Answered: In a series RC circuit, the voltage…

In a series RC circuit, the voltage across the capacitor and the resistor are 60 and 80 volt respectively, the total voltage is

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 14PP: An R-L series circuit contains two resistors and two inductors. The resistors dissipate powers of 96...

See similar textbooks

Related questions

Q: An industrial coil has a resistance of 32 ohms and a reactance of 24 ohms and rated 440 volts at 60…

Q: Two current, 5+j2 and 3-j2 enter a junction. What is the outgoing current?

A: Two currents 5+j2 and 3-j2 enter a junction. What is the outgoing current ?

Q: A 50 mH inductance is connected in series with 20 ohm resistor. If the voltage is 220 volt: What…

A: Given data R = 20 ohm L = 50 mH V = 220 volt To find power drawn ?

Q: A radio receiver consists of a Low noise amplifier (LNA), a mixer and an IF amplifier in cascade.…

A: This question is from "Advance Analog Electronics". Under which we are going to find out the overall…

Q: A resistance of 30 ohms and an inductive reactance of 60 ohms are in series across 120 volts, 60…

A: The power factor is a term that tells how effectively the received or input power is utilized by the…

Q: A 25 ohm resistor connected in series with a coil of 50 ohm resistance and 150 mH nductance. What is…

Q: A 160 micro-farad capacitor is connected in series with a 10 ohm resistor. Write the equation of the…

Q: 3.17 Let f(t) be a T-periodic signal and let g(t) be the signal given by 8 (t) = ² ft f(u) du. a…

A: It is given that: gt=1a∫t-atfudu 0<a<T

Q: A series circuit consisting of a variable resistor in series with a capacitance of 80 microfarad is…

A: Power consumed by resistor = current2 × resistance . First write the expression for current in the…

Q: A single phase lagging power factor load takes 300 W and 5 A at 120 V. Find the reactance of a pure…

Q: 12. Simply the following expressions to a minimum number of literals. xx + xy' = (xyz) (xy' z) =

Q: 2. If I is equal to 2A, find I.

A: The required current can be calculated by reducing the parallel connected resistors and then apply…

Q: Two current sources deliver current to a common load. The first source delivers a current whose…

Q: A resistor and a capacitor are connected in series across a supply of 250 V. When the supp frequency…

Q: Two alternators A and B delivers 100 and 150 A, respectively to a load. If these currents are out of…

A: Use pythagoras theorem to find current current drawn load.

Q: A 40 micro-farad capacitor is connected in series with a 40 ohm resistor. If the voltage is 220-V,…

A: Series circuit consists of Voltage, V = 220 V Capacitance, C = 40microF Resistor, R = 40 ohm…

Q: A coil connected in series with a resistance are supplied from a 240 volts 60 Hz source draw 1.0…

A: Here, we have given a circuit where, the resistor and the inductor are connected in series. The…

Q: A 240 V, 25 Hz sinusoidal generator is connected to a 20 ohms resistor. Determine the instantaneous…

A: Voltage (V) = 240 V Frequency of the supply (f) = 25 Hz Resistance (R) = 20 Ω

Q: Determine the branch currents and power in each resistor of the given circuit using Kirchhoff's…

Q: A resistor of 6 ohms and an unknown impedance coil in series draws 12 A from a 120 V, 60 Hz line. If…

A: Power consumed by resistor = current2 × resistance . Impedance of the coil= voltage/ current through…

Q: Q3 A translational mechanical system can be simplified in schematic diagram as in (a) Draw the free…

A: The required transfer function can be obtained by writing the equation of motion using Newton's law…

Q: A current of 10 A and a power factor of 0.8 lagging is taken from a single phase 250 volt supply.…

Q: An inductive coil takes a current of 2 A and consumes 160 W when connected to a 240 V AC supply. A…

Q: 3) Considering the Linear Equation Systems, write the systems of linear equations related to…

A: The linear system related to loops in the circuit needs to be obtained and then the equivalent…

Q: A series circuit with 2 amperes flow through a 20 ohm resistor, 50 ohm inductive reactance. What is…

A: Apply KVL in loop to find supply voltage. According to KVL sum of voltage rises and voltage drops…

