In a gas turbine plant  working on air standard Brayton cycle, the air at inlet is at 27°C temperature ,0.1 MPa pressure respectively.The pressure is 6.25 and maximum temperature is 800° C the turbine and compressor efficiencies are each 80%. Find per kg of air; i) The compressor work ii)The turbine work iii) The cycle efficiency iv) The turbine exhaust temperature

Q: an air-standard Otto cycle. It operates with a compression ratio of 8 starting from 20C and 101.3…

A:

Q: 1. (a) Find the optimum pressure ratio for maximum specific work a non- ideal air Gas Turbine cycle.…

A:

Q: Your answer has been saved. See score details after the due date. The expression used to solve for…

A:

Q: Air enters the compressor at 80 kPa, 280 K and 60 m³/s in a Brayton cycle with a regenerator with an…

A: The Brayton cycle is a practical working cycle for a gas turbine power plant. The advantage of the…

Q: For an ideal Rankine cycle, steam first enters the turbine at 5 MPa and 500C then it expands to a…

A: The quality of steam, the heat addition, the heat rejected, the turbine work,  the pump work, the…

Q: P = 10 MPa T= 600 °C =0.2 MPa 2 21 A. For the turbine, for mass flow rate of 3,000 kgħr, caiculate:…

A:

Q: Question 2 a) Show that for air undergoing a steady flow compression process, the specific work of…

A:

Q: he intake air to an ideal Otto cycle has a max volume of 0.004m^3 at 27 degre

A:

Q: in a steam power cycle, steam enters the turbine at 20 bar with the following different conditions…

A:

Q: A certain SSSF turbine (irreversible and adiabatic) operates on air with the following conditions,…

A:

Q: In an air standard Brayton cycle the air enters the compressor at 0.1 MPa, 25 ∘C. The pressure…

A:

Q: Air undergoes Isothermal expansion in a Carnot cycle where the pressure decreases from 2.5 MPa to…

A: Dear student z we are suppose to solve only 3 subparts. Still I have solved 5 sub parts. Please post…

Q: Subject: Refrigeration System  A carnot cycle used to produce work has temperature limits of 25C,…

A: “Since you have posted multiple questions with multiple sub parts,we will provide the solution only…

Q: An ideal gas-turbine cycle has two stages of expansion and two stages of compression. The pressure…

A: given data An ideal gas-turbine cycle has two stages of expansion and two stages of compression.The…

Q: A jet engine consists of a turbine and a nozzle. The turbine receives air at 1200 K and 800 kPa with…

A: Jet engine Jet engine consist of Diffuser, Compressor, Turbine, Nozzle as shown in figure below,…

Q: 1. The compression ratio in an ideal Otto cycle is 10. If the air before compression is at 20 °C and…

A:

Q: Consider an insulated turbine with air entering at 50 deg Celsius and exits at -30 deg Celsius, 100…

A:

Q: Answqer b) only

A:

Q: 2. A Ste am power plant uses a Rankine cycle to produce electrical power. The boiler pressure is 2…

A:

Q: Engine work on the reversible cycles as shown, work output from the engine ?

A:

Q: A two-shaft gas turbine power plant is shown in Figure Q2 (b). All the power developed by the…

A: Calculated the temperature at the exit of high pressure turbine. And thermal efficiency ,back work…

Q: from these states to a pressure of 6.5 bar. Calculate the power required for drivir the compressor…

A: Given data;     P1=1 bar=100 KN/m2t1=170CT1=17+273=300 KV1=15  m3/minP2=6.5 bar=650 KN/m2 as per…

Q: Air enters an ideal gas turbine cycle at 1 bar and 27 C. The maximum temperature in the cycle is 727…

A:

Q: Problem3: At the beginning of the compression process of an air standard Otto cycle, p;-1 bar, T-300…

A: AS PER GUIDELINES I HAVE SOLVE ONLY 3 SUBPART OF YOUR QUESTION

Q: Thermodynamics: - Clear writing please!!! Thank you - Sketch and label all numbers on the turbine. -…

A:

Q: Enthalpy data is given for a regenerative Brayton cycle with intercooling and reheating. The cycle…

A: We are suppose to solve only 3 subparts. Please post other parts as a separate question.

Q: 1.There are compressed 100 m/min of air from p=100kpaa and t=24°Cto p-534 kpaa. determine a) Wa, Waf…

A:

Q: An air-standard dual cycle has a compression ratio of 9.1 and displacement of Va = 2.2 L. At the…

A:

Q: A regenerative-reheat gas turbine with intercooling between turbine stages is shown in figure. Air…

A:

Q: A engine works on Carnot cycle between 727 °C and 227 °C. The efficiency of the engine is B. 75.4%…

A: Given, Source temperature = T1 = 727 oC = 1000 K Sink temperature = T2 = 227 oC = 500 K

Q: An air-standard dual cycle has a compression ratio of 9.1 and displacement of Va = 2.2 L. At the…

A:

Q: At the beginning of the compression process of an air standard Otto cycle, p1= 1 bar, T1= 300 K. The…

A: Given, P1=1barT1=300KT3=2250KCompression ratio,r=9.8Engine displacement, Vd=2.7L=2.7×10-3m3/s T-S…

Q: Air is supplied in an 8 kW continuous flow compressor at a pressure of 100 kPa and a temperature of…

A: P1=100 kPaT1=17°C=290 KP2=600 kPaT2=167°C=440 Km˙=2.1kg/min=0.035 kg/s

Q: cess of an air standard Otto cycle, p1 = 1 bar, T1 = 300 K. The maximum temperature in the cycle is…

A:

Q: For an ideal Rankine cycle, steam first enters the turbine at 5 MPa and 500C then it expands to a…

A: The turbine pressure is .The temperature at the turbine entry is .The condenser pressure is .

Q: only need help with parts d to i.   At the beginning of the compression process of an air standard…

A:

Q: Butane enters an adiabatic compressor at 20psia and 250F with a volume Clow rate of 12ft3/s and…

A:

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.