In the figure below, a joint is made by gluing two plywood gussets of thickness t to wood boards. The tensile working stresses are 1245psi for the plywood and 725psi for the boards. The working shear stress for the glue is 52psi. 1.95 in P 6.25in Determine the dimension b so that the joint is as strong as the boards. inches in 2 decimal places

In the figure below, a joint is made by gluing two plywood gussets of thickness t to wood boards. The tensile working stresses are 1245psi for the plywood and 725psi for the boards. The working shear stress for the glue is 52psi. 1.95 in P 6.25in Determine the dimension b so that the joint is as strong as the boards. inches in 2 decimal places

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Give the formula for the tensile and shear strength of the weld joint. Explain the various terms in each of the equations
Determine the force in bars BD, CD, and DE of the nacelle truss shown below. Indicate whether tension or compression. Given-Required-Solution format
Get all the froce using method of joints.
I need solutions for those problems
Determine the forces in all members of the truss shown in the figure. Indicate whether in tension or compression. Use the method of joints. only HANDWRITTEN answer needed ( NOT TYPED)
three decimal places, thanks
Use method of joints to determine the force in members and state whether they are intension or compression
The beam shown is constructed by joining two pieces of wood together using screws. If the resistant shear force of each bolt is Ft , determine the maximum allowable spacing s between the bolts. "cte" means constant "ambas piezas" means both pieces "sección trasversal" means cross section.
C. Determine the area of reinforcing steel required for the isolated T beam shown it f' = 30 MPa, fy = 420 MPa. -effective width = 1400 mm- 70 mm 800 mm 730 mm M₂ = 1100 KN-m
2. From the truss shown below, determine the stresses in all members using method of joints and check by method of sections. 4 KN 4KN E 4KN 4KN 4KN F 3.5m 2KN R₁ 4KN J 12m 4KN 2KN *I- + D. H
Use American code
The truss is suppored by a pin in point A and a roller at point F. Show your FBD