In the liquid storage tank shown in the figure, q1s=10cfm, q2s=5cfm, hs=4ft. A pump is used to extract the liquid at a constant flow rate. (a) Find the transfer function G(s)=H(s)/Q1(s).

Q: Bernoulli pump vertical piping

A: Step 1: 1. Calculating Volumetric Flow Rate (ft3/s): Given,Flow rate at P1 & P2 is same: 14 gpm1…

Q: P.15.10 A control valve is used to control the flow of water to a cooling coil. The characteristic…

A: Given, maximum flow rate is 150 gpm.At normal conditions, Fraction of maximum flow is given byThus,…

Q: 4. Consider the tank illustrated below where the density if the fluid is p. The resistances R₁ and…

A: According to question we have figure Where ρ-density qmi-inflow rate R1 and R2-Linear resistance…

Q: Q23:- In hydraulic power generation process, water at 30 psia is falling from an elevated point at a…

A:

Q: Q4/I Answer two of the following: AI Derive an expression for the degree of reaction for axial…

A:

Q: 1.1. A process liquid is pumped from a storage tank (P1) to a distillation column (P2) using a…

A: The Total Dynamic Head (TDH) is the total equivalent height that a fluid is to be pumped, taking…

Q: A capillary tube has an 8mm inside diameter through which liquid fluorine refrigerant R-11 flows at…

A: The objective of the question is to find the required velocity in the model for dynamic similarity…

Q: FLUID DYNAMICS The pipeline have (QA = 15 L/s), (QB = 3QD), (DA=100 mm), (DB= Dc = 25mm), (Dp= 50…

A:

Q: Determine values for A and R from the step response

A:

Q: (b) Show with the Rankine-Hugoniot conditions that the change in specific enthalpy is given by: Ah =…

A: In thermodynamics, enthalpy is described as a thermodynamic quantity equivalent to the total heat…

Q: Problem 1 (50%) Two empty tanks of the same size (Area = 5m², Height = 10 m) are arranged as shown…

A:

Q: . what is the convection coefficient of the liquid?

A: given that A liquid flows inside 3 cm diameter pipe,d = 3 cm L =5 m Ti = 350 C. Twall =575 C mass…

Q: An anaerobic biofuel production process is carried out in a 10,000-L stirred tank with a diameter of…

A: Given that, The volume of the tank = 10000 L Diameter of the tank Dt = 2 m Agitation rate N = 100…

Q: At section 1: A1=10ft2 , Velocity 1 = 100fpm, v1= 4ft3/lbm. At section 2: A1=2ft2, Velocity 2 =…

A: We need to find Mass flow rate at section 1

Q: Consider a liquid flow system that includes a sealed tank carrying non-condensable gas over the…

A: A sealed contains liquid and non-condensable gas over the liquid. Height of the liquid in the tank =…

Q: A mixture is the overhead of a distillation column and it is liquefied in the overhead total…

A: Installing a control valve on the overhead line leading to the total condenser of a distillation…

Q: A municipal wastewater treatment plant has an average flow of 0.5 m3/s, and two aerated grit…

A: Given, average flow of wastewater, Qavg = 0.5 m3/s Calculate the peak flow as follows: Qpeak =…

Q: A pilot plant reactor, a scale model of a production unit, is of such size that 1 g charged to the…

A: here, the scale factor f = 5001/3 = 7.93Reynold's number, Re = Power input, P = where, n = turbine…

Q: Q: The working fluid, in a steady flow process flows at a rate of 220 kg/min. the fluid rejects 100…

A: Given data: Fluid flowrate=220kg/min Heat reject is 100kJ/s   Inlet outlet Velocity (m/s) 320…

Q: Problem 3. The head loss (ft) in a piping system is represented by the equation H, = 50 + %3D 6.0…

A: The equation for the head loss in the piping system is given as: Hs=50+6.0Q1002+Hv…

Q: Two liquid storage systems are shown below. Each tank is 1.2 m in diameter. For System I, the valve…

A:

Q: b. A wastewater stabilization tank with a cross-sectional area A (m²) is being filled up with a…

A: Consider the below diagram for the wastewater stabilization process taking place.

Q: Q.10Calculate the increase in enthalpy of water in the system as in figure below, where zı=10 ft,…

A: The increase in enthalpy is obtained from the steady flow energy equation. The steady flow energy…

Q: Q28:- Water is being pumped at a rate of 0.5 ft'/sec from a storage tank to a certain exit point of…

A:

Q: Q) Two liquid storage systems are shown in the figure below .Each tank is 4 feet in diameter.For…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Q 3. A single tank process is operating for a long period of time and the inlet flow rate q; is 30.4…

A: single tank process inlet flow rate qi=30.4 ft3/min on increasing flow rate by 10% there is change…

Q: Q3 ( The present study concerns a process in which a liquid is transferred from a storage tank to a…

A: Approach to solving the question: Detailed explanation:  Examples: Key references:

Q: QUESTION-1) The cooling power of an air conditioner (refrigeration machine) is given as 6 kW and the…

A: Given:The coefficient of performance for the refrigeration system is given as COPSM = 4,The cooling…

Q: 3. Chapter 4: Water is steadily flowing through a three-way connector in the Figure. It enters the…

A:

Q: How did they get these answers?

A: To understand how these answers were obtain, we need to go through the calculations step by step.…

Q: A differential manometer is used to measure the drop in pressure across a filter at a water…

A:

Q: Q 3. A single tank process is operating for a long period of time and the inlet flow rate qi is 30.4…

A:

Q: P.15.7 Water is pumped at a rate of 200 gpm through a control valve which has a pressure drop of 30…

A: To solve above problem, we will use the equation for the pressure drop across a control valve :ΔP is…

Q: Consider the following specific information: ⚫ There is a constant 500 L volume in the tank. The…

A: Since you need d-f, solve d-f.To find:d. The numerical values of Ks, p, and TP..e. Graph the…

Q: P.15.6 A control valve of C₁ = 19 is connected in series with a cooling coil. The total pressure…

A: Valve coefficient is given. Total allowed pressure drop across the valve and coil is We know density…

Q: A CSTR is to be operated for 30 minutes with multiple flowrates of one of the input streams. For the…

A: Given data: A CSTR is operated for 30 minutes with multiple flow rates of one of the input stream.…

Q: In a tank heater with agitator, the tank outlet temperature (T) and the heater connected to the tank…

A:

Q: Suppose the real system consists of a closed water tank (closed tank), as shown in the figure below.…

A:

Q: Given all the conditions in the problem and given a flowrate of 0.11 cubic meter per second, what is…

A:

Q: Consider single-phase fluid flow in a 1-D horizontal reservoir. The reservoir is discretized using…

A: The Dimensions of the reservoir are given as Ax = 250 ft,  W= 900ft h = 100 ft Permeability kx = 270…

Q: Consider a perfectly mixed stirred tank heater with a single feed stream and a single product stream…

A: density, Cp = 4184 J/kg.KTi,s = 200C = 293kT,s=400C= 313kvoulme = 500LFlow rate = 100L

Q: 7. A pump is pumping water at 50 gal/min; P= 70 psi. The efficiency of the pump is 0.73. Compute the…

A: Given that 7.Q=50 galminP=70 psi npump =0.73