In order to form a stream of bubbles, air is introduced through a nozzle into a tank of water at 20°C. If the process requires 4.0 mm diameter bubbles to be formed, by how much the air pressure at the nozzle must exceed that of the surrounding water? What would be the absolute pressure inside the bubble if the surrounding water is at 100.3 kN/m2?Take surface tension of water at 20°C = 0.0735 N/m. *

In order to form a stream of bubbles, air is introduced through a nozzle into a tank of water at 20°C. If the process requires 4.0 mm diameter bubbles to be formed, by how much the air pressure at the nozzle must exceed that of the surrounding water? What would be the absolute pressure inside the bubble if the surrounding water is at 100.3 kN/m2?Take surface tension of water at 20°C = 0.0735 N/m. *

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The liquid inside the tank on the left side of the 2000 mm wide rectangular shaped lid hinged from the O point, which is seen in the middle of the figure, is under pressure of -22.50 kPa, and on the right side there is oil with a density of d= 0.80. Find the intensity and direction of the force that will act on the O point in order for this cover to remain in balance (Y(liquid)=0.9 kg/lt, Ig=bh^3/12). (Hava=air, Sıvı=liquid, yağ=oil)
An air receiver carries a pressure of 3500 kPa absolute @ a temperature of 25 C. A fire occurs near the receiver which causes the temperature to rise to 80 C. Neglecting the increased volume of the receiver due to expansion, calculate the air pressure at this temperature.
Answer it correctly. I need the right solution within 20-40min
The test tube opens at 293 K with 15 cm Hg at the bottom, and 7.5 cm of water above the Hg. Calculate the pressure at the bottom of the tube if the atmospheric pressure is 760 mm Hg. Use the density of 13:55 g / cm3 for Hg and 0998 g / cm3 to air.Berikan answers in terms of dyne / cm2,psia, and kN / m2 • (see conversion table). a. … KPa. b. … Dyne / cm2. c. … Psia.
A mountain climbers observed that the pressure on top of the mountain is 500 mm Hg. At the same time the pressure at the base is 760 mm Hg. If average air temperature at that time is 28 degrees C. Calculate the approximate height of the mountain.
Choose Correct Answer .The oil zone lie's between Gas zone and water zone. Upper part of reservoir. Lower part of reservoir. it cuts the rocket the bottom. ?As the bit rotates, what tow things dose it do It Crashes the rock at the bottom. It Cuts and Crushes the rock at the bottom. Of mass to volume ΟΟΟ Densities is the relation Of part to another. ㅇ ㅇㅇㅇ Both of them.
Milk with a density of 970 kg/m^3 is transported on a level road in a 9-m long, 3-m diameter cylindrical tanker. The tanker is completely filled with milk, i.e., no air space in the tank. If the truck is accelerating from a stop signal at 7.0 m/s^2 to the left, determine the pressure difference between the maximum and minimum pressures in the tank. Depict on the figure the location of the minimum and maximum pressures in the tank. min. 9m 3m
(a) Determine the height water at 70°F will rise due to capillary action in a clean, 1/4-in.-diameter tube. (b) What will be the height if the diameter is reduced to 0.01 in.? At this temperature, water = 0.00497 lb/ft and ywater = 62.3 lb/ft³. Use 0 = 0°.
In medical work, pressures are often measured in units of mm of H2O because body fluids, including the cerebrospinal fluid, typically have nearly the same density as water. The pressure of the cerebrospinal fluid can be measured by means of a spinal tap. A hollow tube is inserted into the spinal column, and the height to which the fluid rises is observed. If the fluid rises to a height of 160 mm, we write its gauge pressure as 160 mm H2O. a) Sometimes it is necessary to determine whether an accident victim has suffered a crushed vertebra that is blocking the flow of cerebrospinal fluid in the spinal column. In other cases, a physician may suspect that a tumor or other growth is locking the spinal column and inhibiting the flow of cerebrospinal fluid. Such conditions can be investigated by means of the Queckensted test. In this procedure the veins in the patient’s neck are compressed, to make the blood pressure rise in the brain. The increase in pressure in the blood vessels is…
What torque does the force F produce with respect to the nut's axis when α = 46 degrees? Tips: One option is to determine the horizontal and vertical components of r⃗ and F⃗. Another option is to determine the length of the moment arm and the angle between r⃗ and F⃗. Pay attention to the directions of rotation.