In the circuit, v₁ and v2 are AC sources with = 100 rad/s. The phasor diagram shows the phasors of v₁ and v₂. It is not drawn to scale. You may assume the system is in steady state. V3 is a DC source. (a) What is v₂ () where T is the period of the waveform? (b) What is the waveform ia(t)? (c) What is the maximum value of the waveform va(t)? V3 1 + a| 3 L V₁ + C Va V2 V₂ Im α- V₁ να Re |v1|: |V2|: alpha: V3: C: L: 2 V 3 V 30 degrees 3 V 10 mF 25 mH

Q: XMM1 R1 A R2 20 60 V2 R3 40 V1 6V 12V B Find the voltage across R3 due to the 12V source. Round to…

A:

Q: If Vin is a source with a 10V sinusoidal signal of 10kHz, R is 500Ω, and C is 0.05µF what will the…

A: The solution is given below.

Q: A sinusoid with amplitude 8 has a minimum value of 9 . What is its maximum value?

A: We need to find out maximum value of given sinusoidal signal.

Q: Question. The figure given below is a plot of a sinusoidal wave. From the plot, determine values for…

A:

Q: Describe how a complex wave is produced from sinusoidal waveforms. Give an example to demonstrate…

A: Harmonics are unwanted high frequencies that interfere with the fundamental and create a distorted…

Q: Write equations for the waveforms of Figure. Express the phase angle indegrees.  Here the answers…

A: Step 1: Step 2: Step 3: Step 4:

Q: Find the area of the sinc(t).

A: The area of any function can be determined by integrating the function from the negative infinity to…

Q: Find the RMS value of the foll owing waveform, (t) which is an offet Cosine wave. 4V

A: This waveform is a shifted waveform which is shifted toward positive Y axis with 2 units. SO the…

Q: Write equations for the waveforms of Figure. Express the phase angle indegrees.  Here the answers…

A: Step 1:

Q: Waveform A Waveform B Given the drawing above, the phase shift between Waveform A and Waveform B is:…

A: Given waveform Asked ti find the phase difference or phase shift between A and B?

Q: QUESTION 2 ow many address lines are used in the entire sys elow? Type out the number, for example:…

A:

Q: Create a sinusoidal function that has an amplitude of 4, minimum at 2 and horizontal phase shift of…

A: In this question we will find sinusoidal function...

Q: Write equations for the waveforms of Figure. Express the phase angle indegrees.  Here the answers…

A:

Q: A pure sinusoidal waveform with a period time or 0.02, has a frequency of 50Hz, define the angular…

A: The objective of the question is to calculate the angular frequency of a sinusoidal waveform given…

Q: in the image given, Does the waveform of each pair do actually meet in the x-axis? Where to they…

A: From the observation, we can note that three waveforms (yellow, red and green) are sinusoidal with 0…

Q: Write equations for the waveforms of Figure. Express the phase angle indegrees.  Here the answers…

A: Approach to solving the question:Whenever a function [x(t)] is left shifted by "a" units then the…

Q: What is the phase relationship between the following waveforms? v = 10 V sin(@t + 60°) i= 2 mA…

A: Phase relationship

Q: Answer the following questions about complex waveforms: A. Define the complex waveforms. B. How can…

A: As per Bartleby policy we can not answer all parts at a time. I am answering first two parts for…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.