In the CDMA system the receiver receive the information from the channel and need not to regenerate the information again.

Q: Consider a garden house where the radio channel TRT Radyo 4 is constantly open has an installed…

A: The power consumption of the radio is given and the average usage time is

Q: Choose the false statement. a. In SCR the gate is the controlling terminal b. SCR are used for…

A: we will consider the each statement as follows a) gate controlled device means device is controlled…

Q: this represents an OLTC system, taken from the matlab program, explain what the elements used are,…

A: A 25 kV distribution network consisting of three 30-km distribution feeders connected in parallel…

Q: hich of the following can’t be included in data required for coordination study? A)X/R ratio B)MVA…

A: characteristic curves of the fuses and breakers are generally analyzed in the coordination study

Q: The FDMA channel carries phone circuit at a time. a) Ten b) Two C) One d) Several

A: FDMA stands for Frequency Division Multiple Access. Bandwidth of FDMA channels are relatively low.…

Q: The system y(t)=x(t)+A where A is a constant is linear time invariant nonlinear time variant O…

A: System is said to be time invariant when input is shifted by some to than output also shifted by…

Q: Write a function called numActiveOdd Bits() that will accept an 8-bit std_logic_vector as an input…

A: According to the question, we need to write VHDL codes.

Q: The video signal of the TV system uses frequency modulation. True or False 2. The unique operation…

A: In this question we will write about video signal of TV system and radio detector....

Q: In CE configuration which of the below terminal is common for both input and Output. a. All the…

A: In the CE configuration, The output is taken between the emitter and collector terminal.And the…

Q: A series circuit connected across a 200V, 60 hz line, consists of a capacitive reactance of 30 ohms,…

A:

Q: Explain the operation of the SCR on the forward-blocking region. Differentiate Switching Current Is…

A: For a silicon controlled rectifier (SCR), we need to explain the operation in the forward-blocking…

Q: A person is recording measurements from an analog data reader. During the first reading, he was not…

A: Since we are allowed to solve only up to first three parts of a question the below answer contains…

Q: 6. Build the following circuit and take a picture of it. Disconnect the power source. What did the…

A: Since you have posted multiple questions, we will solve the first question for you. If you require…

Q: Q1) The dynamics of a circuit is given as (D² + 2D + 10)y(t) = x(t) where x(t) = 4u(t) and y(0) = 1…

A:

Q: Simplify using kmap only text

A: Given equation is shown below:

Q: (a) Explain the main different between a 2-bit asynchronous counter and a frequency divider by 4…

A: Bartleby has policy to solve only first question. Reupload the question

Q: Find a JK-FF implementation of a 1-input (x), 1-output (z) clocked sequential circuit defined by the…

A: According to the question, for the given state diagram as shown below We need to design the logic…

Q: 1. Are the following statements correct or wrong? a) Thyristors are used only for low voltage, low…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Draw a 2x1 multiplexer block diagram. Create the status table. Find the simplest form of circuit…

A: Requirement:The block diagram of 2x1 multiplexer.Status table. The simplest form of circuit output…

Q: Does your data table verify Ohm’s law ?

A: Ohms law .: According to  ohms law current is directly proportional to the current flowing through…

Q: When the pinch-off voltage is exceeded, ID will ____ as VDD increases.   a. double   b.…

A:

Q: Which of the following statement is not true about Digital Transmission? a. None of the choices b.…

A: Digital transmission :  Digital transmission is type of transmission in which data is transmitted in…

Q: or phrase: also known as electrostatic coupling, can occur between the signal res in a measurement…

A: As per the honor code I will solve only first three questions. Kindly repost the other questions…

Q: These multiple choice question from DIGITAL COMMUNICATIONS course. just write for me the final…

A:

Q: BK PRECISION CRT COUPLING SOURCE TRIG LEVEL INTENSITY FOCUS AUTO CHI HOLD OFF POSITION AMORM CH2…

A: Function of CRO (Cathode Ray oscilloscope)

Q: The Vrms value is wrong

A: The question is about finding Vrms from the given waveform.

Q: Write the following acronyms in full and Explain it main function. 1. LCD 2. PWM 3. MHz 4. RFU…

A: SOLUTION LCD-     LCD is stand for LIQUID CRYSTAL…

Q: For the following activities, draw the network diagram and by using forward and backward pass,…

A: Given data is

Q: A balanced, positive-sequence, Y-connected voltage source with Eab = 480/0° volts is applied to a…

A: A balanced, positive-sequence, Y-connected voltage source with  is applied to a balanced- load with…

Q: 1. Are the following statements correct or wrong? (a) Thyristors are used only for low voltage, low…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 1. Illustrate IC 555 timer as Monostable Multivibrator and Astable Multivibrator

A: Solution- 1. IC555 as Monostable Multivibrator- A monostable multivibrator, sometimes known as an…

Q: When making an ECG measurement, it is important to measure voltage variations over small time…

A: ECG measurement uses the RC circuit, the voltage expression of the discharging RC circuit is shown…

Q: When the pinch-off voltage is exceeded, ID will ____ as VDD increases. remains the same…

A: Junction Field Effect Transistor(JFET): 1. The construction of JFET is very simple2. Two smaller…

Q: TLO 6 2 Use mesh-current analysis to find the branch currents indicated in the network shown below.…

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.