In the circuit shown, the switch S is closed at time t=0. a) Find the current in the 100 2 resistor immediately after the switch is closed. b) Find the current in the 10 fesistor immediately after the switch is closed. c) Find the current I in the inductor at the switch has been closed. T is a very long time after the switch has been closed

In the circuit shown, the switch S is closed at time t=0. a) Find the current in the 100 2 resistor immediately after the switch is closed. b) Find the current in the 10 fesistor immediately after the switch is closed. c) Find the current I in the inductor at the switch has been closed. T is a very long time after the switch has been closed

Similar questions

In the figure below the switch S is closed, Supppose the emf of the ideal battery is 12.0 V, the inductance of the ideal inductor L = 30.0 mH, and the resistance R2 = 4.34 ohms and the resistance R2 = 2.17 ohms. When i = 0.17 A 1. how much energy is delivered by the battery? 2. how much of this energy is stored in the magnetic field of the inductor? 3. how much of this energy is dissipated by both resistors? 4. what is the rate dibat/dt at t = 0, t = 0.82 s and t after a long time?
When the current in a solenoid uniformly increases from 3.0 A to 8.0 A in a time 0.25 s, the induced EMF is 0.50 volts. What is the inductance of the solenoid? a. 25 mH b. 40 mH c. 30 mH d. 35 mH e. 20 mH
In the figure, a 140-turn coil of radius 3.3 cm and resistance 6.9 Q is coaxial with a solenoid of 240 turns/cm and diameter 4.1 cm. The solenoid current drops from 1.7 A to zero in time interval At = 28 ms. What current is induced in amperes in the coil during At? Coil Solenoid Number i Units
The switch in the circuit shown is closed at time t = 0. a) At what rate is energy being dissipated asheat in the resistor after an elapsed time equal to the time constant of the circuit? b) Calculate the rate at whichenergy is being stored in the inductor at this time. c) What is the total energy stored in the inductor at this time?d) How long a time does it take the current to reach 70 percent of its maximum value?
Just after the switch is closed, what is the magnitude of the potential difference vabvab across the resistor R1? What is the magnitude of the potential difference vcdvcd across the inductor L? The switch is left closed a long time and then opened. Just after the switch is opened, what is the magnitude of the potential difference vabvab across the resistor R1? What is the magnitude of the potential difference vcdvcd across the inductor L?
A 2.4 Henry inductor is connected in series with a 12.0 Volt direct current battery, a 6.0 Ohm resistor, and a switch. The switch is open so no current is flowing in the circuit. Explain what happens to the current once the switch is closed. Intelligently use "Faraday's law" and "Lenz's law" and "time constant" in your explanation. Describe what a graph of current versus time would look like, what it's value would be at time = 0, and what its value would be after a very long time.
4.) In the circuit shown, the initial voltage across the 10 microFarad capacitor is 12V. The solenoid has an inductance of 0.7 H. There is no resistance. a) Find the charge on the capacitor 1.0 millisecond after the switch S is closed. b) At what time will the current in the solenoid reach its maximum value? c) What is the maximum energy stored in the magnetic field of the solenoid?
Coil A is a large 300 turn circular coil of radius 77 cm. Circular coil B has 390 turns, a radius of 5 cm and is located L=99 cm from coil A along the same axis. The planes of the two coils are parallel. A) Find the approximate mutual inductance of this pair of coils. for my answer I got 3.527E-10 H which was wrong B) If the current in coil A varies with time according to I=3t3−8t2−1, where I is in amps and t is in s, find the magnitude of the EMF induced in coil B at time t=2 s.
ew Policies how Attempt History Current Attempt in Progress Your answer is partially correct. A solenoid having an inductance of 6.05 µH is connected in series with a 1.17 k2 resistor. (a) If a 18.0 V battery is connected across the pair, how long will it take in seconds for the current through the resistor to reach 80.7% of its final value? (b) What is the current through the resistor at a time t = 1.00TL? (a) Number (b) Number 8.504 Hint 9.72E-3 eTextbook and Media Units times Units A Save for Later Last saved 1 hour ago. Saved work will be auto-submitted on the due date. Auto- submission can take up to 10 minutes. + + Attempts: 2 of 4 used ditv MacBook Air 8 Submit Answer DII F9
The switch K in the circuit shown in the figure is open, and there is no current in the coil. At a given moment we close the switch. a) Find the current and the voltage of the resistors and the coil right after the close of the switch. After waiting until the current becomes constant in the circuit, we open the switch. b) Find the current and the voltage of the resistors and the coil right after the open of the switch.