In open end vertical antenna, as we increase the length of the antenna, this will produceSelect one:OA Series resonancesB. Parallel resonancesOC. None is correctO D. Series and parallel resonances

In open end vertical antenna, as we increase the length of the antenna, this will produce Select one: OA Series resonances OB. Parallel resonances C. None is correct O D. Series and parallel resonances

In open end vertical antenna, as we increase the length of the antenna, this will produce Select one: OA Series resonances OB. Parallel resonances C. None is correct O D. Series and parallel resonances

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The directive gain of an element is 44 dB. If the main beam of the element is circular, then what…

A: The directive gain of an element essentially indicates the directivity of the element. In this…

Q: answer in good detial

A: using parseval's energy theorem , we can calculate the energy of any signal.If want to further…

Q: dimension of the rectangular wave guide is GHz for the mode TE. The inner broad dominant mode is…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: What is the significance of a Bode plot in electrical engineering and how can it be used to analyze…

A: A Bode plot is a graphical representation of a system's frequency response, which describes how a…

Q: IX) Represent (-48)10 in a) Sign Magnitude form and b) Sign 2's Complement form.

A: We need to represent the given number in two different format .

Q: 4-2. Show that the TMor and TM₁o modes in a rectangular waveguide do not exist.

A: The modes in a rectangular waveguides are represented with their mode of operation, In TM (01) , m…

Q: What is 1/(j*2pi*f) convolved with sinc((f-f_c)/B) where f_c is the center frequency and B is the…

A: To calculate the convolution of and since , we can perform the convolution in the frequency domain.…

Q: In critical sampling the neighboring spectral components with each other.

A: To avoid aliasing sampling frequency should be equal to Nyquist frequency If sampling frequency is…

Q: [Q4A] For each signal, if it is periodic, find the fundamental period To. a-x(1) 5 cos(3xt +…

A: To determine whether each signal is periodic and to find the fundamental period T0 if they are…

Q: Required information Consider the circuit given below. Vin R₁ L₁ 12 m R₂ fout Evaluate the magnitude…

A: Given:with, we need to find:the magnitude of H(jw) at:

Q: carrier signal = 5000hz information signal = 500hz How can i decide Lower passband edge frequency…

A: Given In the above question they have mentioned the carrier signal and message signal And they…

Q: Given M = 6i + 2j - k and N= 2i-j - 3k calculate the M .N, M× Nand the angle between M&N and.

Q: Question 3: For the signal shown in figure plot. а- X(-6) b- X(2t-3) c- X(-3t+5) d- X(0.5t+2) 1.5…

Q: 4. Medium frequency range is from 001

A: Medium frequency is used for the radio frequencies and also this band is used for AM…

Q: FM modulation with square wave information signal; interpret signals in frequency and time domain.

A: Modulation is a process of varying the properties of a carrier signal according to the amplitude of…

Q: Design a differentiator circuit to differentiate signals with frequencies up to 150 Hz and produces…

A: Given to design a differentiator circuit to differentiate signals with frequencies up to 150 Hz…

Q: the circuit diagram shows a simple RC low- pass filter. The filter cut-off frequency fco (cut-off…

Q: 32.Check wen the reot locus or not GO

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: Design a microstrip for a 50 ohms characteristic impedance. Use h=1.6mm epoxiglass substrate.…

A: Design a microstrip for a 50 ohms characteristic impedance. And use h=1.6mm epoxy glass substrate.…

Q: Find dominant mode when a>b>c and a<b<c. Calculate resonant frequency when a=3cm,b=2cm,c=4cm for…

Q: ' If the carrier signal is Vc (t) = Ve Sin (Wst). And the information signal is used to generate AM…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: According to Table B-1 on page 7, is the number of spectrum of the angle moc -0.5 is more than or…

A: From given table For β=0.5 the number of spectrum values are n=0, 1, 2, 3 that is 4 spectrum values.…

Q: Delve into the role of modal dispersion in limiting the bandwidth of multimode fibers

A: We need to describe the role of modal dispersion in limiting the bandwidth of multimode fibers.

Q: generate AM wave Vm (t) = Vm Sin (t), the AM Bandwidth is equal to 10 KHz, modulation index m = 0.6…

Q: Check if the signal x[n] is periodic or not: (6nn' x[n] = el#)

A: Ans. Shown below

Q: If the carrier signal is Vs (t) = Ve Sin (Wst). And the information signal is used to generate AM…

Q: Q. Determine whether or not the signals defined below are periodic, and for each signal that is…

Q: ind dominant mode when a>b>c and a<b<c. Calculate resonant frequency when a=3cm,b32cm,c%34cm for…

A: The wave is function of space and time. The EM wave is formed when electric field is in contact with…

Q: Problem 6 Optical resonator its length 0.1 m and medium refractive index 1.5 Calculate the frequency…

Q: Suppose we are building a radio receiver with an R-L-C circuit. We would like to receive radio…

A: The receiver should accept the signal of frequency 1 MHz without any attenuation or disturbance but…

Q: In the satellite C Band ( 6GHZ / 4GHZ), the first frequency 6 GHz represents the frequency.

Q: [Q5] Choose appropriate values for this Sallen-Key high-pass filter circuit to give it a cutoff…

A: We have to design a Sallen-Key high pass filter with "Butterworth" response by choosing appropriate…

Q: Current Transformer Distributed capacitance C of a coil is measured by a Q-meter. At a frequency of…

A: Given- Frequency- f1=1 MHz, f2=2 MHz, To Find- The value of Cd.

Q: A rectangular waveguide has a dimension of 3cm by 2 cm is used to transmit a signal of 8 GHz.…

A: Given: Rectangular wave-guide used in dominant mode. The dimensions are, a=3 cm and b=2 cm…

Q: rate AM wave Vm (t) = Vm Sin (t), the AM Bandwidth is equal to 12 KHz, alation index m = 0.5 and the…

Q: 100 GCS) = (S+1) (s+10) (5+50)

A: Bode plot A bode plot is a graphical representation of the frequency response of the system or in…

Q: A step-up chopper has input voltage of 22X V and output voltage of 38X V. If the non- conducting…

Q: The white noise is characterized by a wide spectrum. O True False

A: It has zero mean, constant variance and is uncorrelated in time. White noise has a power spectrum…

Q: The figure below shows the spectrum of a signal. b a d 0 e DO 1. what is d value? 2. what is h…

Q: R1 C1 a (1 ZISph VSm ISm ZVSph L1 b In the circuit, the voltage source amplitude and phase are 20 V…

A: Thevenins equivalent circuit: VTh= open circuit voltage between a and b ZTh= equivalent impedance…

Q: 15-20. Determine the power gain in decibels for an antenna with a directive gain D = 50 dB and an…

A: Given directive gain D= 50 db and efficiency = 75% and asked to find the power gain.

Question

In open end vertical antenna, as we increase the length of the antenna, this will produce
Select one:
OA Series resonances
B. Parallel resonances
OC. None is correct
O D. Series and parallel resonances

Expert Solution

Step 1

In open end vertical antenna, as we increase the length of the antenna the load resistance in the circuit relatively large, which make more difficulty to achieve resonances at resonance frequency, then this will produce a Parallel resonance.

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

answer with explain
I need the answer as soon as possible
! Required information A parallel resonance circuit has a resistance of 2 KQ and half-power frequencies of 84 kHz and 92 kHz. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Determine the capacitance. The value of the capacitance is nF.
AM signal's frequency is a constant True O False QUESTION 9 Noise equivelent bandwidth is always the same as -3dB bandwidth. True False QUESTION 10 A period signal's auto correlation is period as well. O True False
SHOW WHAT IS GIVEN AND WHAT IS UNKNOWN, MAKE SURE TO SHOW THE SOLUTION COMPLETELY. ANSWERS MUST BE IN 2 DECIMAL PLACES
Find DFT values of x-[2 1 9 2] and plot amplitude and phase spectrum. Write axis labels.
What is the noise power for a band with of 13.5 kHz at 20°C? Determine the noise power density when the bandwidth is doubled.
(27. Determine the magnitude and phase angle of the circuit current shown in Figure 14.50a 14.49b, (27. Determine the magnitude and phase angle of the circuit current shown in Figule IR 18 mA Ic 8 mA 42 mA (a) FIGURE 14.50 magraak anyle plase
mosfet low frequency question
1. What is the resonance frequency of ac circuit? a) 1/VLC b) v(L/C) c) VLC d) LC
Prove that the Vout = (- Rf / Rin ) vin
What are the various feeling mechanism used in reflector antennas, and what is sployer? Determine the diameter of the mouth and HPBW of a parabole refectur with a power gain of 300 and operating frequency is 2 GHz