In selective repeat ARQ, packet size is 2000 bytes transmission time for one packet is 1ms. If distance between hosts is 10km and signal speed is 4ms per km (4ms/km) and frame sequence number are 6 bit long in frame format then the throughput (in Mbps) is

Q: propagation delay is 10 ad B is 100Mbps. Both 5Bytes long and ACK und trip delay between

A:

Q: onsider a point to point link 50 km in length. At what bandwidth (in Kbps) ,would propagation delay…

A: Length = 50km = 50x103 m Transmission speed = 2 x 108 m/s Packet length = 100 byte

Q: agation delay, The Stop & Wait Protoc

A:

Q: A sender with window size (W=3) is connected to a selective repeat  receiver by a link with…

A: Solution:   Given, the window size (W) of the sender is 3, the bandwidth of the link is 106…

Q: Consider a selective repeat sliding window protocol that uses a frame size of 2 KB to send data on a…

A: Given the Frame Size as 2KB, Bandwidth=4Mbps Latency =60ms, which is also known as Propagation delay…

Q: Consider the following scenario: Frames of 12000 bits are sent over a 400kbps channel using a…

A: Protocols in Networking  A network protocol is a set up set of decides that decide how information…

Q: A TDM link has line rate of 1.536 Mbps. If an individual session requires 64 kbps, how many…

A: The purpose of this calculation is to determine the number of simultaneous sessions that can be…

Q: data communication

A: Scale of message (L)=3 megabits=3×220=3×1024×1024 bits binary systems, Mega implies 2 to 20 energy…

Q: Assume two hosts, A and B, that are linked by a single link with a rate of R bps and are spaced m…

A: Sure, let's break down the questions step by step and calculate the values.Rate of the link (R) = R…

Q: Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay.

A: Propagation delay Given as 240 ms Transmission delay is 256/12000 = 0.021 = 21 ms Putting in formula…

Q: Suppose you are designing a sliding window GBN protocol for a 5 Mbps point to point link, which has…

A: Find the required answer with calculation given as below :

Q: Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive…

A: Computer networking which refers to interconnected computing devices that can exchange data and…

Q: In pure ALOHA protocol the highest throughput is achived when G= and the channel can have a maximum…

A: Efficiency of ALOHA systems An ALOHA system is efficient if a certain percentage of all sent frames…

Q: In cdma2000 reverse link, a user stream of 9.6kbps is sent to an encoder r = 14 (4 coded bit for…

A: Hey there, I am writing the required solution of the above stated question.Please do find the…

Q: Consider a point to point link 50 km in length. At what bandwidth (in Mega bits/second) ,would…

A: Propagation delay:- It is a time taken by signal to reach its destination.

Q: In pure ALOHA protocol the highest throughput is achived when G= and the channel can have a maximum…

A: Introduction: The multiple access protocol ALOHA is used to transmit data over a public network…

Q: Computer Science The following character encoding is used in a data link protocol: A: 11100011 B:…

A: Data link layer detects/corrects errors as follows: Framing Computing checksum Handling error if any…

Q: x is regulated by a tok Mbps. Token bucket i zion taken by the noc

A:

Q: Suppose a 1 Megabit message is to be transmitted over 2 hops in a network. lines in the network are…

A: A message of size m bits is to be transmitted over an L-hop path in a store-and-forward packet…

Q: Suppose you are designing a sliding window protocol for a 2-Mbps point-to-point link to the moon,…

A: Given- Bandwidth = 2 Mbps Propagation delay (Tp) = 1.25 sec Packet size = 1 KB = 210B= 210*8 bits

Q: Q) In pure ALOHA protocol the highest throughput is achived when G= and the channel can have a…

A: Below I have fill the blanks of the given question:

Q: The total processing time in the intermediate nodes is us. The total queuing time in the…

A: Lets find out what are given in question and denote it: message size (L) = 5 megabits…

Q: We have a 1000 m long 10 Mbps communication channel with ARQ protocol. The signal travels at a speed…

A: Automatic Repeat Query (ARQ) is also known as Automatic Repeat Request. In a two-way communication…

Q: Computer A is sending a 100 kByte long file to Computer B via packet-switching over two consecutive…

A: Given that, Size of the file= 100 KB Bandwidth of the link= 10 Mbps Distance of each link= 1000 Km…

Q: Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive…

A: Given that, Length of file= 10 MB Length of packet= 1480 bytes Bandwidth of the link= 100 Mbps…

Q: COMPUTER NETWORKS: Please answer fast and show how to get the answer. An application message is…

A: Number of packets=20 Length of the packet size= 4000 bytes Band width= 1 Mbps Total distance= 2000…

Q: d. The signal at the beginning of a cable with – 0.6 dB/km has a power of 11 mW. Calculate the power…

A: As per our guidelines, we are supposed to answer only one question. Kindly repost the remaining…

Q: Find the throughput of this system, expressed in terms of packet/slot

A: Formula for throughput for slotted ALOHA is  S(threshold) = G*e^-G Where G is the number of…

Q: ng message pássing- 2nd, 5th an at message's successfully transfe

A: Q

Q: ation D are router R. received by 200 bytes S.C.

A:

Q: annel is error free and 270 msec is the signal propagation time from the source to destina e…

A: The Answer is

Q: Assume two hosts, A and B, that are linked by a single link with a rate of R bps and are spaced m…

A: The question requires us to calculate the end-to-end delay for a packet sent from one host to…

Q: All links in the path between source and destination have a transmission rate of 10 Mbps. Assume…

A:

Q: If a two port bridge was used in a heavy load standard Ethernet network such that the traffic is…

A: LANs are used to enable communication and resource sharing between devices within the network. They…

Q: A packet with 88MB long is generated at node A and sent to node C through node B. The distance…

A: For finding  out the minimum data rate between the nodes B and C so that the buffer of the node B…

Q: client and a web server.

A: Given :- In the above given question, the statement is mention in the above given question   Need to…

Q: A node X on a 10 Mbps network is regulated by a token bucket. The token bucket is filled at a rate…

A: A node X on a 10 Mbps network is regulated by a token bucket. The token bucket is filled at a rate…

Q: A framing protocol deploys the bit stuffing for the data transmission process. Frame that is…

A: Bit stuffing is the technique of adding a bit into the transmission data and this bit doesn't…

Q: communication satellite orbits the earth at distance of 30000 miles with each mile having a…

A: Transmission time Tt = packet length/bandwidth = 1250bytes/106 = 1250*8*10-6 = 10000*10-6 = 10 ms =…

Q: e size of 20 sıze asec. To ac ts requirec

A:

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.