In a series oscillating RLC circuit, R = 15.80, C = 31.2 pF, L = 9.04 mH, and E = Emsinwat with Em = 45.4 V and wa= 2960 rad/s. For time t = 0.430 ms find (a) the rate P, at which energy is being supplied by the generator, (b) the rate Pat which the energy in the capacitor is changing, (c) the rate PL at which the energy in the inductor is changing, and (d) the rate PR at which energy is being dissipated in the resistor. (e) Is the sum of PC. PL. and PR greater than, less than, or equal to Pg? (a) Number (b) Number (c) Number i (d) Number (e) i Save for Later Units Units Units Units Attempts: 0 of 5 used Submit Answer

In a series oscillating RLC circuit, R = 15.80, C = 31.2 pF, L = 9.04 mH, and E = Emsinwat with Em = 45.4 V and wa= 2960 rad/s. For time t = 0.430 ms find (a) the rate P, at which energy is being supplied by the generator, (b) the rate Pat which the energy in the capacitor is changing, (c) the rate PL at which the energy in the inductor is changing, and (d) the rate PR at which energy is being dissipated in the resistor. (e) Is the sum of PC. PL. and PR greater than, less than, or equal to Pg? (a) Number (b) Number (c) Number i (d) Number (e) i Save for Later Units Units Units Units Attempts: 0 of 5 used Submit Answer

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: A Reconfigurable RCL Circuit. A series RCL circuit is composed of a resistor (R = 22002), two…

A: The capacitance of the capacitors is 3.40 nF. The inductance of two inductors is 6.20×10-5 H.

Q: An L-R-C circuit has L = 0.410 H, C = 2.20 × 105 F, and resistance R. (a) What is the angular…

Q: An AC source with AVmax = 155 V and f = 25.0 Hz is connected between points a and d in the figure. a…

Q: An RLC series circuit has a 0.20 k2 resistor, a 800 mH inductor, and a 88.0 nF capacitor at 800 Hz.…

A: Solution:-Given thatRLC series circuit:Resistance (R)=0.2 kΩ=200 ΩInductance (L)=800 mH=0.8…

Q: In a series oscillating RLC circuit, R =20 W, C =5 mF, L =20 mH, and e=emsin wt with em =45.0 V and…

A: Determine the current (I) of the given circuit as follows. I=ξmZ=ξmR2+XL-XC2=ξmR2+ωL-1ωC2=45.0 V20…

Q: A series circuit contains an inductor, a resistor, and a capacitor for which L = h, R = 10 ft, and C…

Q: An ac generator produces emf 8 = Em sin(w₁ t - π/4), where 8m = 31.0 V and wd = 360 rad/s. The…

Q: Calculate the average power output of the source if it is connected across:

Q: A 40.0-0 resistor, a 0.100-H inductor, and a 10.0-µF capacitor are connected in series to a 60.0-Hz…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A series RLC circuit has resistance R = 20.0 Ω, inductive reactance XL = 28.0 Ω, and capacitive…

A: Given: R=20 ΩXL=28 ΩXC=14 Ω The maximum voltage across the resistance is 105 V.

Q: A 0.180 H inductor is connected in series with a 90.0 Ω resistor and an ac source. The voltage…

A: Given data: The inductance is L=0.180 H. The resistance is R=90.0 Ω. The time is t=2.00 ms.

Q: Find the time in an RL circuit in which L= 0.3H and R=30.0 ohm when current drops from 0.2 A to…

Q: Consider an RLC series circuit with R = 600 Ω, L = 3 H, C = 4μF, generator voltage V = 20 v,…

A: The inductive reactance can be obtained as XL=2πfL=2π60Hz3H=1130.97Ω

Q: Find the charge on the capacitor in an LRC-series circuit at t = 0.05 s when L = 0.05 h, R = 3…

Q: The emf of an ac source is given by v(t) = V0 sin ωt, where V0 = 100 V andω = 200π rad/s. Calculate…

A: Given: ω = 200π rad/s

Q: In the figure, an ac generator with emf 8 = 8 sina, where 8 = 24.2 V and wa= 386 rad/s, is connected…

Q: Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. L = 1 h,…

Q: A series RLC circuit driven by a source with an amplitude of 120.0 V and a frequency of 50.0 Hz has…

A: Given That, XL = 2 pi f L = 2 3.14 * 50* 0.762 XL = 239.27 ohm capacitive reactance Xc = 1/( 2 pi…

Q: A single-loop circuit consists of a 7.4 Ω resistor, 11.9 H inductor, and a 3.3 μF capacitor.…

Q: Consider an RLC series circuit with R = 600 Ω, L = 3 H, C = 4μF, generator voltage V = 20 v,…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A series RLC circuit has components with the following values: L = 18.0 mH, C = 114 nF, R = 30.o n,…

