Answered: (iii) For quarter-wave film thickness,… | bartleby

Related questions

Question

(iii) For quarter-wave film thickness, show that for normal incidence,
2
nons
R =
nons + n

Expert Solution

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A fine metal foil separates one end of two pieces ofoptically flat glass, as in Fig. 24–33. When light of wavelength 670 nm is incident normally, 24 dark bands areobserved (with one at each end). How thick is the foil?
answer for a i) ii)
(c) A double slit experiment is performed with bluish green light of wavelength 512nm. The slits are 1.2mm apart and the screen is 5.4 m from the slits. (1) Calculate the angular position (0) of the third-order bright fringe in degrees. (ii) Find the width of the bright fringes as seen on the screen.
de, [rad'um] is needed to reflect beam on 2.8 degree from metasurface, which is printed on a dielectric substrate and placed in the air, What value of the phase shift derivative where the incideat angle of radiation is zero and wavelength is 1.55 um. ,-15
4) In a double -slit Separated by a ill uminated by light of experiment, seA the slit are The slit are distana of 2.sum. wave length 500 hm. Calculate the angu pos ition of the se cond - order I tor m:2 lar bright fringe in radians
(a) How far from some grains of red sand must you be so that you are just at the limit of resolving the grains if your pupil diameter is 3mm, the grains are spherical with radius 50μm, and the light from the gains has wavelength 650nm? (b) If the grains were blue and the light from them had wavelength 400nm instead, would the answer to (a) be larger or smaller? (c) Now let's say you are a superhero and you had x-ray vision, so you could see light that had a wavelength of 0.1nm instead. Now how far could you be from the gains of sand to just be at the limit to distinguish one grain of sand from another? (with the same pupil diameter). (assume you're on the beach and there's plenty of light from many frequencies bouncing off the sand, and when you turn on your x-ray vision you aren't bothered by all the other frequencies around).
(II) Red laser light from a He-Ne laser (^ = 632.8 nm) creates a second-order fringe at 53.2° after passing through the grating. What is the wavelength A of light that creates a first-order fringe at 20.6°?
(II) In a double-slit experiment it is found that blue light ofwavelength 480 nm gives a second-order maximum at acertain location on the screen. What wavelength of visiblelight would have a minimum at the same location?
(II) (a) For a given wavelength A, what is the minimum slit width for which there will be no diffraction minima? (b) What is the minimum slit width so that no visible light exhibits a diffraction minimum?