Answered: In the figure, water flows through a… | bartleby

Related questions

Question

In the figure, water flows through a horizontal pipe
and then out into the atmosphere at a speed v₁ =
14.0 m/s. The diameters of the left and right sections
of the pipe are 5.10 cm and 3.00 cm. (a) What volume
of water flows into the atmosphere during a 10 min
period? In the left section of the pipe, what are (b)
the speed v₂ and (c) the gauge pressure?
V2
V2
dą
d₁

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

To verify her suspicion that a rock specimen is hollow, a geologist weighs the specimen in air and in water. She finds that the specimen weighs twice as much in air as it does in water. The density of the solid part of the specimen is 3.96 × 10³ kg/m³. What fraction of the specimen's apparent volume is solid? Number i Units
We’ve discussed elevators that are raised with cables, but many elevators use pistons. A pump provides fluid at very high pressure to the piston; the resulting force on the piston raises the elevator and passengers. For a typical piston elevator, the mass of the elevator and passengers is 2000 kg and the radius of the piston is a surprisingly small 4.2 cm. The elevator begins to move upward, accelerating at 0.80 m/s2. What is the pressure in the piston?
The drawing shows an intravenous feeding. With the distance shown, nutrient solution (p = 1040 kg/m³) can just barely enter the blood in the vein. What is the gauge pressure of the venous blood? Express your answer in millimeters of mercury. Number i Units Atmospheric pressure > en 0.610 m
A container filled with water and there are two holes, as shown in figure below. What is the ratio of x1 to x2? 20 cm 100 am 50 cmB X1 X2 13. Given frictionless flow of water at 125.6 ft'/s in a long, horizontal, conical pipe of diameter 2ft at one end and 6ft at the other. The pressure head at the smaller end is 18ft of water. Find the velocities at two ends and the pressure head at the larger end.
The gauge pressure at the bottom of a cylinder of liquid is pg = 0.40 atm. The liquid is poured into another cylinder with twice the radius of the first cylinder. What is the gauge pressure at the bottom of the second cylinder?
At a given instant, the blood pressure in the heart is 1.1 x 104 Pa. If an artery in the brain is 0.38 m above the heart, what is the pressure in the artery? Ignore any pressure changes due to blood flow. Number Type your answer here Units Choose your answer here
X A 1m tall cylinder is filled with half water and half oil. What is the total pressure (in Pa) at the base of the cylinder? Density of water is 1000 kg/m^3 and density of oil is 900 kg/m^3. * 40,000 5,000 9,000 9,500 Correct answer
Water is flowing through a horizontal pipe of varying cross-section. At section 1, the diameter Is 12.0 cm at a pressure of 8.0 x 10^4 Pa. At section 2, the pipe has a diameter of 6.0 cm and the pressure 6.00 x 10^4 Pa. Find the speed of water through sections 1 and 2 in m/s.
Water (density = 1 x 103 kg/m³) flows at 10 m/s through a pipe with radius 0.030 m. The pipe goes up to the second floor of the building, 2.0 m higher, and the pressure remains unchanged. What is the radius of the pipe on the second floor? 0.018 m 0.026 m O 0.034 m Ⓒ 0.042 m
A liquid-filled tube called a manometer can be used to measure the pressure inside a container by comparing it to the atmospheric pressure and measuring the height of the liquid. Such a device (filled with water) is shown in the figure, measuring the pressure inside a balloon filled with an unknown gas. The water level on the side of the manometer which is open to the air is 12.2 cm higher than on the side connected to the balloon. a. Find the gauge pressure in the balloon, in units of Pa. Recall the density of water is 1000 kg/m3. b. Find the absolute pressure in the balloon, in units of Pa.