Q: An RLC series circuit has a resistor 3.51 kΩ, an inductor 171 mH inductor, and a 33 nF capacitor.…

Q: A series RLC circuit, with the components 1.4 kN, 22 mH and 1.8 µF, is connected to an alternating…

Q: ww R C L ll

Q: A series RLC circuit has resistance R = 35.0 Q and inductance L = 0.515 H. The voltage source…

A: The given values are, R=35.0 ΩL=0.515 Hf=50.0 HzZ=R=35.0 Ω

Q: 14.0-mH inductor is connected to a North American electrical outlet (ΔVrms = 120 V, f = 60.0 Hz).…

Q: A 13.6 H inductor is connected to an AC source whose emf is represented by the equation E = Emax…

Q: = 125 V and f = 35.0 Hz is connected between points a and d in the figure. max An AC source with AV…

Q: The output EMF of a generator is given by V (t) = a sin(wt), where a = 231 V. Find the rms current…

A: Given : Peak voltage (a) = 231 V and resistor (R) = 118 ohm

Q: A LRC series circuit consists of a 1.50 µF capacitor, a 6.00 mH inductor, and a 71.0 N resistor that…

A: The average power delivered to the circuit is given by P = Vrms Irms cos(φ) Where φ = Phase angle

Q: A single-loop circuit consists of a 7.2 Q resistor, 11.9 H inductor, and a 3.3 UF capacitor.…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

In a series oscillating RLC circuit, R = 15.8 Q, C = 31.2 pF, L = 9.04 mH, and E= Emsinwat with Em = 45.4 V and wa= 2960 rad/s. For time t
= 0.430 ms find (a) the rate P, at which energy is being supplied by the generator, (b) the rate Pat which the energy in the capacitor is
changing, (c) the rate PL at which the energy in the inductor is changing, and (d) the rate PR at which energy is being dissipated in the
resistor. (e) Is the sum of PC. PL. and PR greater than, less than, or equal to Pg?
(a) Number
(b) Number
(c) Number i
(d) Number
(e)
i
Save for Later
Units
Units
Units
Units
Attempts: 0 of 5 used
Submit Answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In a series oscillating RLC circuit, R = 16.20, C = 31.6 µF, L = 9.52 mH, and E = Emsinwat with Em = 44.9 V and wd = 3040 rad/s. For time t = 0.443 ms find (a) the rate På at which energy is being supplied by the generator, (b) the rate Pat which the energy in the capacitor is changing, (c) the rate PL at which the energy in the inductor is changing, and (d) the rate PR at which energy is being dissipated in the resistor. (a) Number i 84.47 (b) Number i 31.6 (c) Number (d) Number i -93.2 i 60.5 Units W Units W Units W Units W
Consider a series RLC circuit with R = 12.0 Ω, L = 0.700 H, C = 72 μF, and a maximum voltage of 100 V. (d) What is the impedance at 60.0 Hz? (e) What is the rms current in the circuit at a frequency of 60 Hz? A 48.0 Ω resistor, a 0.900 H inductor, and a 17.0 µF capacitor are connected in series to a 60.0 Hz source. The rms current in the circuit is 3.28 A. Find the (h) phase angle between the current and generator voltage
Find the differential equation corresponding to the following RLC circuit in fig. when L = 0.5 H, R = 3 0, C = 1/12 F and E(t) = 10sin2t V. Et) = E, sin at (a) I" + 31' +I = 20cos2t (b) I" + 61' + 241 = 20cos2t (c) I" + 6I' + 6I = -20cos2t (d) I" + 61' + 241 = 10cos2t (e) I" + 61' + 241 = 10sin2t
In a certain series RLC circuit, Irms = 9.00 A, ΔVrms = 155 V, and the current leads the voltage by 31.0°.
A series RLC circuit has resistance R = 14.0 2, inductive reactance X, = 28.0 N, and capacitive reactance X, = 16.0 Q. If the maximum voltage across the resistor is AV, = 135 V, find the maximum voltage across the inductor and the capacitor. (Due to the nature of this problem, do not use rounded intermediate values in your calculations-including answers submitted in WebAssign.) HINT (a) the maximum voltage across the inductor (in V) V (b) the maximum voltage across the capacitor (in V) V (c) What is the maximum current in the circuit (in A)? A (d) What is the circuit's impedance (in 2)?
Help
An alternating source drives a series RLC circuit with an emf amplitude of 6.25 V, at a phase angle of +32.9°. When the potential difference across the capacitor reaches its maximum positive value of +5.00 V, what is the potential difference across the inductor (sign included)?
Please give a detailed solution Thank-you
An alternating source drives a series RLC circuit with an emf amplitude of 6.05 V, at a phase angle of +30.3°. When the potential difference across the capacitor reaches its maximum positive value of +5.32 V, what is the potential difference across the inductor (sign included)?