In a test to determine the three orifice coefficients under constant head of water of 1.8 m, it was observed that the diameter of the jet at the vena-contracta of a 60-mm-diameter orifice was found to be 48 mm. The weight of water collected in 100 sec was 1030o N. Determine the following: (a) The coefficient of velocity. (b) The power lost in the orifice in watts. (c) The horizontal distance (m) that the water jet hits the ground

Q: The siphon in the figure has a nozzle 150mm long attached at section 3 reducing the diameter to…

A: A siphon is attached to tank as shown in the figure has, length of nozzle = 150mm diameter of nozzle…

Q: (c) To evaluate the acoustic behaviour of a concrete wall, the propagation of a sound wave in air…

A:

Q: A 75 mm-Ø orifice is on the vertical side of a closeà tank. The tank rests on a flat ground and the…

A:

Q: Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two…

A: Given data  Hydraulic head at 1 (h1) = 66cm  Hydraulic head at 2 (h2) = 54cm  Travel distance (L) =…

Q: A U-tube mercury manometer is used to measure pres- sure of oil flowing through a pipe at a point.…

A: Specific gravity of oil (So) = 0.8Oil head = 50cm =  0.5 m Mercury head = 150 cm =  1.5 m

Q: Oil of sp.gr. of 0.750 flows through the nozzle shown and deflects the mercury in the U-tube gage.…

A: The given data is shown below: Specific gravity=0.75Pressure at A=142 kPa

Q: A liquid of specific gravity SG = 1.62 flows in a 75 mm diameter horizontal pipe. The total energy…

A: Specific gravity of liquid, SG =1.62Diamteter of pipe, D=75mm =0.075mThe total energy at a point, E…

Q: The surface tension of water at 20 °C is 75 x 10-3 N/m. The difference in water surface within and…

A:

Q: HYDRO EXPERIMENT NO.3 4. A 100 mm diameter orifice discharges 45.34 li/s liquid under a head of 3.60…

A:

Q: 23. The ratio of the momentum correction factor to the energy correction factor for a laminar flow…

A: given- Laminar flowpipe flow

Q: shaft = 44 kW and mechanical efficiency 94%. Q53. The following data were obtained from a test on a…

A:

Q: A pressure gage at elevation of 12m at the side of the tank containing liquid reads 100 kPa. Another…

A:

Q: Q-9 A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a…

A: Given data- Diameter of the nozzle d=30 mm=0.03 m, Discharge Q=15 litres/s, Q=15×10-3 m3/s The…

Q: 64 A pelton wheel works under a head of 400 m. Frictional loss through the pipe flow is limited to…

A: A Pelton wheel turbine-Head of wheel  = 400 mLimitation of frictional loss = 10%The coefficient of…

Q: nozzle is so shaped that the average flow velocity changes linearly from 1.5 m/s at the eginning to…

A: Given velocity- V1=1.5 m/s V2 =15 m/s  Distance dx=0.375 m

Q: Problem 13.84 The converging nozzle has an exit diameter of 0.25 m. The fuel-oxidizer mixture within…

A:

Q: a.) Determine the pressure difference between the two vessels when the difference in the levels of…

A:

Q: Current Attempt in Progress A sound wave is observed to travel through a liquid with a speed of 1250…

A: Given: Velocity of sound wave in fluid  Specific gravity of fluid To find: Bulk modulus of fluid…

Q: 2.19 The U-tube at right has a l-cm ID 3 and contains mercury as shown. If 20 cm 25 cm of water is…

A: We have to determine the level of free surface in the each leg after slashing has died down.

Q: A 10 cm diameter solid cylinder of height 10 cm weighing 0.40 kg is immersed in a liquid (800…

A:

Q: 10.8 For laminar flow in a tube calculate the position of the average cross-sectional velocity.…

A: Step 1

Q: 2. The jet passes through a point A, as shown. Calculate the flow rate. Assume the flow is…

A:

Q: A pressurized tank discharges its alcohol through a square orifice (c = 0.64, cy = 0.97). If minor…

A: step 1-

Q: 5) Determine the value of y in the manometer shown in the figure. 1m Alr, 5 KPa Oil S- 0.8 3 m 1 m…

A: Given data in question  Pressure of air Depth Specific gravity  To find out  Value of Y Note Density…

Q: Determine the gauge pressure of the water in the bulb. The densities of mercury and water are 13,600…

A:

Q: A cylinder of internal cross-sectional area 2 sq.m. is submerged in a liquid to a depth of 1 m. The…

A: Given Submerged depth, b=1m Area of cross section of cylinder=2m2 Diameter of orifice=20mm Pressure…

Q: The open tank with piezometers attached on the side, contains two different liquids. Find the…

A: As the liquid in piezometer A and liquid in tank above the installation point of piezometer A is…

Q: Home Work P.3.1 Two pipes A andB carrying water are connected by a connecting tube as shown in…

A: The figure is as shown

Q: In the following system, the flow rate of Q = 400 It / s is transmitted from the A chamber to the B…

A: The liquid from one chamber to another chamber due to variation in height and pressure…

Q: Q.1 (50%): Determine the pressure difference between points A and B in Fig. below. Kerosene…

A:

Q: (in millimeters) of the hole. 3 cm diameter 1.20 m 9 cm diameter 1 m 0.30 m

A:

Q: A 3m Oil: 2m S.g. = 0.9 %3D (F), B 2m Water (F,

A:

Q: Water is siphoned from the tank shown in the figure below. The water barometer indicates a reading…

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: Q(1): A horizontal rectangular stilling basin is used at the outlet of a spillway to dissipate…

A: for rectangular stilling basin , given discharge Q = 13m3/s  Width B = 12m  V1 = 10 m/s sequent…

Q: A nozzle of inner radius 1.06 mm is connected to a hose of inner radius 9.05 mm. The nozzle shoots…

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.