In a diesel cycle, the air is compressed to one-tenth of its original volume. If the initial temperature of the air is 27oC, what is the final temperature? Group of answer choices 440 oC 480 oC 460 oC 420 oC

Q: 962 J of work were done on three moles of a diatomic gas that absorbs 2438 J in the process. If the…

A: Work done on a diatomic gas, W=962 JHeat absorb in the process Q=2438 JInitial temperature of the…

Q: A cylinder has a piston at one end that can be moved in or out to change the volume of gas inside.…

A:

Q: a fighter jet is flying at 268m/s, and executes a 9-gee horizontal turn. What is the radius of the…

A: Given: v=268 m/s(velocity of the jet) g=9.81 m/s^2 (acceleration due to gravity)

Q: 0.5 kg of superheated steam (2bar and 200°C) is compressed isothermally until it becomes saturated…

A: The enthalpy change in an isothermal process is zero.  Hence, ∆h=0

Q: In the shown Figure, the net work done by the gas during the close cycle is equal to: p (P.) 6x10…

A:

Q: 16. DETAILS SERPSE9 20.P.041.WI. An ideal gas initially at P, V, and T, is taken through a cycle as…

A: Ideal gas law is, with N representing number of moles, PV=NRT       (1)   Work done by the gas is…

Q: After an isobaric process, the enthalpy of 28g of CO gas, increases by 2700 J. The initial…

A:

Q: Molar specific heat of monatomic gas at constant pressure is (a) 5/2 R (b) 3/2 R (c) 7/2 R (d). R

A:

Q: During the polytopic process of an ideal gas, the state changes from 138 kPa and 5oC to 827 kPa and…

A: Given: The intial pressure is 138 kPa. The initial temperature is 5oC. The final temperature is…

Q: A ceramic mug has a mass of 200 g. It is initially at room temperature, 20ºC. It is filled with 100…

A:

Q: 2.7 kg of an ideal gas undergoes a polytropic process from an initial state at 1.57 bar, 0.80 m3,…

A:

Q: A monatomic ideal gas in a rigid container is heated from 210 K to 328 K by adding 9080 J of heat.…

A:

Q: 1. In a piston cylinder system, the gas an initial pressure of 100 kPa and expands from 1.5 m³ to…

A:

Q: A 2.9 kg lump of aluminum is heated to 96°C and then dropped into 10.0 kg of water at 5.2°C.…

A: Given: The mass of the aluminium lump ml = 2.9 kg. The mass of the water mw = 10 kg. The initial…

Q: A container holds 8 g of neon at a pressure of 5.0 atm and a temperature of 15 degrees Celsius. How…

A: Write the expression for the number of moles and substitute the corresponding values.

Q: P2 657°C Isothermal 2.0 37°C atm V(L) V3 The figure (not to scale) shows a pV diagram for 5.1 g of…

A:

Q: A 2.6 kg lump of aluminum is heated to 92°C and then dropped into 9.0 kg of water at 5.0°C. Assuming…

A:

Q: BMR Basal Metabolic Rate is the rate of heat energy generation when a person is at rest. Some diet…

A:

Q: Consider a 22.4 g of N2 gas that follows the given PV diagram. [Answer in 3 significant figures] C₁…

A: To solve the question and complete the chart for the given PV diagram of ( N_2 ) gas, we'll use the…

Q: V. Th To V Room temperature T 293 K Vp The temperature changes from Th to To during process 3. The…

A: work done in thermodynamic process W = ∫ P dV

Q: p/ 10° Pa 7.2 2.0+- Y V/m3 3.2 1.5 FIGURE 1 A monatomic gas expands adiabatically from the state X…

A: Given: The intial pressure is 7.2x105 Pa. The final pressure is 2x105 Pa. The initial volume is 1.5…

Q: 0.578 mol sample of Kr gas is confined in a 14.7 liter container at 36.7 °C. If the temperature of…

A: If the temperature of the gas sample is raised to 56.9 C holding the volume constant, the average…

Q: A 1.8 kg iron horseshoe initially at 91 oC is dropped into a bucket containing 15 kg of water at 20…

A: Solution

Q: 3.00 moles of an ideal gas that occupies a volume of 20.0 L at a temperature of 20.00C undergoes an…

A: Given data:  An idel gas undergoes an isothermal process  Number of moles (n) = 3.00 Initial volume…

Q: Thermodynamic problem. 1.6kg of brass with C = 390 J/g°K with an initial temperature of 75°C is…

A:

Q: the gas. During the process BA, 43.8 J of heat was removed from the gas. Determine WACBA & QCB.…

A: We are given a non ideal gas.  We are given the closed cycle. The system comes back to its original…

Q: An ideal gas of 79.767moles is taken through the following cycle: 1. Expansion at constant pressure…

A: Given: P1=1.353 atm=137092.73 Pa1 atm=101325 paV1=1.37 m3P2=0.131 atm=13273.575 PaV2=2.69 m3n=79.767…

Q: 11. Ahelium-filled toy balloon has a gauge pressure of o.200 atm and a volume of 10.0 L. How much…

A: Given : Pg = 0.200 atm = 0.200 × 1.013 × 105 = 2.026 × 104 Pa V = 10 L = 0.01 m3

Q: For isothermal reversible expansion of an ideal gas, which of the following quantities: ΔU, ΔH, ΔS,…

A:

Q: A process at constant volume pressure takes n mole monatomic from an initial temperature T to a…

A:

Q: 10. If the temperature of a monoatomic ideal gas is raised from 93 °F to 128 °F, by how much will…

A:

Q: U04

A: We have-Temperature, T= 200°C=473 KWe know that-Internal Energy, Einternal=∑iKi¯+Ui¯where, Ki¯ is…

Q: Question 17 -3 The diagram below depicts an ideal monatomic gas which is compressed isobarically at…

A:

Q: How hot must the air in a balloon be heated if initially it has a volume of 810. L at 20°C and the…

A:

Q: 3. 0.04 moles of a monatomic gas at 101000 pascals and 300 kelvins occupies 0.001 cubic meters. The…

A:

Q: A diatomic gas of N particles is subjected to a sufficiently high temperature such that the gas…

A: here  the total degree of freedom due to translational and rotational  d=3

Q: 1. In a quasi-static isobaric expansion, 475 J of work are done by the gas. If the gas pressure is…

A:

Q: One mole each of a diatomic gas and a monoatomic gas are brought to the same, very high temperature.…

A: Given,

Q: ONe mole of an ideal gas first undergoes an isothermal expansion at a tempreture Ti = 500 K to 2…

A: Given, One mole of an ideal gas undergoes isothermal expansion at the temperature Ti=500K Then it…

Q: 10. If the temperature of a monoatomic ideal gas is raised from 90 °F to 138 °F, by how much will…

A:

Q: Q.16 A gas is taken through the cycle 4→ B →C → A , as shown. What is the net work done by the gas ?…

A: