In the figure shown, If ve=500 mm/s, solve for the (a) velocity (in m/n) of D and (b) the angular velocity (in rpm) of AB. 320 mm C 100 mm 100 mm 240 mm Select the correct response(s): 1.33 5498.18 14.47 0.95 1527.27 3436.36 4810.91 9.04 1.52 1336.36 954.56 12.66

Q: Why is drainage clogging occur?

A: 1)Damaged Pipes-Another major cause of blocked drains is broken pipes. For water to flow freely, it…

Q: What type of potable water distribution system is used in large multistory buildings?

A: To determine: What type of potable water distribution system is used in large multistory buildings?

Q: Define emission factor?

A: Emission Factor An emission factor is a representative value that attempts to relate the quantity of…

Q: Define Gas sampling.

A: Gas sampling is a method by which the chemical, thermal, and hydrological properties of a surface or…

Q: Define Air-handling equipment.

A: Air-handling equipment is defined as the equipment that is used to regulate the temperature of the…

Q: 1. Locate the centroid (£, 9) of the shaded area. 6 in. 3 in. 6 in. 6 in.

A: We are supposed to answer the only the first question, Kindly understand and post other question…

Q: A restroom should be located within 400 feet of every permanent workstation

A: Maximum distance is 400 feets ... Maximum of above or below 1 floor in case of building..

Q: The figure shows layers of soil in a tube that is 100mm x 100mm in cross – section. Wate supplied to…

A: H1=150mm =15cm H2=150mm =15cm H3=200mm =20cm A=10*10= 100cm2

Q: disscuss the following items in relation to plumbing system: a. supply pipe b. fixture c.…

A: Supply Pipe: A supply pipe is used to convey water or sewage from the source of generation to the…

Q: A building has an area of 16656 ft2. What is the minimum number of roof drains required?

A: The area of the building = 16656 ft2 We need to calculate the minimum number of drains required.

Material Selection

A wide variety of engineering applications make use of different materials, depending upon their usage. The materials used in civil engineering vary in their properties such as strength, ductility, brittleness, and creep strength. Depending upon the application and external loading conditions, an engineer must make a wise decision for material selection. A wrong decision would fail in its functionality.