In the structure shown, a 6-mm-diameter pin is used at C, and 10-mm-diameter pins are used at B and D. Knowing that the ultimate shearing stress is 150 MPa at all connections and that the ultimate nomal stress is 400 MPa in link BD, determine the allowable load P if an overall factor of safety of 3.0 is desired. Note that link BD is not reinforced around the pin holes. Front view 18 wm Side view 160 mm 120 mm Cy Top virw

Q: Learning Goal: To determine the in-plane principal stresses and maximum shear stress along with…

A: Step 1: Step 2: Step 3: Step 4:

Q: Fatigue angle in Failure (record number of cycles before failure) Large Metal Paperclip Small Metal…

A: 1.Small metal subjected to a large number of the cycle before failure this is because metal has…

Q: A 4.8 m long from fixed point, 0.5 m wide and assumed a thickness of 30 mm throughout a springboard…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: You have 4 springs, each being 3.5, 6, 8.5, 11 N/m What's the smallest stiffness you can make using…

A:

Q: A) An engineer works for a company that has many gray cast iron rods of different diameters and…

A: Given :Load P = 10 kip Material : grey cast iron

Q: Q1: Find a relation between true strain () and reduction in area (r)?

A:

Q: Question 5 Answer the following questions concisely (no more than half a page per question): a What…

A: Since you have posted a question with multiple subparts, we will solve first three sub parts for…

Q: P=? 1200 lb 7777 If the coefficient of friction is 0.28, determine the force, P, necessary to cause…

A: Given, In first case, Weight of block is given 1200 lb and coefficient of friction is 0.28, it is…

Q: Q8) A wire of a perfectly plastic material has a starting diameter of 3 mm. Assume no friction and…

A: Given   Initial diameter, D = 3 mm     Final diameter, d = 1 mm Find  Number of passes, N

Q: Given the following stress-strain graph: a. is the modulus of elasticity of "A-514" greater, less or…

A: (a): the modulus of elasticity of A-514 is same asA-572 because the slope of initial stress strain…

Q: 10.19. An electrical-resistance strain gage records a strain of 400 µm/m on a steel tension member.…

A:

Q: Determine the maximum normal stress, the maximum shear stress, the Modulus of Elasticity, the…

A:

Thermal Properties of Materials

In mechanical engineering, the thermal property is represented as the physical quantity that is relevant to the application of heat. The thermal properties are evaluated by variations in any specific material due to low heat or high heat. The quantities that influence the thermal property of the materials are mass, density, temperature, and many others.