In a pump test the suction pressure at the pump inlet is -28.00 kPa below atmospheric pressure. The discharge pressure at a point 960 mm above the inlet is 525 kPa. Hydraulic steel tubing is used for both the suction (inlet) and discharge (outlet) lines with 80 mm OD × 2.8 mm wall. Required If the volume flow rate of water is 88 L/min, calculate the power delivered by the pump to the water in kW, to the nearest 1000th. Discharge pipe Suction pipe Flow Pump |||+

Q: The allowable Net Positive Suction Head (NPSH) for a pump provided by the manufacturer for a flow of…

A:

Q: The mechanical efficiency of the pump is 0.85 and pumping with a rate of 650 gal/min of engine oil…

A:

Q: let of the pump. Use Pipe Flow Expert for your analysis.

A: Given:- temperature=80 degree C rate=475L/min To find:- pressure at inlet of pump

Q: The turbine shown in the figure below develops 106 hp when the flowrate of water is 26 ft³/s. If all…

A: P=106hp Q=26ft3/s To find  h ∆P Q

Q: Q-The allowable net positive suction head (NPSH) for a pump provided by the manufacturer for a flow…

A: To Find-The maximum height of the pump above the suction reservoir.

Q: The water level in a tank is 15 m above the ground. A hose is connected to the bottom of the tank,…

A:

Q: 1.) For the water shooting out of the pipe and nozzle under the condition showed, find the height…

A: Given: A jet is given provided with the nozzle diameter of 100mm. PA=55kPa Diameter at  A, DA=200mm…

Q: 1. A pump station design fills a pressurized water tank by pumping water from a reservoir. The flow…

A: Frictional loss is due to shear stress in the walls of the pipe.

Q: If water is pumped from reservoir 1 to reservoir 2 through a 20 cm pipe with a length L1=70 m, and…

A: The expression for velocity in pipe is given as V=QA Substitute the value in above expression V=0.15…

Q: Include a free body diagram  The water level in a tank is 34 ft above the ground. A hose is…

A:

Q: For the system in the figure, calculate the distancevertical between the surfaces of the two…

A: Step 1:QStep 2: Step 3: Step 4:

Q: 10. A fire pump delivers water through a 300 mm main hydrant to which is connected a cotton…

A: Q = 20 L/s or 0.02 m3/s HL1 = 0.8 mHL2 = 3.1 mHL3 = 2.5m

Q: shows a pump employed for lifting water from a sump. If its required to pump 60 liters/sec of water…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?