In developing line or wiring disgrams,in which lines should the overload relays be place for three - pase motor starters?
Protection System
A system that protects electrical systems from faults by isolating the problematic part from the remainder of the system, preventing power from being cut from healthy elements, improving system dependability and efficiency is the protection system. Protection devices are the equipment that are utilized to implement the protection system.
Predictive Maintenance System
Predictive maintenance technologies are designed to assist in determining the state of in-service equipment so that maintenance can be scheduled. Predictive maintenance is the application of information; proactive maintenance approaches examine the condition of equipment and anticipate when it should maintain. The purpose of predictive maintenance is to forecast when equipment will fail (depending on a variety of parameters), then prevent the failure through routine and corrective maintenance.Condition monitoring is the continual monitoring of machines during process conditions to maintain optimal machine use, which is necessary for predictive maintenance. There are three types of condition monitoring: online, periodic, and remote. Finally, remote condition monitoring allows the equipment observed from a small place and data supplied for analysis.
Preventive Maintenance System
To maintain the equipment and materials on a regular basis in order to maintain those running conditions and reduce unnecessary shutdowns due to unexpected equipment failure is called Preventive Maintenance (PM).
On developing the line or wiring diagrams, in which lines should the overload relays be place for three - phase motor starters.
The overload relays will have the contacts and the coil that is present in control circuit. The holding coil is kept contact mainly with the control circuit.
The low voltage protection results in three wire control system. It includes no voltage protection also. The three wires are get connected to the circuit in this controlling type of the starter. These three wires results in controlling the contactor or starter.
Step by step
Solved in 4 steps
