In measuring settling time from step response with five percentage tolerance, the tolerance band will be between, O a. 0.94 and 1.06 O b. 0.95 and 1.05 O c. 0.96 and 1.04 O d. 0.98 and 1.02

Q: Q/ Why is high frequency (Fsw) used in Buck Converter circuits

A:

Q: 24. What is the impedance of a series combination of a 50-2 resistor, a 5.0-uF5.0-µF capacitor, and…

A:

Q: Show the output voltage for the Vi input voltage in the figure by drawing it along a period (Note:…

A: Given input voltage is

Q: Consider the root locus of a unity feedback system with loop transfer function L(s) = Ge(s)G(s) =…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: QUESTION 20 When a modem receives data, it uses a shift register. O SIPO PISO FIFO O D flip flop

A: a modem receive data,

Q: 26. A resistor and inductor are connected in series across an ac generator. The emf of the generator…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Find the inductor current i, (t) assume i(0) = 0, v. (0) = 0 v(1) , = Su (t) A H (a) (5- e' [5…

A:

Q: O Inductor Diode Voltage Surce Swilching Device Capactor This DC-to-DC converter has a duty cycle of…

A: Given data: Duty cycle = 33.3% = 0.333 Converter input = 5 V Output voltage = ? The dc-dc…

Q: The voltage across the 16-ohm resistor in the circuit is 80 V, positive at the upper terminal. a.…

A: The given circuit is shown below. We need to determine the power dissipated in each resistor and…

Q: What is the frequency and what is the period, write the formula

A: Frequency is nothing but repetition of signal per second

Q: The equivalent impedance of two capacitors in series is 0.03 microfarad and when connected in…

A: If two capacitor C1 ,C2 are connected in series than equivalant capacitance is (C1×C2)/(C1+C2). If…

Q: Determine the waveform, theoretical, of the peak output voltage at Resistor L. 120 V rms 5:1 ooooo…

A: Given:a full wave rectifier circuit, we are required to determine the output voltage waveform at…

Q: Derive the frequency response H(w) = for the following active filter. %3D

A:

Q: On the back of the suction electrode is a reference electrode and the signal seen between these two…

A: Given  the information about suction  electrode.

Q: ent method so urrent of 2 2 a sult of 1,12,13.

A: The mesh analysis technique is applicable only for a planner network. It deals with the least…

Q: 22. A 25-µF capacitor is connected to an emf given by v(t) = (160V)sin(120rt). (a) What is the…

A: Given Capacitance C=25 μF EMF vt=160sin120πt Angular frequency ω=120π (a) The capacitive reactance…

Q: A current of 20A flows through a load having a resistance of 2 ohm. Determine the power dissipated…

A: Current I = 20 ALoad resistance RL= 2 Coil resistance Rc = 0.01 We have to find the the value of…

Q: For C1=8, C2=15, C3=34, C4=55, C5=49, C6=42, C7=81, C8=17 & C9=15 in the circuit shown below, Find…

A:

Q: a. Obtain the transfer function H(w) = Vo(w) Vi(w) b. Determine the type of the filter. c. Calculate…

A:

Q: The voltage across the terminals a and b in Fig.1.11 is (a) 0.5 V (b) 3.0 V (c) 3.5 V (d) 4.0 V 1V +…

A: Given:

Q: For the circuit shown below, I 2Ω ww ЗА 42 VI [z] V2 10Ω [10 Given z-parameters as [z] = 12, Find I,…

A:

Q: Find Leq between the terminals a,b for the circuits shown. Assuming the initial energy stored in the…

A:

Q: Given Vi = 20V peak-to-peak, draw the output waveform for the said clamper circuit below:

A:

Q: Consider a closed-loop control with the following loop transfer function: 1 L(s) = Ge(s)G(s) = s(4s…

A: The Given close loop Transfer function is Ls=GcsGs=1s4s+16s+1 The Phase angle of Ljω=-180°

Q: Determine the peak value of the output waveform. v-Sv V-5V 20 V A. 25 V B. 15 V C. -25 V D. -15 V

A:

Q: Calculate current gain, input and output impedance, and linearity. Beta = 90 IS = 2E-15

A: Given figure is as shown below, We need to calculate current gain, input and output impedance

Q: filtered rectifier has a 15 Vdc output with 100 mVp-p of ripple. The peak output voltage for the…

A: In this question we will find peak value of given signal....

Q: In a 10C400 CT, the maximum error occurs at what secondary current? O A. The answwer is not given…

A: In this question We need to choose the correct option What is maximum error  in secondary side.

Q: Referring to the terminal a - b. Find the Thevenin's Equivalent resistance and voltage. in 60 3 A 40…

A:

Q: please work out the following using the infomation in the attached photo. This is for a Boost…

A: Given  L = 4mH C = 100μF Vin = 20V Load (R) = 500Ω Duty cycle (D) = 33.3% = 13 Asked to find…

Q: Q6) The waveform of the voltage obtained after rectification is of a -----nature and therefore…

A: AC signal has both positive and negative half cycle where as dc has only positive voltages.…

Q: A capacitor having a Q-factor of 400 is connected in parallel with a coil having a Q- factor of 50.…

A: Q-factor of capacitor (Qc) = 400 Q-factor of coil (QL) = 60 We have to find the overall Q-factor of…

Q: Given that: R1=21, R2=33, Is=8 A, Vs=6.6 V, Find Vth between the terminals a-b for the circuit shown…

A:

Q: C'uk Converter Design -A C´uk converter has an input of 12 V and is to have an output of - 24 V…

A: we have the expression for duty ratio as  V0Vs=-D1-D substitute -24 for V0 and 12 for Vs…

Q: With reference to the circuit diagram given below describe in detail the operation of the circuit…

A:

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.