In an electric heater the inlet temperature is 15°C. Water is flowing at the rate of 300 grams per minute. The voltmeter measuring voltage across the heating element reads 120 volts and an ammeter current taken reads 10 amperes. When steady state is finally reached, what is the final reading of the outlet thermometer?.

In an electric heater the inlet temperature is 15°C. Water is flowing at the rate of 300 grams per minute. The voltmeter measuring voltage across the heating element reads 120 volts and an ammeter current taken reads 10 amperes. When steady state is finally reached, what is the final reading of the outlet thermometer?.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An oxygen gas R = 0.2598 KJ/kg°k and k = 1.395. If 4 kg of oxygen undergo a reversible non flow constant pressure process from initial volume =1.2 cubic meter and initial pressure = 690 kPa to a state where final temperature = 600°C. What is the initial temperature ? Determine the constant volume specific heat. need a complete solution, symbol, and cancellation:)
A reversible refrigeration cycle operates between cold and hot reservoirs at temperatures Tc and TH, respectively. (a) If the coefficient of performance is 10 and Tc = -40°F, determine TH, in °F. (b) If Tc = 0°C and TH = 30°C, determine the coefficient of performance. (c) If Qc = 500 Btu, QH=600 Btu, and Tc = 20°F, determine TH, in °F. (d) If Tc = 50°F and TH = 100°F, determine the coefficient of performance. (e) If the coefficient of performance is 5.5 and Tc = -5°C, find TH, in °C. Part A If the coefficient of performance is 10 and Tc = -40°F, determine TH, in °F. TH= i Save for Later °F Attempts: 0 of 4 used Submit Answer
In the refrigeration experiment, the following values were measured when using the TXV valve (the TXV valve has been calibrated for a superheat temperature of 5C)°: 1- Temperature at the compressor outlet: 94.7±0.5°c 2- Absolute pressure at the valve inlet: 1150± 40 kPa 3- Absolute pressure at the valve outlet: 260± 10 kPa What is the error in the enthalpy of the refrigerant leaving the condenser in units of kJ/kg? Use at least 2 significant digits when you fill in your answer. NOTE: Assume that the quality at the exit of the condenser is exactly zero with no error. Answer: 2.0
Figure 5m 94°F Sunny 4m 8 m/s 3 1.5 m 0 2 m MB B 30 6 m/s 1 of 1 >
Thermodynamics Please show slution step by step.
Question 2 The work done during polytropic expansion of gas from state 1 to state 2 is given by: W = (P₂V₂ - P₁V₁) 1-n A pressurised reservoir connected to a vertical barrel is used to launch projectiles as shown in Figure Q2.1. Assume no leakage around the projectile, no friction and no pressure drop across the valve. The barrel is cylindrical with a diameter, D = 50mm and a length, L = 0.8m. The mass of the projectile, M = 1kg. The volume of the reservoir, V = 2 litres. Atmospheric pressure is 1.01 bar. 0 L M Barrel Valve Figure Q2.1 Reservoir Volume, Vr a) By applying conservation of energy, for an initial reservoir pressure and temperature of 2bar and 20degC and assuming polytropic expansion with n = 1.3, find the exit velocity of the projectile. b) If the valve shuts at the instant the projectile leaves the barrel, what mass of gas is used to launch the projectile? c) Prove that a barrel length of 0.64m results in maximum exit velocity. d) Using this barrel length, what is the…
The total volume of the water tank used in the equipment is 0.02 m3", and the water is heated through the heating rod. The efficiency of the water circulator 40W is 40%, and the remaining energy is released as heat. Given that the heat lost in the entire area in contact with the outside is KI(T-Ta)dT, find the following. O 25 °C → 30 °C. 2 30 °C → 35 °C (C.=4.184J/ml-C, Ta=20 °C. K = 10 J/s-C) (1) Energy balance: equation (2) Total energy used by Heating rod (J)
Saturated steam at P1=25 bar expands adiabatically through a throttling valve to P2=4 bar. If the quality of the steam at the valve inlet is x1=0.9 what is the quality x2 at the valve outlet Please respond ASAP
A reversible refrigeration cycle operates between cold and hot reservoirs at temperatures Tc and TH, respectively. (a) If the coefficient of performance is 3.5 and Tc = -40°F, determine TH, in °F. (b) If Tc = 0°C and TH = 30°C, determine the coefficient of performance. (c) If Qc = 500 Btu, QH = 600 Btu, and Tc = 20°F, determine TH, in °F. (d) If Tc = 30°F and TH = 100°F, determine the coefficient of performance. (e) If the coefficient of performance is 2 and Tc = -5°C, find TH, in °C.
Measured pressure and theoretical pressure, both are same when error is 1. Select one: True False
Subject: Thermodynamics air enters an ideal nozzle at a pressure of 45 psig with a temperature of 1,340F. The pressure at the nozzle exit is 14.925 psia. What is the velocity of the air leaving the nozzle, ft/s?
Please show the complete solution.