In the figure shown, find the y-coordinate or the distance y of point A so that the 400 N force will have a clockwise moment of 560 N about point O. Y-axis - X=3m A F = 400 N y=? X-axis

Q: Question 3 [Soalan 3] Determine the moment produced by the F1 forces about point O. Express the…

A:

Q: Problem 4 In the frame here, Calculate the reaction forces D₂, Dy and also the forces and moment in…

A:

Q: c) the value of the maximum bending moment in the beam. Enter your answer in kNm to three decimal…

A: a simply supported beam is loaded as followsa=b=5mE=200GPaq=5kN/m

Q: ..A force is specified by the vector F = 1201 + 160j +80k lb. Calculate the angles made by F with…

A:

Q: 1. In picture on the right, let's say that F₁ = 400 N, F₂ = 560 N & F3 = 280 N. a) Divide all forces…

A:

Q: Replace the force system acting on the frame by an equivalent resultant force and a couple of moment…

A: Data given Find (a) Determine the magnitude of the resultant force. (b) Determine the angle between…

Q: The force F = {-100i+200j +200k} N. The moment of F about the line from O to A is MOA = {470i +315j…

A: Objective: To determine the direction cosines for the position vector rA/O.   Given:…

Q: 5kip 51 51

A:

Q: A force P of magnitude 520lb acts on the frame shown at point E. Determine the moment of P about a…

A: So, the coordinate are  (0,15,0) (30,0,10) (30,0,20)

Q: A beam is subjected to concentrated force as shown in the figure below. The EI of the entire beam…

A: A propped cantilever beam of span 15 ft, propped at C and fixed at A. A point load of 36 kips is…

Q: Given P1 = 823 N and P2 = 108 N calculate the moment in the x direction

A: Question is based on the section . Loading condition on section are given in the question . Moment…

Q: A beam is subjected to force as shown in the figure below. Try to analyze the reaction force of the…

A: Solution: Using the moment distribution method: Fixed end moments: Span AB: MFAB=-wl8=-30×168=-60…

Q: 70 lb/ft 35 lb/ft 35 lb/ft 580 ft - Ib 2.9 ft 2.9 ft B.

A:

Control Survey and Geodetic reductions

Control surveys or survey controls are used to establish reference points as a basis for various construction activities. Vertical and horizontal control points are to be established in a control survey to increase accuracy. After establishing the control points, all other types of surveys such as topographic, right-of-way, aerial mapping, construction layout, boundary surveys, and utility mapping can be worked upon so that control networks can be formed. The place from which the observations are made is called a survey station.