In an adiabatic turbine, this steam flow is 50 kg / s. The power produced by the turbine is 29 MW. Steam enters the turbine with a pressure of 50 bar and a speed of 60 m / s. At the outlet, at a pressure of 0.06 bar It comes out as saturated water with a speed of 130 m / s. Accordingly, the heat lost by the turbine and Find the turbine inlet and outlet temperatures of steam

Q: 15 m/h water enters the turbine at 20°C and leaves it at 50°C. The internal diameter of the inlet…

A:

Q: team at 10 MPa & 344°C, expands Isentropically through a turbine. The said turbine exhausts steam at…

A: Let p1 =10MPa T1 =344°C p2 = 40kPa h1 =Enthalpy of steam at entrance  h2 =Enthalpy of steam at exit…

Q: A steam turbine is used to generate electric power in a small-scale process industry. The turbine…

A: As per Bartleby guidelines we are allowed to solve only first 3 subparts of a problem. So kindly…

Q: A pump increases the water pressure from 8 kPa at the inlet to 700 kPa at the outlet. Water enters…

A:

Q: 100 kg/s of superheated steam at 653.15 K and 8800 kPa enters a turbine and leaves as saturated…

A: Condition of superheated steam at turbine inlet is:Temperature,T1=653.15KPressure,P1=8800KPaMass…

Q: The enthalpy of steam entering the turbine inlet is 2750 kJ/kg and leaving turbine at 1750 kJ/kg.…

A: Given data  enthalpy of steam at the inlet of the turbine (h1) = 2750 kJ/kg enthalpy of steam at the…

Q: The turbine's inlet is coupled to a steam throttling valve with inlet conditions of 2MPa and 400C.…

A: Write the given data. P1=2 MPaT1=400 °CW=200 kWQR=100 kWT2=300 °Cm˙=1 kg/s

Q: In a gas turbine unit, the gases flow through the turbine at 13 kg/s and the power developed by the…

A: Given data: Mass flow rate of gas (m.)=13 kg/s The power developed by the turbine (P)=14000 kW The…

Q: A steady flow of steam enters a turbine with a specific enthalpy of 2200 kJ/kg and at negligible…

A: Given:h1=2200 KJ/Kgh2=1900 KJ/Kgm=2 Kg/s

Q: Steam enters an adiabatic turbine at 6MPa pressure, 530C temperature, 2.5MPa pressure and 420C also…

A: Given: Inlet condition of turbineP1=6MPaT1=530°COutlet condition of the turbineP2=2.5MPaT2=420°C…

Q: In a gas turbine , the flow rate of air is 4 kg/sec . The velocity and enthalpy of air at the…

A:

Q: A Pelton wheel turbine is a type of turbine that transforms the kinetic energy of water jet to…

A:

Q: A pump increases the water pressure from 8 kPa at the inlet to 700 kPa at the outlet. Water enters…

A:

Q: The turbine's inlet is connected to a steam throttling valve with inlet conditions of 3MPa and 500C,…

A:

Q: Steam flows into a turbine at a rate of 2 kg/s at 3MPa and 400C. It comes to an end at 300kPa. The…

A:

Q: 4. In a turbo-jet engine the momentum of the gases leaving the nozzle produces the propulsive force.…

A: It is required to deterrmine the diameter of the nozzle at inlet.

Q: A centrifugal air compressor receives a gas at a rate of 6 m3 /min and compresses it from 90 kPa to…

A:

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: A compressor handles 3500 cfm of air as measured at intake of 14.5 psia and 75°F. At discharge, p2 =…

A:

Q: In Otto Cycle, air at 18oC is first compressed to one- eight of its original volume.  If the heat…

A:

Q: As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and…

A:

Q: Before entering the engine of a BMW320D, air drawn in at 20°C and atmospheric pressure enters the…

A: Given:- At Inlet:-Pressure =1 atm=101.325 kPa,Temperature=20° C=293.15 K,Volume flow rate=120…

Q: enthalpy of 3828 kJ/kg at 70m/s and leaves the same stage with an enthalpy: 2846 kJ/kg and a…

A:

Q: Water vapor enters an adiabatic turbine with a pressure of 7 MPa and a flow rate of 2kg / sec at a…

A:

Q: A turbine uses 100,000 lb/hr of steam that enters with an enthalpy of 1400 Btu/lbm and essentially…

A:

Q: Air at temperature 27 oC and pressure 66.3 kPa enters the diffuser steadily with a velocity of 190…

A:

Q: 12 kg of air per minute is delivered by a centrifugal air compressor It enters the compressor at a…

A:

Q: 15 m³/h water enters the turbine at 20°C and leaves it at 50°C. The internal diameter of the inlet…

A: Write the expression for SFEE for the given flow system.

Q: A pump increases the water pressure from 7 kPa at the inlet to 800 kPa at the outlet. Water enters…

A: Given data: The water pressure at the inlet is P1= 7 kPa, The water pressure at the inlet is P2=800…

Q: 600 kPa at 578 K and exits the turbine at a temperature of 428 K and a pressure of 100 kPa

A: apply first law of thermodynamics at inlet and outlet,here assume that air is an ideal gas.

Q: The gas turbine unit is rejecting heat at certain rate but your client is unsure about it. To…

A:

Q: In a steady flow apparatus, 135 kJ of work is done by each kg of fluid. The specific volume of the…

A: Answer: The specific internal energy is -20 kJ/kg (Decreases). Hence, the correct answer is option…

Q: possible to generate 3MW of power with a turbine through which 20 kg/s of steam pass under the…

A:

Q: Define the system to be a container full of steam. If the steam condenses, did the system hae a…

A: Steam is a substance that is a gaseous phase of water. The steam can be generated by evaporation or…

Q: Air enters a gas turbine steadily at pressure 20 kPa, volumetric flowrate 1,000 m3/s, and…

A:

Q: (#20ppVIII-20PrM) - The entrance and exit enthalpies of a steam turbine are 4000 and 3000 kJ/kg…

A: Given:The enthalpy at the entrance of the steam turbine is The enthalpy at the entrance of the steam…