Answered: In the RL circuit shown below, it takes… | bartleby

Related questions

Question

In the RL circuit shown below, it takes 1.5 seconds after the switch is closed for the current to reach half of its steady-state value.

If the inductor was replaced with an inductor with twice the inductance and the experiment was run again from the beginning, how long would it take for the current to reach half of its steady-state value?

20V
eu

Expert Solution

Step 1

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

It has been proposed to use large inductors as energy storage devices. (a) How much electrical energy is conerted to light and thermal energy by a 150W light bulb in one day? (b) if the amount of energy calcuated in part (a) is stored in an inductor in which the current is 80.0 A, what is the inductance?
Inductors in series. Two inductors L1 = 1.13 H and L2 = 2.01 H are connected in series and are separated by a large distance so that the magnetic field of one cannot affect the other. (a) Calculate the equivalent inductance. (Hint: Review the derivations for resistors in series and capacitors in series.Which is similar here?) (b) What is the generalization of (a) for N = 13 similar inductors L = 3.02 H in series? (a) Number i 0.72334 Units H (b) Number i 0.2323 Units H
An inductor consists of 100 turns of wire tightly wound about an insulating core. It is attached to a power supply and when the current through it is increased from 0 to 5 A in 3, s an induced emf of 5 V is measured. Find the inductance of this device and the magnetic flux and the energy stored in the magnetic field when the current is held steady at 5 A.
A loop of wire has a self-inductance of 5.5 mH. You pass a current of 9.0 Amps though the loop, and then drop the current to 0 at a contastant rate over 3.5 seconds. What is the EMF generated?
An electric current contains a battery that produces a voltage of 60 voltsV , a resistor with a resistance of 13 ohms, and inductor with an inductance of 5 henrys H  . Using calculus, it can be shown that I I t    (in amperes, A), when t seconds after the switch is closed is 13 5 60 1 13 t I e          1.4.1 Use this equation to express the time t as function of the currentI 
A 12.0 V battery is connected into a series circuit containing a 20.0 resistor and a 1.50 H inductor. (a) In what time interval (in s) will the current reach 50.0% of its final value? S (b) In what time interval (in s) will the current reach 90.0% of its final value? S What If? After a very long time, using a switch like that shown in the figure below, the battery is removed and the inductor is connected directly across the resistor. R Są ob ก ε ele (c) In what time interval (in s) will the current decrease to 50.0% of its initial value? S (d) In what time interval (in s) will the current decrease to 10.0% of its initial value? S
(a) If an inductor carrying a 1.95 A current stores an energy of 0.250 mJ, what is its inductance? Answer in mH (b) How much energy does the same inductor store if it carries a 3.1 A current? Answer in mJ
In the circuit shown in the Figure with 3.0 mH for the inductance and 6.0 uF for the capacitance, S1 has been closed for a long enough time so that the current reads a steady 3.50 A. Suddenly, S2 is closed and S1 is opened at the same instant. What is the maximum charge that the capacitor will receive? What is the current in the inductor at this time? At an instant when the charge on the capacitor is 0.1 mC, what is the current in the inductor? At an instant when the charge on the capacitor is 0.1 mC, what is the rate at which the current in the inductor is changing?