the system is freely diffusing or adsorbing onto…

A: Randel-Sevick Equation describes the dependance of peak current on scan rate, for an…

Q: Ag/AgCl electrode can not be used as reference electrode to measure Ksp of AgI because a. Its…

A: Please find your solution below : For any electrode to work as reference electrode, it has to be…

Q: Cyclic voltammetry was used to measure the peak current at several different scan rates for the…

A: For the reversible reaction, Sn(IV) Sn(II)Given that:Concentration of the reactant = 4.96 mMArea of…

Concept explainers

Potentiometric Titrations

Potentiometric titration is one of the important titration methods and is mainly carried out to characterize acid solutions. It follows a method similar to that of the normal titration technique, but the main difference is that there is no indicator used in the potentiometric titrations. Instead of using an indicator, electrodes are employed for monitoring the whole titration process. A scientist named Robert Behrend did the potentiometric titration for the first time, and it was done using the mercurous solution and potassium chloride.

Question

with 12. What ion is oxidized and what ion is reduced'?
In this experiment, why do we generate 12 electrochemically in situ rather than
adding a known weight or volume?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Describing given information

VIEW

Step 2: Explaining reasons for situ

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Please help with this question. It's a question under electrochemistry.
Pls help ASAP. Pls show all work and caluclations.
Two Copper strips were used to determine the effect of supporting electrolyte used on the change in mass. Three different experiments were conducted for 5mins where 0.5A current is applied throughout the experiment. In the first experiment two copper strips were immersed in 3.080g of Cu (NO3)2 dissolved in 25mL of DI water and tested for 5mins while applying current 0.5A. The weight of one copper strip act as an anode is taken before the reaction and after the reaction to calculate the change in mass due to different applied current. Same process is repeated with 25ml 0.5 M CuSO4 and25ml 0.5 M CuCl2 for 5 mins Using Faraday’s equation (Eq 1), calculate the theoretical mass and Compares the theoretical mass (mg) of copper and the actual mass deposited (obtained from the electrolysis, ∆m) by calculating the %error at different times. Discuss the observed results. Q = I x t = nFN Electrolyte Initial mass of anode (mg) Final mass of anode (mg) Cu (NO3)2 2941 2893…
Please help me answer 4. Answer on bracket. Thank you.
please answer fast
Hi, I need help with this step-by-step please thank you.
A corrosion cell is made of Zn anode electrode (EO-0.762 V, p-0.1 V and ig-10 mA/cm) and a hydrogen electrode on metal M surface (M-NI, Eo-0V and p-01 V). Determine the corrosioe rate of Zn electrode in mA/em [enter only the value without the unit in decimal format, eg 3.405, 0.123,0.00012 etc] Metal M Zn Zn2+ H* Anode Zn Electrode Hydrogen Cathode Electrode 12
A plot of current (amperes) versus the square root of scan rate (volts/sec) for the ferricyanide/ferrocyanide (n=1) reaction give a slope value of 0.0001257. The electrode diameter is 1.5 mm. The concentration of ferricyanide is 10 mM. Calculate the diffusion coefficient in cm2/sec.
What is the dimension of a chlorine contact chamber if the CT value is 150mg-min/L at the chlorine concentration 0f 5.0 mg/L. Give the width lengthand depth. Show all work.
help please answer in text form with proper workings and explanation for each and every part and steps with concept and introduction no AI no copy paste remember answer must be in proper format with all working
I want handwritten solution of all the parts...i will upvote
If you had a mixture of proteins with different sizes, shapes, and charged and you separated them with electrophoresis, which proteins would move fastest toward anode (positive electrode)?