Q: A series resistance-capacitance (RC) circuit is connected to a 230 Volt, 60 cycle source. If the…

Q: Apply mason Rule (S&P) to block diagnon below. кла то e(s) p Git 623 ST LGH H₂ 6₁ to H3 H₂ ((S) H₁…

A: A system is represented by block diagram. Signal flow graph is graphical representation of system.…

Q: Q4 Calculate the S-parameters of the following two-port network, with respect to 50 2. 592 Note the…

A: The 2 port network,

Q: A 50 micro-farad is connected in series with a coil having 50 ohm resistance and 150 mH inductance.…

A: Here, we have given the information about an electrical circuit, where, the capacitor, resistor and…

Q: ii. What do you understand by carry in addition?

A: Carry is is an extra bit present with the sum of the bit. carry is generated when the added result…

Q: A series RLC circuit is excited by a 100 volts 79.6 Hz source. Resistance R is 100 ohms inductance L…

Q: Q3. b) Suppose you want to transmit the 10-bit message [101101101] by Pulse code Modulation (PCM).…

A: Part (iv) - Delay modulation - In communication, delay modulation is also known as millier's…

Q: A single phase circuit is supplied from a 220 volts 60 Hz source draws 2000 watts of power and 10…

A: Power drawn by single phase circuit = voltage ×current ×power factor. Given power drawn from the…

Q: The amplifier circuit to be used is the one shown in Figure 1. Size the components to obtain a gain…

A: The ac circuit is given as Now the small signal modeling of the amplifier will be

Q: A coil is supplied from a 200 volt and takes a current of 2 amperes at 0.707 power factor agging.…

A: Quality factor =WL/ resistance = inductive reactance/ resistance. From given…

Q: An ideal inductor of 50 mH is connected in series with a 175 microfarad capacitor. The combination…

A: Current is leading when capacitive reactance is more than inductive reactance. From given values…

Q: An impedance coil takes 10 A and absorbs 250 Watts when connected across a 220 V, 60 Hz source. What…

A: This question belongs to circuit theory . It is based on the concept of power consumed across the…

Q: An 8 ohm resistor is connected in series with an inductive coil and the combination is connected…

Concept explainers

Wheatstone Bridge Method

A Wheatstone bridge is a circuit used to measure unknown resistance by measuring the ratios of the two branches of the circuit such that each branch has two resistance and out of four resistance one is unknown. The two branches are joined in between with the help of galvanometer which is used to determine the direction of the current. The main advantage of this circuit is that it can provide the most accurate measurement (different from a simple voltage separator).

Question

Pls. write solution neatly

In a series RC circuit, the voltage across the capacitor and the resistor are 60 and 80 volt
respectively, the total voltage is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A series resistive capacitive circuit contains 2 resistor and 2 capacitors. The resistors are 39 and 56 The capacitors have a capacitive reactance of 80 and 40 What is the total impedance ?
can show steps of question 22
Determine the capacitance for C1 = 10 and C2 =5 connected in series and parallel
Calculate the value of RC in ohms. at VCC=18 V, IB=29 uA, and VC=8V and B=61
The area of a Parallel plate capacitor is 20 in². Give the answer in m² O 12.9 x 10-4 m² O 12.9 x 10-3 m² O 6.452 x 10-4 m² O 12.9x10-³m²
for parallel and Series Circuit: Find the capacitance and charge of V = 12-00 C₁ = 2.50 C2 = 5.00
What is the maximum voltage come across in capacitance
What happens When a capacitor and an inductor having equal reactance's are placed in series RC, RL and RLC circuit
i want the discussion and the waveform for this circuit
In a series RC circuit the voltage across the capacitor and the resistor are 60 volts and 80 volts respectively. The total voltage is
a capacitor and a resistor are connected in parellel to a 120 v 60 hz line the resistor has a resistance of 40 ohms and the capacitor has a capacitance of 132.6 uf what is the total current flow through the circuit. what is the impedence and the power factor and how many degrees out of phase are the current and voltage out phase with eachother.
an rc series circuit is connected to a 120 v 60 hz power source the resistor is 25 ohm and has a voltage drop of 65 volts what is the capacitance of the capacitor