Answered: In series-connected ac circuit, the…

In series-connected ac circuit, the value of the equivalent admittance of the circuit is equal to the reciprocal of phasor sum of the reciprocal of the individual admittances True or false

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 22RQ

See similar textbooks

Related questions

Q: 6. What is the effect of load inductance on the ripple current? 7. effect of chonnine

A: Effects of load Inductance on ripple current :

Q: 1. A 25,000 kVA, 13,800 V, 60 cycle, 3-phase Y-connected alternator supplies its rated voltage to…

Q: Find the admittance Y_ab in the circuit seen in the figure. Express your answer in both polar and…

Q: Why the efficiency is same in both questions of single phase half wave the first is R load and the…

A: Here asking about the efficiency of the single phase half wave rectifier with R load, single phase…

Q: "In a R-L series circuit, applied voltage is in phase with the total current." True False "In…

A: 1. impedance of RL circuit is R+jXL So, impedance angle ∅ = tan-1WLR So, current in Rl circuit…

Q: Value of series impedance if inductance is 4mH , resistance is 40 ohm and frequency is 50 Hz.

A: Given values are =

Q: Let v,(t) = 9cos(2t)V, R1 = 3N, R2 = 82, C1 = 600mF and C2 = 900m F. %3D %3D %3D %3D | + C2 Vs 2i,…

Q: star connection, the line voltages leads the phase voltages by

A: Star connection :- (Phasor Diagram)

Q: The transformers works on phenomenon of to change the values of alternating voltages and currents.

A: Transformer is a static gadget which is chipping away at intromagnetic enlistment head. Transformer…

Q: Capacitance is ___ proportional with A and ___ proportional with d.

Q: The terminal voltage for cases where the cosQ value is reverse, forward and 1, respectively,…

A: It is asked to draw the phasor diagrams for the terminal voltage for case where power factor is…

Q: Ohmic components have a V-I curve O Non-linear VI curve. O Parabolic VI curve. O Sinusoidal VI…

A: Ohmic components obey Ohm's law. As per Ohm's law, the current flowing through a ohmic component is…

Q: The regulation of an alternator is likely to be negative in case of resistive load O True O False

A: Regulation of alternator at any load is Voltage regulation = Rpucos(∅)±Xpu sin(∅) + for lagging…

Q: Two impedances consist of resistance of (15 ohms and series connected inductance of 0.04 henry) and…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: what will be the total and unit for impedance if the given is 8mA and 9mV?

A: Electrical impedance is the amount of opposition that a circuit presents to current or voltage…

Q: 1. A load of 50 ohms resistance and 0.4 H inductance are connected in series to 100 volts, 60 hz a-c…

A: we have to calculate capacitance.

Q: Explain in details the relation between phase and line voltages and currents in a star- connected…

A: Circuit diagram for star connected network is given by, Here N is the neutral point R is red phase…

Q: The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base…

A: In this answer let us try to find the base power used in order to get the given per unit impedance…

Q: A 10A current is lagging the voltage by 47° and a 12A current is lagging the voltage by 58°. What is…

A: Given: 10 A current lagging the voltage by 470 and 12 A current lagging the voltage by 580. We have…

Q: A transformer has a rated output of 300 kVA at a power factor of 0.6. Find the rate power output and…

A: Rated output (S) = 300 kVA Power factor (ϕ) = 0.6 We have to find the rated power output and…

Q: APPLICATION OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT

A: we need to answer what are the APPLICATION OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT .

Q: the two alternating e.m.f.s would reach their maximum and zero values at the same time such…

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: -Calculate and draw the load current for the first two-period interval b-Calculate and draw the…

A: Rectifier: Because nearly every electrical appliance runs on DC (Direct Current), the rectifier…

Q: Problem 2: Question 2. Consider the three phase generator below: Phase A Phase B N Phase C N N a) If…

Q: Value of series impedance if inductance is 5mH , resistance is 4 ohm and frequency is 50 Hz.

A: Given values are =

Q: Jessica is observing two series connected loads each having a 100 ohms impedance. Jessica Enows that…

A: Kirchhoff's voltage law: It states that in any closed circuit or loop, the total voltage around the…

Q: The symmetrical short circuit current is quantity in nature. O Alternating O Exponential O Ramp O…

A: Need to fill the blank

Q: Add the following two impedances (a) in series and (b) in parallel. Z1 = 4 + 3i and Z2 = 12 + 5i

A: The question is about finding equivalent impedance in series and parallel.Given, Z1 = 12+5i

Q: 2) using the sequence find only last two terms of the series: 2 + 5 + 10 + 17 + 26 + ... + ...

A: Series is written as the sum of term of sequence where sequence is the list of numbers. Series are…

Q: 一→ Is It 一> 414 I3 3A 102

A: Voltage across the resistance 8ohm This circuit have 2 independent energy sources and resistances.…

Q: A three phase star-connected load drawing power at a voltage of 0.9 pu and 0.8 power factor lagging.…

A: A three phase star-connected load- Power factor cosϕ=0.8 lagging, Base voltage Vb=0.9 pu, Base…

Q: Compute the magnitude of the voltage in units of Volts (enter value only, not units) for a componet…

A: Answer:- magnitude of the voltage is 2. Therefore, V= 2

Q: 15) Kirchhoff's Voltage Law (KVL) states that…

A: The second law of Kirchhoff's is about the energy conservation in a closed electrical path. The…

Q: In 3-phase balanced delta connected system, the voltage induced in each coil is called

A: In a delta-connected system, if the finished terminal of one winding is connected to the beginning…

Q: The primary is 3000 turns, while the secondary is 6000 turns a. single-phase b.…

A: Transformer is static device. The secondary voltage of step up transformer is more than primary…

Question

In series-connected ac circuit, the value of the equivalent admittance of the circuit is equal to the reciprocal of phasor sum of the reciprocal of the individual admittances

True or false

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
APPLICATION OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT
The terminal voltage for cases where the cosQ value is reverse, forward and 1, respectively, ignoring the resistance value of the generator draw phasor diagrams
15) Kirchhoff's Voltage Law (KVL) states that A) the product of the phasor voltages around any closed path must equal zero. B) the sum of the phasor voltages around any closed path does not have to equal zero. C) the sum of the phasor voltages around any closed path must equal zero. D) the sum of the phasor voltages around a closed path cannot include "through the air."
what will be the total and unit for impedance if the given is 8mA and 9mV?
Draw three transformers for each of the different three-phase connections. That is, draw three transformers and then make the connection, eg star-star, then redraw three transformers and make another three-phase connection, and so on until all four combinations of three-phase connections are made.
Please answer quickly "In a R-L series circuit, applied voltage is in phase with the total current." True False "In series-connected ac circuit, the total voltage across the circuit and the voltage across each elements are the same." True False "In parallel-connected ac circuit, the total voltage across the circuit is always equal to the phasor sum of the individual voltage across each element." True False
Capacitance is ___ proportional with A and ___ proportional with d. directly, indirectly directly, directly indirectly, indirectly indirectly, directly
Add the following two impedances (a) in series and (b) in parallel. Z1 = 4 + 3i and Z2 = 12 + 5i
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
2) using the sequence find only last two terms of the series: 2 + 5+ 10 + 17 + 26 + ... + ...
Two impedances consist of resistance of (15 ohms and series connectedinductance of 0.04 henry) and (resistance of 10 ohms, inductance of 0.1 henryand a capacitance of 100 microfarad, all in series) are connected in series andare connected to 230 volts, 50 – Hz AC source. Find: (a) current drawn, (b) voltageacross each impedance, (c) individual and total power factor. Draw the phasordiagram.