In distillation, q is defined as the moles of liquid flow in the stripping section per mole of feed introduced. The values of q for saturated liquid feed and for saturated vapor feed are and respectively. a) 0, 0.5 b) 0.5, 0 c) 1, 0 d) 0, 1

Q: Q1) a hot gas at 325°C flows through a metal pipe of 10 cm OD and 3 mm thick. It is insulated with a…

A: Given Data  To Find The insulation thicknessHeat loss per m length of the pipe

Q: An oil burner nozzle is labeled 60°. This is the angle from straight ahead tothe direction that the…

A: Paper is placed 12 inches from the nozzle.  the oil burner is labeled at 600C, The Schematic of the…

Q: 3. A long hollow cylinder has inner and outer radii R, and R2, respectively. The temperature of the…

A: Given details, For Hollow Cylinder of  Inner radius=R1 at Temperature T1 Outer radius=R2 at…

Q: Nitrogen gas has a heat capacity of 20.8 and 29.1 J/mol-C at constant volume and constant pressure…

A: Given Data: Specific heat capacity of N2 at constant Volume;Cv=20.8 J/mol °CSpecific heat capacity…

Q: It is said that inlet gas takes 5-6 turns in Cyclone Separator.Justify the statement.

A:

Q: For multicomponent distillation,under what conditions is the pinch point located at the…

A: The condition at which pinch point is located at the location of feed is to be mentioned.

Q: 7. Joule-Thompson cooling of a gas occurs when the pressure of the gas drops as it goes through a…

A: If Z= f(x,y) is function of two variables say x and y. then total differential will be ;…

Q: temperature. * O True O False Nan

A: The above question is the question of the heat exchanger. There are many reasons that decrease the…

Q: Why the temperature of the gas exiting the CSTR is different from the temperature of the entering…

A: Constant stirred tank reactor (CSTR) is a continuous, perfectly mixed reactor.

Q: Which of the following crystallizers work without contacting feed solution and coolant in a single…

A: To choose the correct option that shows the name of crystallizer in which there is no contact of…

Q: Example 2.1 : Calculate the rate of heat loss through a wall of k = 0.70 W/(m K)] 5 m in length, 4 m…

A: Above problem is based on conductio.Conduction is an mode of heat transfer which is define as the…

Q: The process of injecting water into a well under high pressure is called Thermal EOR a. False b.…

A: The oil is recovered from the reservoir by means of natural energy (pressure difference) but when…

Q: In the case of determining heat rates and fluxes, is power required for the system the same as the…

A: Heat rate: Heat rate is defined as amount of heat (energy) per unit time. Unit of energy may be…

Q: A pipe (ID: 130 mm, OD: 165 mm, k=15 W/m²-K, Length: 2 meters)is insulated with several materials,…

A:

Q: Answer the question below: Experiment 1: Calibration of a Calorimeter Results Time (in minutes)…

A: Before HeatingTime minutes Temperature (C)024.50.524.61.024.71.524.82.024.92.524.93.025.0Heater…

Q: The compression ratio of an air-standard dual cycle is 12, and the pressure at the beginning of…

A:

Q: I understand that we have to use this formula Heat current=(k. Area. change in temperature)/length…

A: Firstly, the brass rod one end is in boiling water, which means this rod is hot. While the Copper…

Q: Use the on-line psychrometric chart (link in this module) to help solve this problem. The surface…

A: Given data: Surface temperature of the steel duct = 18 0C Dry bulb temperature of the surrounding…

Q: 5. . . ) In a manufacturing process, a long, coated plastic rod (p = 2200 kg/m³, c = 800 J/kg K, k…

A: The time it take to the surface of the rod to reach 175o C, the temperature above which the special…

Q: A horizontal tube (inner and outside diameters are 2.0 cm and 2.5 cm respectively). is used as…

A: Given, 1Uinner=0.005 (m2–K)/W 1Uoutside=0.008 (m2–K)/W  1Uoverall=1Uinner+1Uoutside…

Q: A pipe (ID: 130 mm, OD: 165 mm, k=15 W/m²-K, Length: 2 meters)is insulated with several materials,…

A: Given Pipe Di=130mm D0=165mm K=15 W/(m2K) L=2m Inside fluid –Oil temperature T1=118℃ Insulation is…

Q: Radial heat flow through multi- pie cylinders in series. B In conduction through series, the…

A: Given Three layer A,B,C of conductivities k1,k2,and k3 Have radius r1,r2 and r3 from centre →Write…

Q: At a minimum reflux ratio, the boilup ratio is a) also at minimum b) at finite value c) equal to…

A:

Q: is flowing at a rate of 15 kg/s. For this type of flow, the Nusselt number is given by the following…

A: Given data: Mass flow rate of fluid = 15 kg/s Density of the fluid = 881 kg/m3 Viscosity =…

Q: Determine the external pressure if ethanol boils at 60 °C?

A: The boiling point of Ethanol at new pressure(P2)=60oC To Calculate the pressure(P2)=?

Q: . If A rotary filter, operating at 1.8 rpm, filters at the rate of 0.0075 m3 /s. Operating under the…

A: Given data:Initial filtrate speed, f⁠⁠⁠⁠⁠⁠⁠1 = 1.8 rpmInitial filtrate rate, Q1 = 0.0075…

Q: Q.2 An Aluminum plate of area 500cm2 is heated up for 5 seconds and its temperature increases from…

A: Area of Aluminium Plate=500cm2=0.05m2 Thickness=2cm=0.02m Mass of Aluminium plate=3.46kg Time up to…

Q: Which of the following is the rate of heat transfer unit 1. Watt 2. Pascal 3. Joule 4. None of these

A: Heat transfer is the transfer of heat due to modes of heat transfer like conduction, convection and…

Q: Estimate the thermal conductivity of the Meat at 35 ° C. (Water content = 75.0% wet basis). Thermal…

A: Thermal conductivity is the intrinsic property of the material, it actually relates the ability of…

Q: True or False

A: Ans 1- True  2-  False ( because cooling and chilling rate are governed by any of form it can be…

Q: Describe an electrochemical cell that operates at 1000'C and burns fuel to produce direct current…

A: Dear user Since the primary objective of fuel cells is to produce non-polluting energy by not…

Q: If a beaker of water is placed in a bell jar, and the water is maintained at constant temperature…

A: Introduction A bell jar is a glass jar, similar in shape to a bell , often used in laboratories to…

Q: Temperature measurement is done using a mercury thermometer; which is protected by a thermowell.…

A: The order of mercury thermometer is to be mentioned with detailed analysis.

Q: 2) A cylinder holds 200 kg of water at 120 °C at a pressure of 20 MPa. The temperature is increased…

A:

Q: Derive the total energy equation when there is a volume source of heat, h(r, t), per unit volume in…

A:

Q: A 4 mm diameter tube, 40 cm long, closed at one end and standing vertically on its closed end, is…

A: Given, d= 4mm, L=40 cm, T=17oC, ρ=790 Kg/m3 System is uni-component diffusion…

Q: pars), calculate the

A: Given data: mole% of water in overhead stream=8.5 mole%Pressure; P=34.7 psia=2.36 bars

Q: px 10³ beg 10³

A: